Statistical iterative reconstruction (SIR) using multidetector computed tomography (MDCT) is a promising alternative to standard filtered back projection (FBP), because of lower noise generation while maintaining image quality. Hence, we investigated the feasibility of SIR in predicting MDCT-based bone mineral density (BMD) and vertebral bone strength from finite element (FE) analysis. The BMD and FE-predicted bone strength derived from MDCT images reconstructed using standard FBP (FFBP) and SIR with (FSIR) and without regularization (FSIRB0) were validated against experimental failure loads (Fexp). Statistical iterative reconstruction produced the best quality images with regard to noise, signal-to-noise ratio, and contrast-to-noise ratio. Fexp significantly correlated with FFBP, FSIR, and FSIRB0. FFBP had a significant correlation with FSIRB0 and FSIR. The BMD derived from FBP, SIRB0, and SIR were significantly correlated. Effects of regularization should be further investigated with FE and BMD analysis to allow for an optimal iterative reconstruction algorithm to be implemented in an in vivo scenario.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1097/RCT.0000000000000788 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Functional Hydrogel Interfaces for Cartilage and Bone Regeneration.
Adv Healthc Mater
January 2025
School of Environmental and Biological Engineering, Nanjing University of Science and Technology, Nanjing, 210094, China.
Effective treatment of bone diseases is quite tricky due to the unique nature of bone tissue and the complexity of the bone repair process. In combination with biological materials, cells and biological factors can provide a highly effective and safe treatment strategy for bone repair and regeneration, especially based on these multifunctional hydrogel interface materials. However, itis still a challenge to formulate hydrogel materials with fascinating properties (e.
View Article and Find Full Text PDFGenerating Virtual Bone Scans for the Purpose of Investigating the Effects of Cortical Microstructure.
J Biomech Eng
January 2025
Dr. Carl D. and H. Jane Clay Department of Mechanical Engineering, Ohio Northern University, 525 S. Main St, Ada OH 45810.
Evaluating the contribution of microstructure to overall bone strength is tricky since it is difficult to control changes to pore structure in human or animal samples. We developed an open-source program that can generate three-dimensional models of micron-scale cortical bone. These models can be highly customized with a wide array of variable input parameters to allow for generation of samples with high similarity to CT scans of cortical bone or with specific geometric features.
View Article and Find Full Text PDFTibial Skeletal Adaptations in Male and Female Marine Corps Officer Candidates Undergoing 10 Weeks of Military Training.
Calcif Tissue Int
January 2025
Neuromuscular Research Laboratory/Warrior Human Performance Research Center, Department of Sports Medicine and Nutrition, University of Pittsburgh, 3860 S. Water St, Pittsburgh, PA, 15203, USA.
Military training improves tibial density, structure, and estimated strength; however, men and women may adapt differently. Most work performed in military populations has assessed changes in bone health during initial entry programs, a timeframe at the beginning of a service member's career when bones may be more adaptable to a novel mechanical stimulus. The purpose of this investigation was to examine changes in tibial volumetric bone mineral density (vBMD), structure, and estimated strength, and biomarkers of bone metabolism (P1NP, osteocalcin, TRAP5b, sclerostin) between male and female candidates measured at the start and end of United States Marine Corps Officer Candidates School (OCS), a 10-week military training program attended by older service members (~ 25 y/o) who may have previous military experience.
View Article and Find Full Text PDFFinite element investigation for improving chest wall reconstruction process using ceramic and polymeric implants.
Sci Rep
January 2025
Biomedical Engineering Department, Faculty of Engineering, Helwan University, Cairo, Egypt.
Car accidents, infections caused by bacteria or viruses, metastatic lesions, tumors, and malignancies are the most frequent causes of chest wall damage, leading to the removal of the affected area. After excision, artificial bone or synthetic materials are used in chest wall reconstruction to restore the skeletal structure of the chest. Chest implants have traditionally been made from metallic materials like titanium alloys due to their biocompatibility and durability.
View Article and Find Full Text PDFMechanisms of Ferroptosis in bone disease: A new target for osteoporosis treatment.
Cell Signal
January 2025
Tianjin Hospital of Tianjin University (Tianjin Hospital), Tianjin 300211, China; Tianjin Orthopedic Institute, Tianjin 300050, China; Tianjin Key Laboratory of Orthopedic Biomechanics and Medical Engineering, Tianjin 300050, China. Electronic address:
Osteoporosis (OP) is a common disease in the elderly, characterized by decreased bone strength, reduced bone density, and increased fracture risk. There are two clinical types of osteoporosis: primary osteoporosis and secondary osteoporosis. The most common form is postmenopausal osteoporosis, which is caused by decreased estrogen production after menopause.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!