The development of two high-speed monolithically integrated optical receivers for wireless optical communication is presented from the design phase to the measurement. The first high-speed receiver is the modified previous design with an integrated 200-µm diameter avalanche photodiode. The redesign improved the optical sensitivity by 3.7 dB resulting in the sensitivity of -35.5 dBm at 1 Gbit/s. The second receiver is an avalanche photodiode receiver with increased photodiode diameter of 400 µm with a sensitivity of -34.7 dBm at 1 Gbit/s. The receivers were employed in wireless optical communication experiments under various ambient light conditions. The maximum error free transmission distance is 22 m at 1 Gbit/s OWC link. The limits of the used standard 0.35 µm HV CMOS technology are estimated in terms of maximum possible detection area of avalanche photodiode receiver still capable for Gbit data rates.

Download full-text PDF

Source
http://dx.doi.org/10.1364/OE.27.011930DOI Listing

Publication Analysis

Top Keywords

avalanche photodiode
12
035 µm
8
µm cmos
8
cmos technology
8
detection area
8
wireless optical
8
optical communication
8
dbm gbit/s
8
photodiode receiver
8
optical
5

Similar Publications

Si APD-Based High Speed Infrared Radiation Thermometry for Analysing the Temperature Instability of a Combustion Chamber.

Sensors (Basel)

December 2024

Sensor Systems Group, School of Electrical & Electronic Engineering, The University of Sheffield, Portobello Centre, Pitt Street, Sheffield S1 4ET, UK.

This study introduces a novel approach to analysing the combustion process using a high-speed, non-contact, optical fibre-coupled Si avalanche photodiode (APD)-based infrared radiation thermometer (IRT). The Si APD-IRT, combined with an optimised field-programmable gate array (FPGA)-based digital design, achieves a response time of 1 µs, faster than commercially available instruments. Our instrument captures the entire ignition and reignition cycle of a Jet A kerosene droplet with high temporal precision within a combustion chamber, a feat impossible with traditional thermocouples.

View Article and Find Full Text PDF
Article Synopsis
  • Quantitative X-ray diffraction techniques need careful adjustments for sample transmission, especially in SAXS and WAXS experiments.
  • Typical beamstops used in X-ray nanoprobes can’t record transmission signals simultaneously with scattering data, which negatively impacts data quality.
  • The paper introduces a novel small beamstop with an embedded metal target to enhance fluorescence detection, allowing for accurate sample transmission measurements using a high-sensitivity avalanche photodiode.
View Article and Find Full Text PDF

Ultrahigh Resolving Power Ion Mobility Spectrometry with a Simple Pulser Circuitry.

Anal Chem

December 2024

Department of Chemistry, University of Basel, Klingelbergstrasse 80, Basel 4056, Switzerland.

The pulsing circuitry for high resolving power drift-tube ion-mobility spectrometry is based on three avalanche photodiodes. These are switched on by illumination through optical fibers, which provide electrical insulation of the driver circuitry from the high voltage. The setup was tested with a series of quaternary ammonium ions introduced with an electrospray ion source.

View Article and Find Full Text PDF

This article proposes a separate absorption and multiplication (SAM) GaN-based avalanche photodiode (APD) that achieves both high gain and low operating voltage by applying Sc-based ferroelectric material ScGaN in APDs. The avalanche gain of the proposed SAM APD with a low Sc composition p-ScGaN insertion layer reaches 7.2 × 10, which is 60% higher than that of a conventional p-i-p-i-n GaN-based APD.

View Article and Find Full Text PDF

To achieve higher visible light communication (VLC) traffic capacity, using the wide bandwidth light-emitting diode (LED) and spectral efficiency modulation signal, is currently the most commonly used method. In this demonstration, we apply the orthogonal frequency division multiplexing quadrature amplitude modulation (OFDM-QAM) with bit- and power-loading algorithm on single blue LED to achieve >1 Gbit/s VLC capacity, when a 400 MHz bandwidth avalanche photodiode (APD)-based receiver (Rx) is exploited for decoding. Here, the higher sensitivity APD can be applied to compensate for the wireless VLC link length in the proposed LED VLC system, and due to the lower LED illumination (255 to 40 lux), is used for the indoor access network after passing the wireless link length of 1 to 4 m.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!