The aim of this study was to examine the smear layer removal capacity of various etidronate treatments. Seventy-eight roots were instrumented up to apical size X4 and randomly divided into five treatment groups and a positive control group (n = 13). Groups were as follows: irrigation with 5 ml of sterile saline (control) for 3 min, 5 ml of 17% ethylenediaminetetraacetic acid (EDTA) for 3 min, 5 ml of 9% A1-hydroxyethylidene-1,1-bisphosphonate (HEBP) for 3 min, 5 ml of 18% HEBP for 3 min, irrigation with 5 ml of 1% sodium hypochlorite (NaOCl) + 9% HEBP for 3 min, and 5 ml of 2% NaOCl + 18% HEBP for 3 min. The roots were examined using a scanning electron microscope. The smear layer scores in the 2% NaOCl + 18% HEBP group were lower than those in the other treatment groups and the control group (p < .05). There were no significant differences among the treatment groups in the smear layer scores of the coronal and middle thirds. However, the smear layer scores in the 2% NaOCl + 18% HEBP treatment group were lower those in the 9% HEBP and 18% HEBP treatment groups in the apical third (p < .05). In the clinical setting, the recommended concentration of HEBP is 18%, and it should be used with an oxidizing agent to ensure optimum smear layer removal.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1002/jemt.23318 | DOI Listing |
J Endod
March 2023
Department of Conservative and Prosthetic Dentistry, School of Dentistry, Complutense University, Madrid, Spain. Electronic address:
Introduction: The purpose of this study was to evaluate pulp tissue dissolution ability of sodium hypochlorite (NaOCl) when mixed with tetrasodic etidronate (NaHEBP) and disodic ethylenediaminetetraacetate (NaEDTA) under controlled flow.
Methods: Bovine pulp tissue was extracted from the lower incisors of 10 bovine jaws. Pulp specimens were standardized in size (1 × 3 × 10 mm), blotted dry, and weighed (initial weight [T0]: mean (SD) = 31.
Microsc Res Tech
September 2019
Department of Endodontics, Faculty of Dentistry, Suleyman Demirel University, Isparta, Turkey.
The aim of this study was to examine the smear layer removal capacity of various etidronate treatments. Seventy-eight roots were instrumented up to apical size X4 and randomly divided into five treatment groups and a positive control group (n = 13). Groups were as follows: irrigation with 5 ml of sterile saline (control) for 3 min, 5 ml of 17% ethylenediaminetetraacetic acid (EDTA) for 3 min, 5 ml of 9% A1-hydroxyethylidene-1,1-bisphosphonate (HEBP) for 3 min, 5 ml of 18% HEBP for 3 min, irrigation with 5 ml of 1% sodium hypochlorite (NaOCl) + 9% HEBP for 3 min, and 5 ml of 2% NaOCl + 18% HEBP for 3 min.
View Article and Find Full Text PDFInt Endod J
December 2015
Department of Stomatology, School of Dentistry, University of Granada, Granada, Spain.
Aim: To evaluate the antimicrobial effect of 2.5% sodium hypochlorite alone (NaOCl) and associated with 9% HEBP (NaOCl/HEBP), 2% peracetic acid (PAA) and 2% chlorhexidine (CHX), on the viability of Enterococcus faecalis biofilms attached to dentine.
Methodology: Biofilms of E.
Int Endod J
January 2014
Department of Endodontics, Dental School, Federal University of Pará, Belém, Brazil.
Aim: To evaluate the influence of sodium hypochlorite associated with EDTA and etidronate on apical root transportation.
Methodology: Forty-five roots of human mandibular molars with curvatures of 15-25° were embedded in acrylic resin to allow standardized angulation of the initial and final radiographs. The pre-instrumentation radiographs of the mesiobuccal canal of each root were taken using a radiograph digital sensor with a size 15 K-file in the canal.
Acta Odontol Scand
January 2013
Faculty of Dentistry, Department of Prosthodontics, Gazi University, Ankara, Turkey.
Objective: The aim of this study was to evaluate the effect of tetracycline HCl, 1-hydroxyethylidene-1, 1-bisphosphonate (HEBP) and chlorhexidine digluconate (CHX) on micro push-out (µ-PO) bond strengths of two self-adhesive resin cements on dentin.
Materials And Methods: Sixty discs of 1.25 mm thickness (middle dentin) were prepared from human molars perpendicular to the tooth axis.
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!