A collection of personal protective equipment (PPE), suitable for use in case of accident in nuclear facilities or radiological emergencies, was gathered at the National Institute for Nuclear, Chemical and Biological Protection, Czech Republic. The shielding characteristics of the various PPE materials were measured via narrow geometry spectral attenuation measurements with point radionuclide sources covering a broad range of photon energies. Photon relative penetration and attenuation for relevant energies of the spectra were the principal experimentally determined quantities for tested PPE. Monte Carlo simulations in the MCNPX™ code were carried out to determine photon attenuation for respective energies in the tested PPE, and the results were compared to those determined experimentally. Energy depositions in a unit volume of an ORNL phantom were simulated in a radioactive aerosols atmospheric environment to determine effective doses both for the whole body and in various organs in the human torso during exposure to different dispersed radioactive aerosols while wearing one of the PPE protecting against X- and gamma-ray. This work aimed to determine the effective dose and its decrease for individual PPE protecting against X- and gamma-ray.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC6885783PMC
http://dx.doi.org/10.1155/2019/1641895DOI Listing

Publication Analysis

Top Keywords

monte carlo
8
tested ppe
8
radioactive aerosols
8
determine effective
8
ppe protecting
8
protecting gamma-ray
8
ppe
6
measuring monte
4
carlo modelling
4
modelling x-ray
4

Similar Publications

Investigating time-independent and time-dependent diffusion phenomena using steady-state diffusion MRI.

Sci Rep

January 2025

Wellcome Centre for Integrative Neuroimaging, FMRIB, Nuffield Department of Clinical Neurosciences, University of Oxford, Oxford, UK.

Diffusion MRI is a leading method to non-invasively characterise brain tissue microstructure across multiple domains and scales. Diffusion-weighted steady-state free precession (DW-SSFP) is an established imaging sequence for post-mortem MRI, addressing the challenging imaging environment of fixed tissue with short T and low diffusivities. However, a current limitation of DW-SSFP is signal interpretation: it is not clear what diffusion 'regime' the sequence probes and therefore its potential to characterise tissue microstructure.

View Article and Find Full Text PDF

Formaldehyde is considered as a significant contaminant. This study aimed to perform comprehensive research with systematic review, health risk estimation, meta-analysis, and Monte Carlo simulation to evaluate exposure to formaldehyde at different seasons of the year in various indoor environments. A systematic literature review was initially performed.

View Article and Find Full Text PDF

Two-dimensional Monte Carlo simulation coupled with multilinear regression modeling of source-specific health risks from groundwater.

J Hazard Mater

January 2025

University of Belgrade, Faculty of Technology and Metallurgy, Karnegijeva 4, Belgrade 11120, Serbia. Electronic address:

Effective protection of groundwater requires an accurate health risk assessment of contaminants; however, the diversity of pollution sources, variability, and uncertainties in exposure parameters present significant challenges in this assessment. In this study, groundwater risk estimates associated with NO, and F, along with fourteen heavy metal(loid)s (V, Cr, Mn, Fe, Ni, Cu, As, Co, Cd, Se, Pb, Hg, Zn, and Al) in an agricultural area were optimized by implementing positive matrix factorization (PMF), multilinear regression, and two-dimensional Monte Carlo simulations to characterize source-specific health risks. Groundwater pollution was analyzed considering regional variations, including differences in elevation, land use and land cover, and soil types.

View Article and Find Full Text PDF

Traditional ecological and human health risk assessment often relies on deterministic frameworks that preclude the presence of variability or uncertainty among input parameters characterizing exposure, effects, and risk. To promote increased realism and generate more robust risk management decisions, probabilistic risk assessment (PRA) has been introduced as a foundational grouping of techniques that seeks to broadly characterize variability among its components. While multiple methods exist (e.

View Article and Find Full Text PDF

Food waste offers a potential source for bioethanol production, but productivity depends on the chemical composition of the raw materials and the processes involved. However, assessment of the environmental sustainability of these processes is often absent and can be carried out using the Life Cycle Assessment (LCA) methodology. This study aimed to perform an LCA on bioethanol production from mixtures of different wastes, including tubers, fruits, and processed foods, focusing on the gate-to-gate phase.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!