Limb bone articular and diaphyseal proportions have been shown to relate to locomotor behavior in broad comparisons across catarrhines, but comparisons among phylogenetically and functionally more closely related species may be particularly useful in investigating form-function relationships that can be applied to fossil taxa. Here we compare inter- and intra-limb proportions of diaphyseal strength and articular surface area and breadth of the femur and humerus with frequencies of leaping and vertical climbing behavior in 13 cercopithecid species. Leaping frequency is highly positively correlated with femoral/humeral diaphyseal strength, moderately positively correlated with femoral/humeral articular breadth, and less highly correlated with femoral/humeral articular surface area. These results are consistent with predicted higher bending loads as well as joint reaction forces on the femora of leapers. Surface areas may show a weaker association because they also directly impact joint excursion and are thus more influenced by other aspects of locomotion, including climbing. Climbing frequency is positively correlated with humeral head articular surface area/diaphyseal strength, but weakly negatively correlated with femoral head articular surface area/diaphyseal strength. These combined trends lead to a strong negative association between climbing and femoral/humeral head surface area. Femoral/humeral diaphyseal strength and distal articular breadth are not correlated with climbing frequency. The climbing results are consistent with greater shoulder mobility in more frequent vertical climbers. The lack of such a relationship in the femur among these taxa contrasts with earlier findings for catarrhines more generally, including hominoids, and may be a result of different climbing kinematics in cercopithecoids involving less hip abduction than in hominoids. Different use of the forelimb during climbing in cercopithecoids and hominoids may also explain the lack of association between femoral/humeral diaphyseal strength and climbing in the present study, in contrast to comparisons across catarrhines more generally.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1016/j.jhevol.2019.04.003 | DOI Listing |
Vet Comp Orthop Traumatol
November 2024
Department of Animal Medicine, Universidade Federal do Rio Grande do Sul, Porto Alegre, RS, Brazil.
Objective: To assess the biomechanical parameters of intact tibiotarsi (INT) and tibiotarsi with a 5-mm segmental diaphyseal defect repaired using four osteosynthesis techniques: a locking plate (LP), a plate-rod combination, an external skeletal fixator (one end-threaded positive-profile pin per fragment) with an intramedullary pin tie-in (TIF 1), and an external skeletal fixator (two end-threaded positive-profile pins per fragment) with an intramedullary pin tie-in (TIF 2).
Study Design: Sixty tibiotarsi from 30 adult laying hens were allocated into five groups for nondestructive dynamic torsion and four-point bending tests, followed by failure tests. Nondestructive dynamic tests evaluated stiffness over time in torsion and bending.
While many humeral shaft fractures can be successfully treated with nonoperative management, compression plating techniques using at least three or four screws on either side of the fracture are the current gold standard. We hypothesized that a less rigid construct using compression with only two screws on either side of the fracture can provide adequate strength for uneventful fracture union. This is a retrospective review of all the patients who underwent open reduction and compression plate fixation for acute diaphyseal humerus fractures (ADHFs) at an academic Level-1 urban trauma center between 2018 and 2023.
View Article and Find Full Text PDFJ Mech Behav Biomed Mater
December 2024
Department of Orthopedic Surgery, SUNY Upstate Medical University, 750 East Adams Street, Syracuse, NY, 13210, USA. Electronic address:
JOM (1989)
July 2024
Department of Mechanical Engineering, University of Utah, Salt Lake City, UT 84112 USA.
Unlabelled: The osteon is the primary structural component of bone, contributing significantly to its unique toughness and strength. Despite extensive research on osteonal structure, the properties of osteons have not been fully investigated, particularly within the context of bone fragility diseases like type 2 diabetes mellitus (T2DM). This study aims to isolate osteons from bovine bone, simulate the effects of increased advanced glycation end-products (AGEs) in T2DM through ribosylation, and evaluate the mechanical properties of isolated osteons.
View Article and Find Full Text PDFJ Orthop Res
January 2025
School of Engineering Design and Innovation, The Pennsylvania State University, University Park, Pennsylvania, USA.
Axial micromotion between bone fragments can stimulate callus formation and fracture healing. In this study, we propose a novel mechanically compliant locking plate which achieves up to 0.6 mm of interfragmentary motion as flexures machined into the plate elastically deflect under physiological load.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!