Objective: To measure the energy content of frequently ordered meals from full service and fast food restaurants in five countries and compare values with US data.
Design: Cross sectional survey.
Setting: 223 meals from 111 randomly selected full service and fast food restaurants serving popular cuisines in Brazil, China, Finland, Ghana, and India were the primary sampling unit; 10 meals from five worksite canteens were also studied in Finland. The observational unit was frequently ordered meals in selected restaurants.
Main Outcome Measure: Meal energy content, measured by bomb calorimetry.
Results: Compared with the US, weighted mean energy of restaurant meals was lower only in China (719 (95% confidence interval 646 to 799) kcal versus 1088 (1002 to 1181) kcal; P<0.001). In analysis of variance models, fast food contained 33% less energy than full service meals (P<0.001). In Finland, worksite canteens provided 25% less energy than full service and fast food restaurants (mean 880 (SD 156) versus 1166 (298); P=0.009). Country, restaurant type, number of meal components, and meal weight predicted meal energy in a factorial analysis of variance (R=0.62, P<0.001). Ninety four per cent of full service meals and 72% of fast food meals contained at least 600 kcal. Modeling indicated that, except in China, consuming current servings of a full service and a fast food meal daily would supply between 70% and 120% of the daily energy requirements for a sedentary woman, without additional meals, drinks, snacks, appetizers, or desserts.
Conclusion: Very high dietary energy content of both full service and fast food restaurant meals is a widespread phenomenon that is probably supporting global obesity and provides a valid intervention target.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC6290458 | PMC |
http://dx.doi.org/10.1136/bmj.k4864 | DOI Listing |
Sci Rep
December 2024
School of architecture, Ocean and energy power engineering, Wuhan University of Technology, Wuhan, 430070, China.
During maritime operations, extreme events such as explosions, grounding, and seal failures can cause water ingress into lubricant compartments, forming oil-water emulsions that significantly affect the lubrication performance of ship stern bearings. Existing studies mainly focus on low water content, with limited exploration of the impact of high water content on lubrication performance. To address this gap, viscosity measurements of oil-water mixtures were conducted, and an emulsification viscosity equation applicable to varying water contents was derived.
View Article and Find Full Text PDFSci Rep
December 2024
College of Chemistry and Chemical Engineering, Southwest Petroleum University, Chengdu, 610500, China.
A cost-effective industrial TiOSO solution was employed to fabricate visible light active sulfur-doped titanium dioxide (S-TiO) via a facile hydrothermal method. The effect of calcination temperature on morphology, particle size, crystallinity, and photocatalytic property of S-TiO was systematically investigated. Successful incorporation of sulfur into TiO was confirmed by carbon-sulfur analysis, X-ray photoelectron spectroscopy (XPS), and Energy dispersive spectrometer (EDS).
View Article and Find Full Text PDFJ Colloid Interface Sci
December 2024
Institute for Frontier Materials, Deakin University, Geelong VIC 3216, Australia. Electronic address:
Hypothesis: Optimizing interfacial positioning of crosslinkers within a reactive self-assembled hexagonal lyotropic liquid crystals (HLLC) system could assist in retaining the hexagonal structure during polymerization and thereby improving water filtration performances of the as-synthesized nanofiltration membranes.
Experiments: The positioning of the hydrophilic crosslinker, poly (ethylene glycol) diacrylate (PEGDA), within the reactive HLLC system was systematically investigated using H and C solid nuclear magnetic resonance (NMR) and small angle X-ray scattering (SAXS) techniques. The structural variation and water filtration performances of these HLLC systems with/without crosslinkers after polymerization were further studied using grazing incidence SAXS (GISAXS) and crossflow filtration tests, respectively.
ACS Appl Mater Interfaces
December 2024
TCS Research, Sahyadri Park 2, Rajiv Gandhi Infotech Park, Hinjewadi Phase 3, Pune 411057, India.
Realization of a sustainable hydrogen economy in the future requires the development of efficient and cost-effective catalysts for its production at scale. MXenes (MX) are a class of 2D materials with 'n' layers of carbon or nitrogen (X) interleaved by 'n+1' layers of transition metal (M) and have emerged as promising materials for various applications including catalysts for hydrogen evolution reaction (HER). Their properties are intimately related to both their composition and their atomic structure.
View Article and Find Full Text PDFZh Nevrol Psikhiatr Im S S Korsakova
December 2024
Research Center of Neurology, Moscow, Russia.
Objective: To evaluate the relationship of diet and food components with the frequency of migraine attacks.
Material And Methods: Sixty patients (mean age 35.5±8.
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!