Objectives: Understand how cooling protocols control the microstructure and mechanical properties of veneering porcelains.
Methods: Two porcelain powders were selected, one used to veneer metallic frameworks (VM13) and one for zirconia frameworks (VM9). After the last firing cycle, the monolithic specimens were subjected to two cooling protocols: slow and fast. Flexural strength (FS) was evaluated by three-point beam bending and fracture toughness (K) was evaluated by the single-edge V-notch beam (SEVNB) method. Scanning electron microscopy (SEM) was performed to determine the leucite crystal volume fraction (%), particle size, and matrix microcrack density. The results were compared by analysis of variances (ANOVA) and Tukey's multiple comparison test.
Results: The mechanical properties were significantly (p<0.05) higher for the VM13 porcelain (FS=111.0MPa, K=1.01MPa.√m) compared to VM9 (FS=79.6MPa, K =0.87MPa.√m) regardless of cooling protocol due to ∼250% higher volume fraction of leucite crystals. The slow cooled VM13 and fast cooled VM9 resulted in the highest and lowest mechanical properties, respectively, while the VM9 slow cooled properties were similar to the VM13 fast cooled. The SEM revealed that the slow cooling significantly increased the volume fraction of leucite crystals by 33-41 %. Across both porcelains, a significant linear correlation between both mechanical properties (strength and toughness) and leucite crystal content was found. Slow cooling was also associated with increased crystal growth resulting in more matrix microcracking.
Significance: Controlled crystallization using slow cooling can be applied as a means of strengthening dental porcelains. However, the benefits of slow cooling may be partially offset by increasing the microcrack density in the glass matrix. To achieve the maximum benefit of slow cooling, it is recommending to develop heat treatments to produce porcelain with fine-grained and homogenously dispersed leucite crystals to achieve minimal glass matrix microcracking.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1016/j.dental.2019.07.011 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Carving Metal-Organic-Framework Glass Based Solid-State Electrolyte Via a Top-Down Strategy for Lithium-Metal Battery.
Angew Chem Int Ed Engl
January 2025
KU Leuven, Materials engineering, Kasteelpark Arenberg 44 bus 2450, 3001 LEUVEN Belgium, LEUVEN, BELGIUM.
Traditional polymer solid electrolytes (PSEs) suffer from low Li conductivity, poor kinetics and safety concerns. Here, we present a novel porous MOF glass gelled polymer electrolyte (PMG-GPE) prepared via a top-down strategy, which features a unique three-dimensional interconnected graded-aperture structure for efficient ion transport. Comprehensive analyses, including time-of-flight secondary ion mass spectrometry (TOF-SIMS), Solid-state 7Li magic-angle-spinning nuclear magnetic resonance (MAS-NMR), Molecular Dynamics (MD) simulations, and electrochemical tests, quantify the pore structures, revealing their relationship with ion conductivity that increases and then decreases as macropore proportion rises.
View Article and Find Full Text PDFAging-Induced Discrepant Response of Fracture Healing is Initiated from the Organization and Mineralization of Collagen Fibrils in Callus.
ACS Biomater Sci Eng
January 2025
Engineering Research Center of Chinese Ministry of Education for Biological Diagnosis, Treatment and Protection Technology and Equipment, Key Laboratory for Space Bioscience and Biotechnology, School of Life Sciences, Northwestern Polytechnical University, Xi'an 710072, China.
Fracture healing is a complex process during which the bone restores its structural and mechanical integrity. Collagen networks and minerals are the fundamental components to rebuild the bone matrix in callus. It has been recognized that bone quality could be impaired during aging.
View Article and Find Full Text PDFA brief review on the progress of MXene-based catalysts for electro- and photochemical water splitting for hydrogen generation.
Chem Commun (Camb)
January 2025
Materials Genome Institute of Shanghai University, Shanghai 200444, China.
The development and generation of affordable and highly efficient energy, particularly hydrogen, are one of the best approaches to address the challenges posed by the depletion of non-renewable energy sources. Hydrogen energy, as a green and ecosystem-friendly source with zero carbon emission, can be generated through various methods, including water splitting (HER/OER) either photo- or electrocatalytic reactions. To implement these reactions effectively in practical applications, it is highly desirable to develop extremely efficient and cost-effective catalytic materials that are comparable to contemporary catalysts.
View Article and Find Full Text PDFElectrically conducting porous hydrogels by a self-assembled percolating pristine graphene network.
Soft Matter
January 2025
Department of Chemistry, University of Connecticut, Storrs, Connecticut, USA.
This study introduces a method for synthesizing electrically conductive hydrogels by incorporating a self-assembled, percolating graphene network. Our approach differs from previous approaches in two crucial aspects: using pristine graphene rather than graphene oxide and self-assembling the percolation network rather than creating random networks by blending. We use pristine graphene at an oil-water interface to stabilize a water-in-oil emulsion, successfully creating hydrogel foams with conductivities up to 15 mS m and tunable porosity.
View Article and Find Full Text PDFBioactive Silk Cryogel Dressing with Multiple Physical Cues to Control Cell Migration and Wound Regeneration.
Adv Healthc Mater
January 2025
State Key Laboratory of Radiation Medicine and Radiation Protection, Institutes for Translational Medicine, Soochow University, Suzhou, Jiangsu Province, 215123, P. R. China.
Introducing multiple physical cues to control cell behaviors effectively is considered as a promising strategy in developing bioactive wound dressings. Silk nanofiber-based cryogels are developed to favor angiogenesis and tissue regeneration through tuning hydrated state, microporous structure, and mechanical property, but remained a challenge to endow with more physical cues. Here, β-sheet rich silk nanofibers are used to develop cryogels with nanopore structure.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!