The objective of the present study was to develop rectal mucoadhesive hydrogels loaded with Tolmetin Sodium, a non-steroidal anti-inflammatory drug, for prolonged duration of action and increased bioavailability. Fourteen formulae were prepared with different types and concentrations of polymers as hydroxypropylmethyl cellulose, hydroxylethyl cellulose, carboxymethyl cellulose and sodium alginate. Each formulation contain Tolmetin Sodium equivalent to 5% w/w active drug. The effect of the employed gel bases on pH, gel strength, mucoadhesion, viscosity and the in vitro release profile of drug was examined. In addition, hydrogel formulations were subjected to rheological and stability studies. The physicochemical characterization revealed that all hydrogels had a suitable pH (6.64-7.75) and gel strength (15.5-65.29 s) for rectal application. The in-vitro drug release from the formulations showed a controlled drug release pattern, reaching 72-92.6% after 8 h. The kinetic analysis of the release data revealed that the drug release from all tested hydrogel bases obeyed the diffusion mechanism. The degradation of Tolmetin Sodium from its rectal hydrogel formulations was found to be a zero-order reaction. All formulations except sodium alginate hydrogel were quite stable. Considering the in-vitro release, rheological properties and shelf life, (CMC; 2%w/w) hydrogel formula was the best among the studied formulations. Therefore, further histopathological and bioavailability studies were carried out to detect different pharmacokinetic parameters of the established formulations compared with commercially available capsules. Formula containing 2% CMC showed relative bioavailability 357.93%. Finally, good correlation was observed between in-vitro and in-vivo profile.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC6280843 | PMC |
http://dx.doi.org/10.1007/s40005-017-0365-1 | DOI Listing |
Luminescence
November 2024
Department of Pharmaceutical Analytical Chemistry, Faculty of Pharmacy, Tanta University, Tanta, Egypt.
A facile, low-cost, and rapid method was developed for spectrofluorometric determination of tolmetin (TOL) using highly fluorescent (QY = 35%) cerium and nitrogen codoped carbon dots (Ce-NCDs) sensing platform prepared by one-step hydrothermal method. Owing to the severe overlap between TOL absorption and Ce-NCDs excitation spectra around 320 nm, TOL could attenuate the emission of Ce-NCDs at 407 nm through primary inner filter effect (IFE). This concentration dependent attenuation was linear between 2 and 10 μg/mL (r = 0.
View Article and Find Full Text PDFJ Phys Chem C Nanomater Interfaces
May 2024
Université de Lorraine, CNRS, LCPME, F-54000 Nancy, France.
An aqueous colloidal suspension of gold nanoparticles (AuNPs) may be condensed into a thin fractal film at the polarizable liquid-liquid interface formed between two immiscible electrolyte solutions upon injection of millimolar concentrations of sodium chloride to the aqueous phase. By adjusting the interfacial polarization conditions (negative, intermediate, and positive open-circuit potentials), the morphology of the film is modified, resulting in unique surface plasmon properties of the film, which enable in situ surface-enhanced Raman spectroscopy (SERS). Intense SERS signals are observed at the polarizable liquid-liquid interface when micromolar concentrations of tolmetin, a nonsteroidal anti-inflammatory drug, are entrapped in the AuNP fractal film.
View Article and Find Full Text PDFWorld J Clin Cases
April 2024
College of Medicine, Jingchu University of Technology Jingmen, Jingmen 448000, Hubei Province, China.
Background: Various non-steroidal anti-inflammatory drugs (NSAIDs) have been used for juvenile idiopathic arthritis (JIA). However, the optimal method for JIA has not yet been developed.
Aim: To perform a systematic review and network meta-analysis to determine the optimal instructions.
J Chromatogr A
June 2024
Department of Analytical Chemistry, Faculty of Chemistry, University of Mazandaran, Babolsar, Iran.
This work, reports the successful preparation a thin film by a simple and inexpensive process for quantification of a model analytes in the urine sample using HPLC-UV. To this end, cellulose paper was employed as a substrate for the in-situ synthesis of MOF-5, to increase the resistance of the prepared film. The prepared film can be reused 26 times with no reduction in its performance.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!