Copolymerization of isoprene (IP) with glycidyl methacrylate (GMA) was performed under RAFT (reversible addition-fragmentation chain-transfer) polymerization conditions in a platform for high-output experimentation. Covering the range between 1 and 0.2 molar fraction of IP in the feed, four sets of reactions were carried out at 10, 15, 20, and 30 h at 115 °C. The kinetic data obtained were used to estimate the reactivity ratios using a nonlinear least-squares approach (NLLS). Reactivity ratios = 0.61 = 0.74 indicate that both monomers tend to crosspropagate in agreement with known literature values. Concerning the RAFT study, relatively good control and livingness of the copolymerization was observed except for the experiment in which IP represents 20 mol % in the feed. H NMR characterization confirmed the presence of both monomers in the final copolymer, particularly the presence of the epoxy ring of GMA which is susceptible to post polymerization reactions. Finally, preliminary results on the hydrogenation of various polymers are discussed.

Download full-text PDF

Source
http://dx.doi.org/10.1021/acscombsci.9b00110DOI Listing

Publication Analysis

Top Keywords

copolymerization isoprene
8
isoprene glycidyl
8
glycidyl methacrylate
8
reactivity ratios
8
semiautomated parallel
4
parallel raft
4
raft copolymerization
4
methacrylate copolymerization
4
methacrylate gma
4
gma performed
4

Similar Publications

The advancement of stereoregular polymerization techniques for linear 1,3-dienes has enabled the production of polymers with precise stereocontrol, influencing their physical and chemical properties significantly. While 1,3-butadiene and isoprene yield diverse stereoregular polymers, cyclic dienes have received less attention due to catalyst challenges and limited application in the rubber industry. However, the growing interest in bio-based monomers, particularly those derived from terpenes and terpenoids, has revitalized interest in cyclic monomers with conjugated double bonds.

View Article and Find Full Text PDF

The copolymerization of ethylene (E) with isoprene (Ip) was performed catalyzed by a symmetrical catalyst exhibiting a silicon bridge [rac-MeSi(2-Me-4-Ph-Ind)ZrCl with the combination of borate/TIBA activator. The effect of cocatalyst, Ip concentration, and polymerization temperature on the activity, molecular weight (Mw), distribution (MWD), comonomer composition, chain structure (regio- and stereoselectivity), and resulting side reactions were logically addressed. Gel-permeation chromatography (GPC) was used to characterize the Mw and polydispersity, while nuclear magnetic resonance (NMR) was employed for the chain structure of the polymers.

View Article and Find Full Text PDF

Radical ring-opening polymerization (rROP) has received renewed attention to incorporate cleavable linkages into the backbones of vinyl polymers, especially from cyclic ketene acetals (CKAs). Among the monomers that hardly copolymerize with CKAs are (1,3)-dienes such as isoprene (I). This is unfortunate since synthetic polyisoprene (PI) and its derivatives are the materials of choice for many applications, in particular as elastomers in the automotive, sport, footwear, and medical industries, but also in nanomedicine.

View Article and Find Full Text PDF

Synthesis of Chain-End Functional Polydienes Using Diene Comonomer Bearing Boronic Acid Masked with Diaminonaphthalene.

Molecules

December 2022

Department of Applied Chemistry, Graduate School of Engineering, Hiroshima University, Higashihiroshima 739-8527, Japan.

Diene comonomers bearing boronic acid masked with 1,8-diaminonaphthalene (dan) were applied to copolymerization with isoprene or butadiene using neodymium borohydride complex as a catalyst. The comonomers were tolerant to excess modified methylaluminoxane (MMAO) and thus were applicable to the polymerization system using MMAO. On the other hand, the corresponding pinacol borate was highly reactive toward MMAO, and no incorporation into the obtained polymer was observed.

View Article and Find Full Text PDF

The objectives of this work were to address the fundamental characteristics of ansa-zirconocene catalyzed E/diene copolymerization and E/diene/1-hexene and E/diene/propylene terpolymerizations, and the quantitative relationship between diene structure and polymer chain propagation rate constant in term of quantifiable catalytic active sites. One of the most important but unknown factors in olefins ansa-zirconocene complexes is the distribution of the catalyst between sites actively participating in polymer chain formation and dormant sites. A set of ethylene/dienes copolymerizations, and ethylene/dienes/1-hexene and ethylene/dienes/1-hexene terpolymerizations catalyzed with -zirconocenes/borate/triisobutylaluminium (-Et(Ind)ZrCl/[PhC][B(CF)]/triisobutylaluminium (TIBA) were performed in toluene at 50 °C To determine the active center [C*]/[Zr] ratio variation in the copolymerization of E with different dienes and their terpolymerization with 1-hexene and propylene, each polymer propagation chain ends were quenched with 2-thiophenecarbonyl, which selectively quenches the metal-polymer bonds through acyl chloride.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!