Removal of acetone from air emissions by biotrickling filters: providing solutions from laboratory to full-scale.

J Environ Sci Health A Tox Hazard Subst Environ Eng

a Research Group GI2AM, Department of Chemical Engineering , Universitat de València, Burjassot , Spain.

Published: August 2019

A full-scale biotrickling filter (BTF) treating acetone air emissions of wood-coating activities showed difficulties to achieve outlet concentrations lower than 125 mg C m, especially for high inlet concentrations and oscillating emissions. To solve this problem, a laboratory investigation on acetone removal was carried out simulating typical industrial conditions: discontinuous and variable inlet concentrations and intermittent spraying. The results were evaluated in terms of removal efficiency and outlet gas emission pattern. Industrial emissions and operational protocols were simulated: inlet load up to 70 g C m h during 2 cycles of 4 h per day and intermittent trickling of 15 min per hour. The outlet gas stream of the pollutant was affected by intermittent spraying, causing a fugitive emission of pollutant. Complete removal efficiency was obtained during non-spraying. Average removal efficiencies higher than 85% were obtained, showing the feasibility of BTF to treat acetone. The outlet gas stream showed a clear dependence on the pH of the trickling liquid, decreasing the removal at pH < 5.5. Thus, a proper control of alkalinity, with regular NaHCO addition, was required for successful operation. The laboratory findings were fruitfully transferred to the industry, and the removal of acetone by full-scale BTF was improved.

Download full-text PDF

Source
http://dx.doi.org/10.1080/10934529.2018.1496552DOI Listing

Publication Analysis

Top Keywords

outlet gas
12
acetone air
8
air emissions
8
inlet concentrations
8
intermittent spraying
8
removal efficiency
8
gas stream
8
removal
6
removal acetone
4
emissions
4

Similar Publications

Using an acid to stimulate a heterogeneous carbonate reservoir during matrix acidizing may lead to over-treating the high permeability zones, leaving low permeability zones untreated. This is particularly exacerbated in long horizontal sections, necessitating the use of acid diverters for effective acid distribution across the formation. In previous studies, conventional core flooding systems were utilized where single inlet and outlet lines were used or, at best, two outlet lines for dual-core flooding.

View Article and Find Full Text PDF

Computational exploration of injection strategies for improving medicine distribution in the liver.

Comput Biol Med

December 2024

Faculty of Chemical & Petroleum Engineering, University of Tabriz, Tabriz, Iran. Electronic address:

Background And Objectives: The liver, a vital metabolic organ, is always susceptible to various diseases that ultimately lead to fibrosis, cirrhosis, acute liver failure, chronic liver failure, and even cancer. Optimal and specific medicine delivery in various diseases, hepatectomy, shunt placement, and other surgical interventions to reduce liver damage, transplantation, optimal preservation, and revival of the donated organ all rely on a complete understanding of perfusion and mass transfer in the liver. This study aims to simulate the computational fluid dynamics of perfusion and the temporal-spatial distribution of a medicine in a healthy liver to evaluate the hemodynamic characteristics of flow and medicine transport with the purpose of more effective liver treatment.

View Article and Find Full Text PDF

Electrochemical carbon dioxide (CO) reduction from aqueous solutions offers a promising strategy to overcome flooding and salt precipitation in gas diffusion electrodes used in gas-phase CO electrolysis. However, liquid-phase CO electrolysis often exhibits low CO reduction rates because of limited CO availability. Here, a macroporous Ag mesh is employed and activated to achieve selective CO conversion to CO with high rates from an aqueous bicarbonate solution.

View Article and Find Full Text PDF

Simulation and experimental study of local high frequency resistance distribution in proton exchange membrane fuel cells under steady and dynamic conditions.

Heliyon

December 2024

Fuel Cell System and Engineering Laboratory, Key Laboratory of Fuel Cells & Hybrid Power Sources, Dalian Institute of Chemical Physics, Chinese Academy of Sciences, Dalian, Liaoning, 116023, China.

Proton-exchange membrane (PEM) dry-wet variation during PEM fuel cell (PEMFC) operation markedly affects PEMFC lifespan. Therefore, deeper insights into the mechanical degradation mechanism of PEM require analysis of the membrane dry-wet change process. The stress changes caused by PEM dry-wet variations may induce mechanical failure.

View Article and Find Full Text PDF

Performance and Emission Characteristics of a Small Gas Turbine Engine Using Hexanol as a Biomass-Derived Fuel.

Materials (Basel)

December 2024

Centre of Heat and Power Engineering, Institute of Fluid Flow Machinery, Polish Academy of Sciences, 80-231 Gdańsk, Poland.

The global transition to renewable energy has amplified the need for sustainable aviation fuels. This study investigates hexanol, a biomass-derived alcohol, as an alternative fuel for small-scale gas turbines. Experimental trials were conducted on a JETPOL GTM-160 turbine, assessing blends of 25% (He25) and 50% (He50) hexanol with kerosene (JET A) under rotational velocities ranging from 40,000 to 110,000 RPM.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!