Nanoparticles of ZnS doped with Cu (ZnS:Cu) were prepared at room temperature by wet chemical method without any capping agent using two dopant precursor solutions-aqueous: (i) Copper acetate [ZnS:CA] and (ii) Copper nitrate [ZnS:CN] solutions. The characterization of the samples was carried out for the structural, surface morphological and optical properties. XRD analysis results revealed the formation of cubic structure ZnS:Cu particles with an average size of 2.5 nm. From diffuse reflectance spectral (DRS) studies the band gap was found to be higher than bulk due to quantum confinement effect. In Photoluminescence (PL) spectra a sulphur vacancy related blue emission around 432 nm and a green emission from the recombination between the shallow donor level and the level of Cu were observed. The ZnS:CN nanoparticles showed enhanced luminescence property compared with that of ZnS:CA nanoparticles.

Download full-text PDF

Source
http://dx.doi.org/10.1166/jnn.2020.17481DOI Listing

Publication Analysis

Top Keywords

dopant precursor
8
optical properties
8
precursor solutions
4
solutions structural
4
structural optical
4
properties znscu
4
znscu nanophosphors
4
nanophosphors nanoparticles
4
nanoparticles zns
4
zns doped
4

Similar Publications

Atomically dispersed rare earth dysprosium-nitrogen-carbon for boosting oxygen reduction reaction.

J Colloid Interface Sci

January 2025

Collaborative Innovation Center of Sustainable Energy Materials, School of Physical Science and Technology, Guangxi University, Guangxi Key Laboratory of Electrochemical Energy Materials, State Key Laboratory of Featured Metal Materials and Life-cycle Safety for Composite Structures, Nanning 530004, China. Electronic address:

Transition metal-nitrogen-carbon (MNC) based on 3d metal atoms as promising non-precious metal catalysts have been extensively exploited for oxygen reduction reaction (ORR), but MNC with 4f rare earth metals have been largely ignored, most likely due to their large atomic radii that are difficult to coordinate with N dopants using conventional precursors. Herein, atomically dispersed dysprosium-nitrogen-carbon (DyNC) nanosheets were developed via the pyrolysis of anitrogen-containing chelate compound of 2, 4, 6-Tri (2-pyridyl) 1, 3, 5-triazine (TPTZ) ligand with Dy under the assistance of molten NaCl. The as-synthesized DyNC features specific moieties of single Dy atom coordinated by N and O as active sites for ORR, displaying excellent performance.

View Article and Find Full Text PDF

TiO:Eu nanoparticles with varying europium concentrations were successfully synthesized via a one-pot sol-gel approach using a molecular heterometallic single-source precursor (SSP) Eu-Ti. For comparison, nanomaterials with similar europium levels were also produced by impregnating europium salts onto the same TiO substrate. All the nanomaterials were thoroughly characterized using Eu elemental analysis, powder X-ray diffraction (XRD), scanning (SEM), transmission (TEM), scanning transmission electron microscopy (STEM), Brunauer-Emmett-Teller (BET) analysis, thermogravimetric analysis (TGA), X-ray photoelectron spectroscopy (XPS), Raman spectroscopy, and photoluminescence (PL).

View Article and Find Full Text PDF

Enhanced Performance of Polymer Photodetectors Using a Metal-Doped Zinc Oxide Interfacial Layer.

ACS Appl Mater Interfaces

January 2025

Department of Semiconductor Engineering, Gyeongsang National University, Jinjudae-ro 501beon-gil, Jinju-si, Gyeongsangnam-do, Republic of Korea.

Organic photodetectors (OPDs) are cheaper and more flexible than conventional photodetectors based on inorganic precursors, but their wider commercial application is limited by their low electron extraction efficiency under reverse bias conditions (when operating under photoconductive mode). Zinc oxide (ZnO) has shown promise as an electron transport layer for OPDs owing to its wide band gap, but its electron extraction efficiency has been limited by issues such as photoinstability and the formation of surface detects. This study investigated the effects of doping ZnO nanoparticles with indium gallium (i.

View Article and Find Full Text PDF
Article Synopsis
  • The study explores the connection between d-wave superconductivity and stripe phases in high-temperature cuprate superconductors, revealing how anisotropic couplings can enhance critical temperatures.
  • Recent advancements in quantum simulators using ultracold atoms allow for the experimentation and observation of these phenomena in real-time at a detailed level.
  • The research presents evidence of stripe formation in a cold-atom Fermi-Hubbard simulator, showing attractive correlations between dopants and suggesting the presence of a precursor to the stripe phase, which involves complex charge and spin ordering.
View Article and Find Full Text PDF

Atomic layer deposition of Pt nanoparticles grown onto 3D B-doped graphene as an efficient ultra-low Pt loading catalyst layer for PEMFC.

J Colloid Interface Sci

December 2024

Collaborative Innovation Center of Sustainable Energy Materials, School of Physical Science and Technology, Guangxi University; Guangxi Key Laboratory of Electrochemical Energy Materials, State Key Laboratory of Featured Metal Materials and Life-cycle Safety for Composite Structures, Nanning 530004, China. Electronic address:

Article Synopsis
  • Researchers developed a new catalyst layer using 3D porous B-doped graphene integrated with ultra-low platinum (Pt) for proton exchange membrane fuel cells (PEMFC), aiming to improve activity and durability.
  • The Pt/3D-PBG configuration achieved a maximum power density of 0.90 W/cm² while meeting the Department of Energy's 2025 targets, which is a significant breakthrough.
  • The integration of boron (B) dopants enhances both the deposition of Pt and its electronic interaction, resulting in better performance and stability of the fuel cell at lower amounts of platinum.
View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!