More attention was paid to the attachment between microplastics and environmental pollutants. The adsorption performance of Polyethylene (PE) beads (a typical type of microplastics) and Cr(VI) ions with the existence of sodium dodecyl benzene sulfonate (SDBS) was investigated in this paper. The adsorption experiments of Cr(VI) ions by PE microplastics were conducted at different conditions, i.e. PE doses, pH and SDBS concentrations, respectively. The adsorption capability of Cr(VI) ions was increased from 0.39 to 1.36 mg⋅g when the dosage of PE microplastics was increased from 2 to 14 g ⋅L at pH of 5 with addition of SDBS, compared with increasing adsorption capability from 0.03 to 0.32 mg⋅g without addition of SDBS. The pH would influence the adsorption capability with and without the addition of SDBS. When the pH was less than 6, the adsorption capability of Cr(VI) would be promoted by the addition of SDBS; however, there was a contrast tendency when the pH was more than 6, which was attributed to that SDBS would compete with CrO for occupying the adsorption sites of PE microplastic. The SDBS concentration would affect the adsorption performance of Cr(VI) ions onto PE microplastics. The peak of the adsorption capacity was at SDBS concentration between 1 and 1.5 mM. This research would provide a basis for investigating the influence of SDBS on adsorption performance of heavy metal by PE microplastics to simulate the surface attachment model of those three kinds of pollutants.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1016/j.envpol.2019.113440 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Removal of Cr(VI) from aqueous solutions by activated carbon and its composite with PWO: A spectroscopic study to reveal adsorption mechanism.
Heliyon
January 2025
Nuclear Chemistry Division, Department of Chemistry, Atomic Energy Commission, P. O. Box: 9061, Damascus, Syrian Arab Republic.
Molecular scale information is needed to understand ions coordination to mineral surfaces and consequently to accelerate the design of improved adsorbents. The present work reports on the use of two-dimensional correlation Fourier Transform infra-red spectroscopy (2D-COS-FTIR) and hetero 2D-COS-FTIR- X-ray diffraction (XRD) to probe the mechanism of Cr(VI) removal from aqueous solutions by activated carbon (AC) and its composite with PWO (AC-composite). The adsorption data at an initial Cr(VI) concentration of 320 mg L (320 ppm) revealed maximum adsorption capacities of 65 mg g for AC and 73 mg g for AC-composite, corresponding to removal percentages of 83 % and 94 %, respectively.
View Article and Find Full Text PDFThis work aimed at addressing the problem of hexavalent chromium pollution in the water environment, designing and preparing the Cu/CuO/NH-MIL-88B (Fe) heterojunction material with NH-MIL-88B (Fe) as the carrier, Cu/CuO was loaded on NH-MIL-88B (Fe) by light-assisted reduction. The loading of CuO effectively improves the visible light absorption capacity of the composite material. The SPR effect of Cu improves the separation and transfer of photogenerated carriers in the composite material.
View Article and Find Full Text PDFCellulose/covalent organic framework aerogel for efficient removal of Cr(VI): Performance and mechanism study.
Int J Biol Macromol
January 2025
Yunnan Provincial Key Laboratory of Wood Adhesives and Glued Products, Southwest Forestry University, Kunming 650224, Yunnan, China. Electronic address:
Cellulose composites have exceptional qualities, particularly in removing heavy metal ions. Nevertheless, these materials' poor mechanical qualities and the restricted exposure of surface-active sites reduce the effectiveness of their removal. The removal efficiency of adsorbent materials largely depends on their macroscopic structural characteristics.
View Article and Find Full Text PDFNano-Fibrillated Bacterial Cellulose Nanofiber Surface Modification with EDTA for the Effective Removal of Heavy Metal Ions in Aqueous Solutions.
Materials (Basel)
January 2025
Division of Applied Chemistry and Biochemistry, National Institute of Technology, Tomakomai College, Nishikioka 443, Tomakomai 059-1275, Hokkaido, Japan.
Nano-fibrillated bacterial cellulose (NFBC) has very long fibers (>17 μm) with diameters of approximately 20 nm. Hence, they have a very high aspect ratio and surface area. The high specific surface area of NFBC can potentially be utilized as an adsorbent.
View Article and Find Full Text PDFPreparation of ZnAl layered double hydroxides supported by silica for the treatment of Cr(VI) and Cu(II) in aqueous solution.
Sci Rep
January 2025
School of Chemistry and Chemical Engineering, Heze University, Heze, 274015, People's Republic of China.
A novel adsorbent ZnAl-LDHs/SiO (ZA/SiO) was prepared by blending urea mixture of ZnSO and Al(SO) while using SiO as a support form. The adsorption properties of ZA/SiO for the removal of toxic metal ions (Cu(II) and Cr(VI)) from water were evaluated. By batch experiment method to investigate the ZA/SiO adsorption of Cu(II) and Cr(VI) solution treatment effect.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!