ISO 4387 Standard determines the main aerosol constituents (total particulate matter, water, nicotine, and nicotine-free-dry-particulate matter, referred to as "tar") in cigarette mainstream smoke (ISO, 2000). Heated Tobacco Products (also called Tobacco Heating Products or Heat-not-Burn Products) are designed to form aerosol by heating tobacco rather than burning like in combustible cigarettes. In this study we have evaluated the suitability of ISO 4387 Standard to be adapted for quantifying main aerosol constituents for HTP aerosol. HTP emissions have much higher levels of water and humectants (e.g., glycerol) in dynamic equilibria between gaseous and particulate phases. Several modifications to ISO 4387 Standard on aerosol collection were tested to improve the accuracy and reliability of aerosol capturing, with minimal deviation to the standard method. The proposed modifications are readily adoptable by laboratories already practicing the Standard for cigarette smoke analyses. Taking collectively with other available aerosol chemistry and biological results on HTPs in the literature, they show a fundamentally different aerosol in HTPs and call for category-specific product standards and terminology.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.yrtph.2018.09.016DOI Listing

Publication Analysis

Top Keywords

main aerosol
12
aerosol constituents
12
iso 4387
12
4387 standard
12
aerosol
10
heated tobacco
8
tobacco products
8
fundamentally aerosol
8
standard
5
accurate measurement
4

Similar Publications

By 2050, the U.S. plans to increase solar energy from 3% to 45% of the nation's electricity generation.

View Article and Find Full Text PDF
Article Synopsis
  • Fungal contamination in hospital air can impact the health of staff, patients, and caregivers, with a study in Wuhan revealing that factors like temperature, humidity, and seasonal changes significantly influence fungal concentration rather than disease type or personnel density.
  • The analysis showed that airborne fungal particle sizes are normally distributed, with the highest proportions found in specific size ranges, but the median diameter remained below 3.19 μm across different departments in both winter and summer.
  • The findings suggest a need for improved filtration efficiency for specific fungal particle sizes and the use of appropriate antifungal treatments and hygiene practices in hospital air management.
View Article and Find Full Text PDF

Component analysis and source identification of atmospheric aerosols at the neighborhood scale in a coastal industrial city in China.

Environ Pollut

December 2024

State Key Laboratory of Atmospheric Boundary Layer Physics and Atmospheric Chemistry, Institute of Atmospheric Physics, Chinese Academy of Sciences, Beijing, 100029, China; College of Earth and Planetary Sciences, University of Chinese Academy of Sciences, Beijing, 100049, China.

A multiple-site filter-sampling observation study was conducted in a coastal industrial city (Rizhao, 35°10'59″N, 119°23'57″E) to understand the main components, formation mechanisms, and potential sources of particulate matter. The average (±σ) mass concentration of PM across all the sites was 42 (±27) μg/m, with high variability (6-202 μg/m). Water-soluble inorganic ions (WSIIs) were the major contributors (54%-60%) to PM with mean values for sulfate (13 μg/m), nitrate (6 μg/m), and ammonium (7 μg/m) (SNA).

View Article and Find Full Text PDF

The COVID-19 pandemic has resulted in significant changes in our daily lives, including the widespread use of face masks. Face masks have been reported to reduce the transmission of viral infections by droplets; however, improper use and/or treatment of these masks can cause them to be contaminated, thereby reducing their efficacy. Moreover, regular replacement of face masks is essential to maintaining their effectiveness, which can be challenging in resource-limited healthcare settings.

View Article and Find Full Text PDF

This work introduces CAECENET, a new system capable of automatically retrieving columnar and vertically-resolved aerosol properties running the GRASP (Generalized Retrieval of Atmosphere and Surface Properties) algorithm using sun-sky photometer (aerosol optical depth, AOD; and sky radiance measurements) and ceilometer (range corrected signal; RCS) data as input. This method, so called GRASPpac, is implemented in CAECENET, which assimilates sun-sky photometers data from CÆLIS database and ceilometer data from ICENET database (Iberian Ceilometer Network). CAECENET allows for continuous and near-real-time monitoring of both vertical and columnar aerosol properties.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!