Introduction: It is vital to protect divers from the cold, particularly in Arctic conditions. The insulating gas layer within the drysuit is crucial for reducing heat loss. The technical diving community has long claimed the superiority of argon over air as an insulating gas. Although argon is widely used, previous studies have shown no significant differences between the two gases. Owing to its lower heat conductivity, argon should be a better thermal insulating gas than air.
Methods: The study aimed to determine whether argon is beneficial for reducing heat loss in divers during development of military drysuit diving equipment in Arctic water temperatures. Four divers completed 14 dives, each lasting 45 minutes: seven dives used air insulation and seven used argon insulation. Rectal and eight skin temperatures were measured from which changes in calculated mean body temperature (MBT) were assessed.
Results: There was a significant reduction in area weighted skin temperature over time (0-45 minute) on air dives (ΔTskin = -4.16°C, SE = 0.445, P ⟨ 0.001). On argon dives the reduction was significantly smaller compared to air dives (difference between groups = 2.26°C, SE = 0.358, P ⟨ 0.001). There were no significant changes in rectal temperatures, nor was a significant difference seen between groups.
Conclusion: Compared to air, argon may be superior as a drysuit insulating gas in Arctic water temperatures for some divers. Argon used as insulating gas can make diving safer and may diminish the risks of fatal diving accidents and occupational hazard risks in professional diving.
Download full-text PDF |
Source |
---|
Rev Sci Instrum
January 2025
School of Electrical Engineering, Xi'an Jiaotong University, Xi'an 710049, China.
The spiral generator, based on the principle of the electric field vector inversion, is capable of delivering repetitive high-voltage nanosecond pulses in the commercial portable pulsed x-ray source and gas switch trigger source. However, the spiral generator suffers from extremely low output efficiency, which significantly affects the compactness and accelerates the insulation film breakdown at electrode foil edges since the high charging voltage is required. A novel output efficiency improvement method for the spiral generator was proposed, implementing the permalloy film inside the passive layer to optimize internal voltage wave propagation processes during the pulser erection.
View Article and Find Full Text PDFACS Appl Polym Mater
December 2024
IMEM-BRT Group, Departament d'Enginyeria Química, EEBE, Universitat Politécnica de Catalunya, C/Eduard Maristany, 10-14, 08019 Barcelona, Spain.
The transition from insulator to electro-responsive has been successfully achieved by earlier studies for some inorganic materials by applying external stimuli that modify their 3D and/or electronic structures. In the case of insulating polymers, this transition is frequently accomplished by mixing them with other electroactive materials, even though a few physical treatments that induce suitable chemical modifications have also been reported. In this work, a smart approach based on the application of an electro-thermal reorientation process followed by a charged gas activation treatment has been developed for transforming insulating 3D printed polymers into electro-responsive materials.
View Article and Find Full Text PDFGels
December 2024
School of Energy and Building Environment, Guilin University of Aerospace Technology, Guilin 541004, China.
In this study, a new environmentally friendly and efficient method for recycling and reusing waste polyurethane sheets is proposed. SiO aerogel was prepared using the sol-gel method, and mullite whiskers were introduced to enhance its toughness. The whisker-toughened aerogel was used in the degradation of waste polyurethane to produce modified recycled polyol, which was subsequently used to prepare recycled polyurethane foam insulation material.
View Article and Find Full Text PDFAdv Mater
December 2024
Program in Materials Science and Engineering, University of California, San Diego, La Jolla, CA, 92093, USA.
The realization of low thermal conductivity at high temperatures (0.11 W m K 800 °C) in ambient air in a porous solid thermal insulation material, using stable packed nanoparticles of high-entropy spinel oxide with 8 cations (HESO-8 NPs) with a relatively high packing density of ≈50%, is reported. The high-density HESO-8 NP pellets possess around 1000-fold lower thermal diffusivity than that of air, resulting in much slower heat propagation when subjected to a transient heat flux.
View Article and Find Full Text PDFAnal Chem
December 2024
Research Center of Analytical Instrumentation, School of Mechanical Engineering, Sichuan University, Chengdu 610065, People's Republic of China.
In ambient mass spectrometry, the performance in direct in situ analysis applications has been hindered by the lack of efficient ion-transferring technique between the atmosphere pressure ionization source and the mass analyzer. Building upon the hybrid concept of a stack ring ion guide and multipole ion guide, this study proposes the concept of a reconfigurable twisted dipole ion guide (TDIG) that enables flexible ion transfer between atmosphere and vacuum. Initially, theoretical and numerical studies were conducted to understand the basic ion confining principle of the twisted dipole ion guide, revealing its unique merits in long-distance flexible ion transmission.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!