X-ray photoelectron spectroscopy (o-XPS) has been used to record the binding energy shifts in the C 1s peak of a pristine poly(ethylene glycol) (PEG) liquid drop in an electrowetting on dielectric (EWOD) geometry and after exposing it to several high-voltage breakdown processes. This was achieved by recording XPS data while the samples were subjected to 10 V dc and ac (square-wave modulation) actuations to extract electrical information related to the liquid and its interface with the dielectric. Through analysis of the XPS data under ac actuation, a critical frequency of 170 Hz is extracted for the pristine PEG, which is translated to a resistance value of 14 MΩ for the liquid and a capacitance value of 60 pF for the dielectric, by the help of simulations using an equivalent circuit model and also by XPS analyses of a mimicking device under similar conditions. The same measurements yield an increased value of 23 MΩ for the resistance of the liquid after the breakdown by assuming that the capacitance of the dielectric stays constant. In addition, an asymmetry in polarity dependence is observed with respect to both the onset of the breakdown voltage and also the leakage behavior of the deteriorated (PEG + dielectric) system such that deviations are more pronounced at positive voltages. Both dc and ac behaviors of the postbreakdown system can also be simulated, but only by introducing an additional element, a diode or a polarity- and magnitude-dependent voltage source (VCVS), which might be attributed to negative charge accumulation at the interface. Measurements for a liquid mixture of PEG with 8% ionic liquid yields an almost 2 orders of magnitude smaller resistance for the drop as a result of the enhanced conductivity by the ions. Coupled with modeling, XPS measurements under dc and ac modulations enable probing unique electrochemical properties of liquid/solid interfaces.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1021/acs.langmuir.9b03134 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Photocatalytic Oxidative Coupling of Methane to Ethane Using CO2 as a Soft Oxidant Over the Au/TiO2-Vo Nanosheets.
Angew Chem Int Ed Engl
December 2024
University of Science and Technology of China, Hefei National Research Center for Physical Sciences at Microscale, jinzhai road, hefei, CHINA.
Herein, we first report a photocatalytic OCM using CO2 as a soft oxidant for C2H6 production under mild conditions, where an efficient photocatalyst with unique interface sites is constructed to facilitate CO2 adsorption and activation, while concurrently boosting CH4 dissociation. As a prototype, the Au quantum dots anchored on oxygen-deficient TiO2 nanosheets are fabricated, where the Au-Vo-Ti interface sites for CO2 adsorption and activation are collectively disclosed by in situ Kelvin probe force microscopy, quasi in situ X-ray photoelectron spectroscopy and theoretical calculations. Compared with single metal site, the Au-Vo-Ti interface sites exhibit the lower CO2 adsorption energy and decrease the energy barrier of the *CO2 hydrogenation step from 1.
View Article and Find Full Text PDFDirect Observation of Hybridization Between Co 3d and S 2p Electronic Orbits: Moderating Sulfur Covalency to Pre-Activate Sulfur-Redox in Lithium-Sulfur Batteries.
Adv Sci (Weinh)
December 2024
Key Laboratory for Photonic and Electronic Bandgap Materials, Ministry of Education, School of Physics and Electronic Engineering, Harbin Normal University, Harbin, Heilongjiang, 150025, China.
Lithium-sulfur batteries (LSBs) offer high energy density and environmental benefits hampered by the shuttle effect related to sluggish redox reactions of long-chain lithium polysulfides (LiPSs). However, the fashion modification of the d-band center in separators is still ineffective, wherein the mechanism understanding always relies on theoretical calculations. This study visibly probed the evolution of the Co 3d-band center during charge and discharge using advanced inverse photoemission spectroscopy/ultraviolet photoemission spectroscopy (IPES/UPS), which offers reliable evidence and are consistent well with theoretical calculations.
View Article and Find Full Text PDFNickel removal from synthetic wastewater by novel zeolite-doped magnesium- iron- and zinc-oxide nanocomposites by hydrothermal-calcination technique.
Sci Rep
December 2024
Qatar Environment and Energy Research Institute (QEERI), Hamad Bin Khalifa University (HBKU), Qatar Foundation, Doha, 34110, Qatar.
This study aims to modify raw zeolite with metal oxide nanocomposites to remove nickel (Ni) ions from synthetic wastewater. Novel zeolite-doped magnesium oxide (MgO), iron oxide (FeO), and zinc oxide (ZnO) nanocomposites were synthesized by hydrothermal-calcination methods. The novel zeolite-doped metal oxide nanocomposites were used as adsorbents to remove Ni (II) ions from synthetic wastewater.
View Article and Find Full Text PDFRobustic and hybrid cobalt doped BaFeO hexaferrites for the photocatalytic degradation of Congo Red for wastewater treatment.
Sci Rep
December 2024
School of Physics and Materials Science, Shoolini University, Solan, H.P., India.
The industrial sector faces a significant challenge in finding the highly effective and efficient treatments for harmful dye-based color effluents. In this study, pure and cobalt doped barium hexaferrite of chemical formula, BaCoFeO (x = 0-0.06) are made via sol-gel auto-combustion (SC) methodology.
View Article and Find Full Text PDFInvestigations on the Origin of Topotactic Phase Transition of LaCoO Thin Films with In Situ XRD and Ambient Pressure Hard X-ray Photoelectron Spectroscopy.
ACS Appl Mater Interfaces
December 2024
Department of Materials Science and Engineering, Chosun University, Gwangju 61452, Korea.
With the applications of in situ X-ray diffraction (XRD), electrical - measurement, and ambient pressure hard X-ray photoelectron spectroscopy (AP-HAXPES), the characteristics of the topotactic phase transition of LaCoO (LCO) thin films are examined. XRD measurements show clear evidence of structural phase transition (SPT) of the LCO thin films from the perovskite (PV) LaCoO to the brownmillerite (BM) LaCoO phases through the intermediate LaCoO phase at a temperature of 350 °C under high-vacuum conditions, ∼10 mbar. The reverse SPT from BM to PV phases is also found under ambient pressure (>100 mbar) of air near 100 °C.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!