Novel TiO catalyst carriers with high thermostability for selective catalytic reduction of NO by NH.

Catal Today

Department of Chemistry and Biochemistry, Environmental Science & Engineering, and Biomedical Engineering, University of Texas at EL Paso, EL Paso, TX 79968, USA.

Published: May 2019

A series of TiO catalyst carriers with ceria additives were prepared by a precipitation method and tested for selective catalytic reduction (SCR) of NO by NH. These samples were characterized by XRD, N-BET, NH-TPD, H-TPR, TEM, XPS and DRIFTS, respectively. Results showed that the appropriate addition of ceria can enhance the catalytic activity and thermostability of TiO catalyst carriers significantly. The maximum catalytic activity of Ti-Ce-O-500 is 98.5% at 400 °C with a GHSV of 100 000 h and the high catalytic activity still remains even after the treatment at high temperature for 24 h. The high catalytic performance of Ti-Ce-O-500 can be attributed to a series of superior properties, such as larger specific surface area, more Brønsted acid sites, more hydrogen consumption, and the higher proportion of chemisorbed oxygen. Ceria atoms can inhibit the crystalline grain growth and the collapse of small channels caused by high temperatures. Furthermore, DRIFTS in different feed gases show that the SCR reaction over Ti-Ce-O-500 follows both E-R and L-H mechanisms.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC6469708PMC
http://dx.doi.org/10.1016/j.cattod.2018.04.038DOI Listing

Publication Analysis

Top Keywords

tio catalyst
12
catalyst carriers
12
catalytic activity
12
selective catalytic
8
catalytic reduction
8
high catalytic
8
catalytic
6
high
5
novel tio
4
carriers high
4

Similar Publications

The effects of filter fabrication approaches on photocatalytic abatement of formaldehyde in an indoor environment using a TiO-based air purifier system.

Environ Res

December 2024

Department of Global Smart City & School of Civil, Architectural Engineering, and Landscape Architecture, Sungkyunkwan University, 2066 Seobu-ro, Suwon 16419, Republic of Korea. Electronic address:

Titanium dioxide (TiO) is the most commonly used catalyst for fabricating commercial photocatalytic air purifier (AP) systems. The AP performance can be affected sensitively by the preparation conditions of filters and the physicochemical properties (e.g.

View Article and Find Full Text PDF

A cost-effective industrial TiOSO solution was employed to fabricate visible light active sulfur-doped titanium dioxide (S-TiO) via a facile hydrothermal method. The effect of calcination temperature on morphology, particle size, crystallinity, and photocatalytic property of S-TiO was systematically investigated. Successful incorporation of sulfur into TiO was confirmed by carbon-sulfur analysis, X-ray photoelectron spectroscopy (XPS), and Energy dispersive spectrometer (EDS).

View Article and Find Full Text PDF

Multi-heterointerface charge transfer in amine-functionalized cadmium sulfide-copper sulfide@titanium dioxide hollow spheres with rich oxygen vacancies for carbon dioxide photoreduction.

J Colloid Interface Sci

December 2024

Key Laboratory of Functional Inorganic Material Chemistry, Ministry of Education of the People's Republic of China, Heilongjiang University, Harbin 150080, PR China. Electronic address:

Photocatalytically reducing CO into high-value-added chemical materials has surfaced as a viable strategy for harnessing solar energy and mitigating the greenhouse effect. But the inadequate separation of the photogenerated electron-hole pair remains a major obstacle to CO photoreduction. Constructing heterostructure photocatalysts with efficient interface charge transfer is a promising approach to solving the above problems.

View Article and Find Full Text PDF

WO/Ag/TiO composite photoelectrodes were formed via the high-temperature calcination of a WO film, followed by the sputtering of a very thin silver film and deposition of an overlayer of commercial TiO nanoparticles. These synthetic photoanodes were characterized in view of the oxidation of a model organic compound glucose combined with the generation of hydrogen at a platinum cathode. During prolonged photoelectrolysis under simulated solar light, these photoanodes demonstrated high and stable photocurrents of ca.

View Article and Find Full Text PDF

Single-Atom Mo Supported by TiO for Photocatalytic Nitrogen Fixation.

Langmuir

December 2024

State Key Laboratory of High-Efficiency Utilization of Coal and Green Chemical Engineering, School of Chemistry and Chemical Engineering, Ningxia University, Yinchuan, Ningxia 750021, PR China.

The challenge of achieving efficient photocatalysts for the fixation of ambient nitrogen to ammonia persists. The utilization efficiency of single-metal-atom catalysts leads to an increased number of active sites, while their distinctive geometrical and electronic characteristics contribute to enhancing the intrinsic activity of each individual site. In this study, we present a method using an organic molecule to assist in loading TiO with Mo single atoms for the purpose of photocatalytic nitrogen fixation.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!