Self-sustained feedback oscillators referenced to MEMS/NEMS resonators have the potential for a wide range of applications in timing and sensing systems. In this paper, we describe a real-time temperature compensation approach to improving the long-term stability of such MEMS-referenced oscillators. This approach is implemented on a ~26.8 kHz self-sustained MEMS oscillator that integrates the fundamental in-plane mode resonance of a single-crystal silicon-on-insulator (SOI) resonator with a programmable and reconfigurable single-chip CMOS sustaining amplifier. Temperature compensation using a linear equation fit and look-up table (LUT) is used to obtain the near-zero closed-loop temperature coefficient of frequency (TC) at around room temperature (~25 °C). When subject to small temperature fluctuations in an indoor environment, the temperature-compensated oscillator shows a >2-fold improvement in Allan deviation over the uncompensated counterpart on relatively long time scales (averaging time τ > 10,000 s), as well as overall enhanced stability throughout the averaging time range from τ = 1 to 20,000 s. The proposed temperature compensation algorithm has low computational complexity and memory requirement, making it suitable for implementation on energy-constrained platforms such as Internet of Things (IoT) sensor nodes.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC6266509 | PMC |
http://dx.doi.org/10.3390/mi9110559 | DOI Listing |
J Am Chem Soc
January 2025
Department of Quantum Matter Physics, University of Geneva, 24 Quai Ernest-Ansermet, CH-1211 Geneva, Switzerland.
Layered delafossite-type compounds and related transition metal dichalcogenides, characterized by their triangular net structures, serve as prototypical systems for exploring the intricate interplay between crystal structure and magnetic behavior. Herein, we report on the discovery of the compound KCrSe ( ≈ 0.13), an incommensurately modulated phase.
View Article and Find Full Text PDFA passive temperature-compensated magnetic field sensor based on the material thermal-optics effect has been proposed. The proposed structure is easy to fabricate, consisting of only two single-mode optical fibers adhered to a magnetostrictive rod and the Fabry-Perot (FP) cavity filled with polydimethylsiloxane (PDMS). Benefitting from the negative thermal-optics coefficient of PDMS, the temperature cross-sensitivity of the sensor decreased from 351.
View Article and Find Full Text PDFThis paper presents a highly sensitive, temperature-insensitive optical carrier microwave interferometry (OCMI) system using a cascaded three fiber Bragg grating (FBG) structure to generate an enhanced Vernier effect for sensing applications. The enhanced Vernier effect is created by superimposing the interferograms of two separate interferometers formed by pairing the sensing FBG with each reference FBG. Experimental and theoretical results show that in strain sensing, the sensitivity based on enhanced Vernier effect is -4.
View Article and Find Full Text PDFInnovation (Camb)
January 2025
Center for High Pressure Science and Technology Advanced Research, Beijing 100193, China.
The steep temperature gradient near the bottom of the mantle is known to generate a negative correlation between the shear wave velocity ( ) and the depth in most regions of the D″ layer, as detected by seismological observations. However, increasing with depth is observed at the D″ layer beneath Central America, where the Farallon slab sinks, and the origin of this anomaly has not been well constrained. Here, we calculate the thermoelastic constants and obtain the elastic wave velocities of hydrous phase H with various Al contents and cation configurations, which may act as a water carrier to the D″ layer.
View Article and Find Full Text PDFPolymers (Basel)
January 2025
Rheology Department, Polymat Institute, University of the Basque Country, 20018 Donostia-San Sebastian, Euskadi, Spain.
This paper addresses the author's current understanding of the physics of interactions in polymers under a voltage field excitation. The effect of a voltage field coupled with temperature to induce space charges and dipolar activity in dielectric materials can be measured by very sensitive electrometers. The resulting characterization methods, thermally stimulated depolarization (TSD) and thermal-windowing deconvolution (TWD), provide a powerful way to study local and cooperative relaxations in the amorphous state of matter that are, arguably, essential to understanding the glass transition, molecular motions in the rubbery and molten states and even the processes leading to crystallization.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!