In this work, a tetraethylenepentamine (TEPA)-grafted metal-organic framework material (MIL-101) was synthesized. The introduction of TEPA increased the abundance of functional groups on the MIL-101. As a powdery adsorbent, MIL-101-TEPA can be difficult to separate. In order to solve this problem, we combined MIL-101-TEPA with sodium alginate (SA) and injected the mixture into a CaCl₂ solution to solidify the powder into beads with a particle size of 3 mm. The easily recovered adsorbent was applied to the adsorption of Pb(II) from water. The structure and characterization of the adsorbent were investigated through scanning electron microscope (SEM), Fourier-transform infrared spectroscopy (FTIR), X-Ray diffraction (XRD), thermogravimetric analysis (TGA), and X-ray photoelectron spectroscopy (XPS). We also optimized the adsorption conditions. The results of the study showed that the adsorption process was chemisorptive and endothermic in nature. The maximum adsorption capacity of the composite beads was 558.6 mg/g. Meanwhile MIL-101-TEPA@CA showed good repeatable utilization.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC6403883 | PMC |
http://dx.doi.org/10.3390/polym10070750 | DOI Listing |
Adv Sci (Weinh)
January 2025
Department of Chemistry, University of North Texas1508 W Mulberry St, Denton, TX, 76201, USA.
Efficient removal of TcO from radioactive effluents while recovering drinking water remains a challenge. Herein, an excellent ReO (a nonradioactive surrogate of TcO ) scavenger is presented through covalently bonding imidazolium poly(ionic liquids) polymers with an ionic porous aromatic framework (iPAF), namely iPAF-P67, following an adsorption-site density-addition strategy. It shows rapid sorption kinetics, high uptake capacity, and exceptional selectivity toward ReO .
View Article and Find Full Text PDFEnviron Res
January 2025
Department of Chemical Engineering, BITS Pilani Hyderabad Campus, Hyderabad, 500078, India. Electronic address:
In this work, a novel adsorbent from alginate, zeolite and biochar has been made through one-pot synthesis route with highly compatible Sodium Dodecyl Sulphate (SDS) modification. This gave ultra-high Ni removal of 1205 mg/g in batch mode while treating almost 200 L of solution in column mode with 1171 mg/g capacity, which are the one of the highest reported values. The Point of Zero Charge (pH) for Ni removal was determined to be 5, with optimal removal efficiency being observed at pH 7, indicating a negative surface charge of the ABPC beads, which aligns with the anionic charge provided by SDS enhancement.
View Article and Find Full Text PDFInt J Biol Macromol
January 2025
Departamento de Biocatálisis, ICP-CSIC, C/Marie Curie 2, Campus UAM-CSIC, 28049 Madrid, Spain. Electronic address:
Eversa Transform (ETL) was immobilized on octyl agarose beads at two different enzymes loadings (1 mg/g and 15 mg/g) under 18 different conditions, including different pH values, buffers, additives (different solvents, Ca, NaCl). Their activity was analyzed at pH 5 and 7 with p-nitrophenyl butyrate and at pH 5 with triacetin, determining also its stability at pH 5 and 7 (in different media). Ca stabilized ETL biocatalysts while phosphate destabilized them.
View Article and Find Full Text PDFJ Hazard Mater
January 2025
Graduate Institute of Environmental Engineering, National Taiwan University, Taipei 106319, Taiwan; Advanced Research Center for Green Materials Science and Technology, National Taiwan University, Taipei 106319, Taiwan. Electronic address:
Anthropogenic and industrial activities have released large amounts of mercury (Hg) into the hydrosphere. Hg ultimately deposits in sediments and could be re-released into the water environment, threatening the ecological system. Active capping is considered a suitable remediation method due to its relatively low cost and in-situ decontamination feasibility.
View Article and Find Full Text PDFJ Environ Manage
January 2025
Department of Soil Science and Agricultural Chemistry, Engineering Polytechnic School, University of Santiago de Compostela, 27002, Lugo, Spain.
The primary goal of the current work was to construct pH-sensitive nano and microcomposite hydrogel beads based on alginate (AL), carboxymethyl cellulose (CMC), biochar (BC), and two Moroccan clays: Ghassoul (swelling SW) and red (not swelling NSW) nano and microhybrid. The adsorbents, SW + AL, SW + AL + BC, SW + AL + CMC, NSW + AL, NSW + AL + BC, NSW + AL + CMC, AL, and AL + CMC were prepared for the adsorption of the antibiotic sulfadiazine (SDZ). The test samples were characterized using a variety of techniques, including X-Ray Diffraction (XRD), IR spectroscopy (FT-IR), and scanning electron microscopy (SEM), with the molecular structures of the studied additives geometrically optimized using the DFT/B3LYP method and the function 6-311G(d).
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!