Message: file_get_contents(https://...@gmail.com&api_key=61f08fa0b96a73de8c900d749fcb997acc09): Failed to open stream: HTTP request failed! HTTP/1.1 429 Too Many Requests
Background: Subpectoral biceps tenodesis can be performed with cortical fixation using different repair techniques. The goal of this technique is to obtain a strong and stable reduction of biceps tendon in an anatomic position.
Purpose/hypothesis: The purpose of this study was to compare (1) displacement during cyclic loading, (2) ultimate load, (3) construct stiffness, and (4) failure mode of the biceps tenodesis fixation methods using onlay techniques with an all-suture anchor versus an intramedullary unicortical button. It was hypothesized that fixation with all-suture anchors using a Krackow stitch would exhibit biomechanical characteristics similar to those exhibited by fixation with unicortical buttons.
Study Design: Controlled laboratory study.
Methods: Ten pairs of fresh-frozen cadaveric shoulders (N = 20) were dissected to the humerus, leaving the biceps tendon-muscle unit intact for testing. A standardized subpectoral biceps cortical (onlay) tenodesis was performed using either an all-suture anchor or a unicortical button. The biceps tendon was initially cycled from 5 to 70 N at a frequency of 1.5 Hz. The force on the tendon was then returned to 5 N, and the tendon was pulled until ultimate failure of the construct. Displacement during cyclic loading, ultimate failure load, stiffness, and failure modes were assessed.
Results: Cyclic loading resulted in a mean displacement of 12.5 ± 2.5 mm for all-suture anchor fixation and 29.2 ± 9.4 mm for unicortical button fixation ( = .005). One all-suture anchor fixation and 2 unicortical button fixations failed during cyclic loading. The mean ultimate failure load was 170.4 ± 68.8 N for the all-suture anchor group and 125.4 ± 44.6 N for the unicortical button group ( = .074), with stiffness 59.3 ± 11.6 N/mm and 48.6 ± 6.8 N/mm ( = .091), respectively. For the unicortical button, failure occurred by suture tearing through tendon in 100% of the specimens. For the all-suture anchor, failure occurred by suture tearing through tendon in 56% and knot failure in 44% of the specimens.
Conclusion: The all-suture anchor fixation using a Krackow stitch for subpectoral biceps tenodesis provided ultimate load and stiffness similar to unicortical button fixation using a nonlocking whipstitch. The all-suture anchor fixation technique was shown to be superior in terms of displacement during cyclic loading when compared with the unicortical button fixation technique. However, the results of this study help to show that the fixation method used on the humeral side is less implicative of the overall construct strength than stitch location and technique, as the biceps tendon tissue and stitch configuration seem to be the limiting factor in subpectoral onlay tenodesis techniques.
Clinical Relevance: All-suture anchors have a smaller diameter than traditional suture anchors, can be inserted through curved guides, and preserve humeral bone stock without compromising postoperative imaging. This study supports use of the all-suture anchor fixation technique for subpectoral biceps tenodesis, with high biomechanical fixation strength and low displacement, as an alternative to the subpectoral onlay biceps tenodesis technique.
