Using spectroscopic ellipsometry measurements on GaPBi/GaP epitaxial layers up to x = 3.7% we observe a giant bowing of the direct band gap ([Formula: see text]) and valence band spin-orbit splitting energy (Δ). [Formula: see text] (Δ) is measured to decrease (increase) by approximately 200 meV (240 meV) with the incorporation of 1% Bi, corresponding to a greater than fourfold increase in Δ in going from GaP to GaPBi. The evolution of [Formula: see text] and Δ with x is characterised by strong, composition-dependent bowing. We demonstrate that a simple valence band-anticrossing model, parametrised directly from atomistic supercell calculations, quantitatively describes the measured evolution of [Formula: see text] and Δ with x. In contrast to the well-studied GaAsBi alloy in GaPBi substitutional Bi creates localised impurity states lying energetically within the GaP host matrix band gap. This leads to the emergence of an optically active band of Bi-hybridised states, accounting for the overall large bowing of [Formula: see text] and Δ and in particular for the giant bowing observed for x ≲ 1%. Our analysis provides insight into the action of Bi as an isovalent impurity, and constitutes the first detailed experimental and theoretical analysis of the GaPBi alloy band structure.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC6497675 | PMC |
http://dx.doi.org/10.1038/s41598-019-43142-5 | DOI Listing |
Philos Trans A Math Phys Eng Sci
January 2025
Microsystems Group, School of Engineering, Newcastle University, Newcastle upon Tyne NE1 7RU, UK.
The increasing demand for processing large volumes of data for machine learning (ML) models has pushed data bandwidth requirements beyond the capability of traditional von Neumann architecture. In-memory computing (IMC) has recently emerged as a promising solution to address this gap by enabling distributed data storage and processing at the micro-architectural level, significantly reducing both latency and energy. In this article, we present In-Memory comPuting architecture based on Y-FlAsh technology for Coalesced Tsetlin machine inference (IMPACT), underpinned on a cutting-edge memory device, Y-Flash, fabricated on a 180 nm complementary metal oxide semiconductor (CMOS) process.
View Article and Find Full Text PDFSci Rep
January 2025
Computational Physics Key Laboratory of Sichuan Province, Yibin University, Yibin, China.
The potential energy curves, dipole moments and transition dipole moments of the 14 Λ-S states and 30 Ω states of TlBr cation were performed using the multi-reference configuration interaction method. The Davidson correction and spin-orbit coupling effects were also considered. The spectroscopic properties and transition properties of TlBr cation were reported at the first time.
View Article and Find Full Text PDFSci Rep
January 2025
Laboratory for Artificial Intelligence, Institute for Computational Science and Artificial Intelligence, Van Lang University, Ho Chi Minh City, Vietnam.
Compliant mechanism has some advantages and has been widely applied in many accurate positioning systems. However, modeling the compliant mechanism behavior has suffered from many challenges, such as unstable results, and the limitation of training data set. In the field of compliant mechanism modeling, there has been no research interested in applying meta-heuristics optimization algorithms to optimize the weights and biases of the neural network globally.
View Article and Find Full Text PDFSci Rep
January 2025
College of Intelligent Systems Science and Engineering, Hubei Minzu University, Enshi, 445000, China.
This paper addresses the low level of intelligence in tea processing equipment in Enshi Prefecture by designing an intelligent withering control system based on the STMicroelectronics 32-bit Microcontroller (STM32). This control system can achieve real-time monitoring of the withering environment and automate the control of heating and ventilation dehumidification modules. By integrating IoT technology, relevant users can view the tea production process via mobile devices, enabling intelligent and remote production operations.
View Article and Find Full Text PDFSci Rep
January 2025
Department of Physics, The American University in Cairo, New Cairo, 11835, Egypt.
Inverse design with topology optimization considers a promising methodology for discovering new optimized photonic structure that enables to break the limitations of the forward or the traditional design especially for the meta-structure. This work presents a high efficiency mid infra-red imaging photonics element along mid infra-red wavelengths band starts from 2 to 5 µm based on silicon nitride optimized material structures. The first two designs are broadband focusing and reflective meta-lens under very high numerical aperture condition (NA = 0.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!