Effect of Bracket Slot and Archwire Dimension on Posterior Tooth Movement in Sliding Mechanics: A Three-dimensional Finite Element Analysis.

Introduction Space closure by molar protraction has always been a challenge in orthodontic treatment due to larger root surface area which requires additional anchorage. Ideally, there should be little or no tipping. However, the protraction forces, being occlusal and buccal to the centre of resistance (CR) of the tooth, cause tipping and rotations. Aim The aim of the study was to assess the effect of bracket slot and archwire dimensions on posterior tooth movement during space closure in sliding mechanics and evaluate the length of power arm to bring about translatory movement of teeth using three-dimensional finite element analysis. Materials and methods A model of the maxillary teeth was created and converted to a finite element format through a meshing software, Hypermesh. Two three-dimensional models, each with a combination of 0.017"× 0.022" archwire in 0.018" slot (model 1) and 0.019"×0.025" archwire in 0.022" slot (model 2), were generated. Power arms of different lengths were attached to the first molar. Miniscrew was inserted between the canine and first premolar. Results In model one, the power arm of 10-mm height provided controlled tooth movement than the one with 6 mm height, and in model two, power arms of both 6-mm and 10-mm height produced controlled tooth movement. Conclusions As the force was raised apically from the slot, more translation was observed. Power arm of 6-mm height can be used due to anatomic limitation of the vestibule.