Silicon Microelectromechanical Systems (MEMS) resonators have broad commercial applications for timing and inertial sensing. However, the performance of MEMS resonators is constrained by dissipation mechanisms, some of which are easily detected and well-understood, but some of which have never been directly observed. In this work, we present measurements of the quality factor, Q, for a family of single crystal silicon Lamé-mode resonators as a function of temperature, from 80-300 K. By comparing these Q measurements on resonators with variations in design, dimensions, and anchors, we have been able to show that gas damping, thermoelastic dissipation, and anchor damping are not significant dissipation mechanisms for these resonators. The measured f · Q product for these devices approaches 2 × 10, which is consistent with the expected range for Akhiezer damping, and the dependence of Q on temperature and geometry is consistent with expectations for Akhiezer damping. These results thus provide the first clear, direct detection of Akhiezer dissipation in a MEMS resonator, which is widely considered to be the ultimate limit to Q in silicon MEMS devices.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC6381092 | PMC |
http://dx.doi.org/10.1038/s41598-019-38847-6 | DOI Listing |
IEEE Trans Ultrason Ferroelectr Freq Control
January 2024
Guiding and manipulating GHz frequency acoustic waves in [Formula: see text]-scale waveguides and resonators open up new degrees of freedom to manipulate radio frequency (RF) signals in chip-scale platforms. A critical requirement for enabling high-performance devices is the demonstration of low acoustic dissipation in these highly confined geometries. In this work, we show that gallium nitride (GaN) on silicon carbide (SiC) supports low-loss acoustics by demonstrating acoustic microring resonators with frequency-quality factor ( fQ ) products approaching 10 Hz at 3.
View Article and Find Full Text PDFNano Lett
April 2021
Department of Physical Sciences, Indian Institute of Science Education and Research Mohali, Knowledge City, Sector 81, SAS Nagar, Manauli, P.O. 140306, India.
Advances in nanofabrication techniques have made it feasible to observe damping phenomena beyond the linear regime in nanomechanical systems. In this work, we report cubic nonlinear damping in palladium nanomechanical resonators. Nanoscale palladium beams exposed to a H atmosphere become softer and display enhanced Duffing nonlinearity as well as nonlinear damping at ultralow temperatures.
View Article and Find Full Text PDFSensors (Basel)
December 2020
Institute of Semiconductors, Chinese Academy of Sciences, Beijing 100083, China.
This work investigates the dominant energy dissipations of the multi-frequency whispering gallery mode (WGM) resonators to provide an insight into the loss mechanisms of the devices. An extensive theory for each loss source was established and experimentally testified. The squeezed film damping (SFD) is a major loss for all the WGMs at atmosphere, which is distinguished from traditional bulk acoustic wave (BAW) resonators where the high-order modes suffer less from the air damping.
View Article and Find Full Text PDFSci Rep
December 2019
Department of Electrical and Computer Engineering, Georgia Institute of Technology, 777 Atlantic Drive NW, Atlanta, GA, 30332, USA.
Micromechanical resonators with ultra-low energy dissipation are essential for a wide range of applications, such as navigation in GPS-denied environments. Routinely implemented in silicon (Si), their energy dissipation often reaches the quantum limits of Si, which can be surpassed by using materials with lower intrinsic loss. This paper explores dissipation limits in 4H monocrystalline silicon carbide-on-insulator (4H-SiCOI) mechanical resonators fabricated at wafer-level, and reports on ultra-high quality-factors (Q) in gyroscopic-mode disk resonators.
View Article and Find Full Text PDFSci Rep
February 2019
Department of Mechanical Engineering, Stanford University, Stanford, California, 95304, USA.
Silicon Microelectromechanical Systems (MEMS) resonators have broad commercial applications for timing and inertial sensing. However, the performance of MEMS resonators is constrained by dissipation mechanisms, some of which are easily detected and well-understood, but some of which have never been directly observed. In this work, we present measurements of the quality factor, Q, for a family of single crystal silicon Lamé-mode resonators as a function of temperature, from 80-300 K.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!