Factors influencing structural heat-induced structural relaxation of dissolved organic matter.

Ecotoxicol Environ Saf

Institute of Chemistry and Technology of Environmental Protection, Faculty of Chemistry, Brno University of Technology, Purkyňova 118, 61200 Brno, Czech Republic. Electronic address:

Published: January 2019

Physical and chemical structure affect properties of dissolved organic matter (DOM). Recent observations revealed that heating and cooling cycles at higher temperature amplitude lead to a change in DOM physical conformation assumingly followed by a slow structural relaxation. In this study, changes at lower temperature amplitudes and their relation to DOM composition were investigated using simultaneous measurements of density and ultrasonic velocity in order to evaluate the adiabatic compressibility, which is sensitive indicator of DOM structural microelasticity. Six fulvic acids (FAs) having various origins were analyzed at concentrations of 0.12, 0.6 and 1.2 g L and at different temperature amplitudes. First, we validated that the used technique is sensitive to distinguish conclusively the structural changes upon heating and cooling of DOM with heating/cooling amplitude of ± 3 °C and higher. This amplitude was then applied to observe the relationship between change in adiabatic compressibility and chemical composition of FA. No correlation was observed with elemental composition and aromatic structures. Positive correlations were observed with content of alkyl moieties, carboxylic and carbonyl carbons and biological activity. Based on literature data, it was concluded that alkyl moieties undergo (re)crystalization during thermal fluctuation and their structural relaxation back is very slow (if occurs). The polar moieties form a flexible hydrogel responding to thermal fluctuation by moderate dissolution and re-aggregation. Negative correlation was observed in relation to the amount of peptide and O-alkyl systems, which can be attributed to very fast structural relaxation of proteinaceous materials, i.e. their larger content leads to lower difference between original and heat-induced compressibility. Last, the increase of the heating/cooling amplitude from ± 3 to ± 15 °C resulted in an increase of the change of the adiabatic compressibility and in the extension of the relaxation time needed for DOM structure to return to the equilibrium. We conclude that this increase is caused by the increase in inner energy, and DOM conformation can reach a cascade of energy minima, which may influence DOM reactivity and biodegradability.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.ecoenv.2018.10.050DOI Listing

Publication Analysis

Top Keywords

structural relaxation
16
adiabatic compressibility
12
dissolved organic
8
organic matter
8
dom
8
heating cooling
8
temperature amplitudes
8
heating/cooling amplitude
8
change adiabatic
8
correlation observed
8

Similar Publications

Osteoarthritis (OA) is heterogeneous and involves structural changes in the whole joint, such as cartilage, meniscus/labrum, ligaments, and tendons, mainly with short T2 relaxation times. Detecting OA before the onset of irreversible changes is crucial for early proactive management and limit growing disease burden. The more recent advanced quantitative imaging techniques and deep learning (DL) algorithms in musculoskeletal imaging have shown great potential for visualizing "pre-OA.

View Article and Find Full Text PDF

Analysis of the internal motions of thermoresponsive polymers and single chain nanoparticles.

Soft Matter

January 2025

Department of Macromolecular Science and Engineering, Case Western Reserve University, 10900 Euclid Ave., Cleveland, OH 44122, USA.

Data-driven techniques, such as proper orthogonal decomposition (POD) and uniform manifold approximation & projection (UMAP), are powerful methods for understanding polymer behavior in complex systems that extend beyond ideal conditions. They are based on the principle that low-dimensional behaviors are often embedded within the structure and dynamics of complex systems. Here, the internal motions of a thermoresponsive, LCST polymer are investigated for two cases: (1) the coil-to-globule transition that occurs as the system is heated above its critical temperature and (2) intramolecularly crosslinked, single chain nanoparticles (SCNPs) both above and below the critical temperature ().

View Article and Find Full Text PDF

Rubbers prepared from technical poly(butadiene) and natural poly(isoprene) are studied by field-cycling (FC) H NMR relaxometry to elucidate the changes of the relaxation spectrum. Starting with the non-cross-linked polymer successively cross-links are introduced via sulfur or peroxide vulcanization. Applying an advanced home-built relaxometer allows one to probe entanglement dynamics in addition to Rouse dynamics.

View Article and Find Full Text PDF

Probing the Design Rules for Optimizing Electron Spin Relaxation in Densely Packed Triplet Media for Quantum Applications.

ACS Mater Lett

January 2025

Department of Materials and London Centre for Nanotechnology, Imperial College London, South Kensington Campus, Exhibition Road, SW7 2AZ London, United Kingdom.

Quantum technologies using electron spins have the advantage of employing chemical qubit media with tunable properties. The principal objective of material engineers is to enhance photoexcited spin yields and quantum spin relaxation. In this study, we demonstrate a facile synthetic approach to control spin properties in charge-transfer cocrystals consisting of 1,2,4,5-tetracyanobenzene (TCNB) and acetylated anthracene.

View Article and Find Full Text PDF

Stepwise Structural Relaxation in Battery Active Materials.

ACS Mater Lett

January 2025

Centre for Materials Science and Nanotechnology, Department of Chemistry, University of Oslo, PO Box 1033, Blindern 0315 Norway.

Whenever the cycling of Li-ion batteries is stopped, the electrode materials undergo a relaxation process, but the structural changes that occur during relaxation are not well-understood. We have used operando synchrotron X-ray diffraction with a time resolution of 1.24 s to observe the structural changes that occur when the lithiation of graphite and LiFePO electrodes are interrupted.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!