Purpose: This study compared the biomechanics of reinserted pedicle screws using the previous entry point and trajectory with those of correctly inserted pedicle screws.
Methods: The study used 18 lumbar vertebrae (L1-6) from three fresh calf spines to insert 6.5 × 40-mm pedicle screws. A control screw was inserted correctly along the axis of one pedicle, while an experimental screw was reinserted completely using the previous entry point and trajectory in the other pedicle. The experimental screw was removed after being completely inserted in group A and after 80% of the total trajectory inserted in group B. And the experimental screw was removed after 60% of the total trajectory was reached in group C. The biomechanical values of the pedicle screws were measured.
Results: There were no significant differences in pedicle screw axial pullout strength between reinserted screws and correct screws in the 3 groups (P = 0.463, P = 0.753, P = 0.753). Stiffness measurement increased for the reinserted screw compared with that of the control screw. Fracturing was observed between the vertebral body and pedicle.
Conclusion: Theoretically, a surgeon can remove the pedicle screw when necessary, inspect the trajectory, and reinsert the screw using the previous entry point and trajectory.
Download full-text PDF |
Source |
|---|---|
| http://www.ncbi.nlm.nih.gov/pmc/articles/PMC6611027 | PMC |
| http://dx.doi.org/10.1186/s13018-019-1240-8 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
The predictive value of endplate morphology and pedicle screw bone quality score on screw loosening after single-level lumbar spinal fusion surgery.
J Orthop Surg Res
December 2024
Guangzhou University of Chinese Medicine, Guangzhou, Guangdong, 510006, China.
Objective: This study aims to explore the predictive value of endplate morphology and pedicle screw bone quality score on screw loosening after single-level lumbar spinal fusion surgery.
Methods: A retrospective analysis was conducted on the clinical data of 207 patients who underwent single-level lumbar spinal fusion (34 in the screw loosening group and 173 in the non-screw loosening group). Univariate analysis and binary logistic regression model analysis were performed using SPSS 27.
Applying a three-dimensional curved lumbar spine model to simulate surgery for training residents in pedicle screw insertion.
Surg Radiol Anat
December 2024
Department of Anatomy, Digital Imaging and 3D Modelling Laboratory, Faculty of Medicine, Ege University, Bornova, 35100, Izmir, Turkey.
Purpose: The challenges of spinal surgery can be overcome by deeply understanding the anatomical and surgical complexities of the region through the use of model simulators. This study investigates the impact of digitally designed simulators, specifically lumbar spinal models with abnormal curvature, on preoperative planning and their effectiveness as training tools. The study addresses challenges in spine surgery, such as unique deformities, classification issues, and associated abdominal structure abnormalities.
View Article and Find Full Text PDFPedicle Screw Pull-Out Strength Between the Jamshidi Needle and Pedicle Probe Techniques in an Osteoporotic Cancellous Bone Model: A Biomechanical Study.
Cureus
November 2024
Aerospace Engineering, Universiti Putra Malaysia, Kuala Lumpur, MYS.
Introduction Spinal fusion surgery with pedicle screws is commonly performed to stabilize the spine of osteoporotic patients. However, securing a strong screw fixation in osteoporotic bone presents significant challenges due to the reduced bone density. This study aimed to compare the biomechanical performance in an osteoporotic bone model of pedicle screws inserted using two different techniques, the Jamshidi needle technique and the pedicle probe technique, as well as the influence of tapping on both these techniques.
View Article and Find Full Text PDFHounsfield unit to serum pentosidine ratio predicts screw loosening after lumbar interbody fusion.
BMC Musculoskelet Disord
December 2024
Department of Orthopaedic Surgery, The Jikei University School of Medicine, 3-19-18 Nishi-shimbashi, Minato-ku, Tokyo, 105-8471, Japan.
Purpose: This study aimed to identify whether the ratio of the vertebral Hounsfield unit to serum pentosidine (H/P ratio), which reflects bone density and quality, can predict screw loosening after spinal fusion surgery.
Methods: A retrospective case-control study was conducted in 35 patients (mean age 71 ± 10.4 years, 18 men) who underwent spinal interbody fusion for lumbar spine disease between June 2020 and February 2022.
Finite element analysis of modified pedicle screw fixation and traditional lumbopelvic fixation for the treatment of sacroiliac joint disruption.
BMC Musculoskelet Disord
December 2024
Department of Orthopaedics, Seventh People's Hospital of Shanghai University of TCM, Shanghai, 200137, China.
Introduction: The modified pedicle screw fixation (PSF) was designed to simulate an integrated framework structure to ameliorate the resistance to vertical and shearing forces of the disrupted sacroiliac complex, and the aim of this study was to compare the biomechanical characteristics of PSF and traditional lumbopelvic fixation (LPF) for the treatment of sacroiliac joint disruption.
Methods: The digital computer simulation model of an intact spine-pelvis-femur complex with main ligaments was built from clinical images. A left sacroiliac joint disruption model was mimicked by removing the concerned ligaments.
Want AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!