We propose and demonstrate a method to perform quantitative phase-sensitive optical time domain reflectometry (Φ-OTDR) using multimode fiber. While most Φ-OTDR sensors use single-mode fiber, multimode fiber exhibits higher thresholds for non-linear effects, a larger capture fraction of Rayleigh backscattered light, and the potential to avoid signal fading by detecting many spatial modes in parallel. Previous multimode fiber based OTDR sensors discarded most of the backscattered light and thus failed to take advantage of these noise-reducing factors. Here, we show that by performing off-axis holography with a high-speed camera, we can record the entire Rayleigh backscattered field, maximizing the detected light level and making the sensor immune to fading. The sensor exhibits a high degree of linearity, a minimum phase noise of -80 dB [rel. rad/Hz], and 20 kHz bandwidth.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1364/OE.26.023019 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Optical semantic communication through multimode fiber: from symbol transmission to sentiment analysis.
Light Sci Appl
January 2025
Wuhan National Laboratory for Optoelectronics, Next Generation Internet Access National Engineering Laboratory, and Hubei Optics Valley Laboratory, School of Optical and Electronic Information, Huazhong University of Science and Technology, Wuhan, 430074, China.
We propose and validate a novel optical semantic transmission scheme using multimode fiber (MMF). By leveraging the frequency sensitivity of intermodal dispersion in MMFs, we achieve high-dimensional semantic encoding and decoding in the frequency domain. Our system maps symbols to 128 distinct frequencies spaced at 600 kHz intervals, demonstrating a seven-fold increase in capacity compared to conventional communication encoding.
View Article and Find Full Text PDFSpectrally encoded flow cytometry using few-mode fiber collection.
Biomed Opt Express
January 2025
Faculty of Biomedical Engineering, Technion-Israel Institute of Technology, Haifa 3200003, Israel.
In fiber-based confocal microscopy, using two separate fibers for illumination and collection enables the use of a few-mode fiber to achieve an effect similar to opening the pinhole in a conventional confocal microscope. In some Fourier-domain applications, however, or when a spectral measurement is involved, the coherent light detection would lead to noticeable spectral modulation artifacts that result from differential mode delay, an effect caused by the multimode propagation in the collection fiber. After eliminating these artifacts by using mode-dependent polarization control, we demonstrate effective spectrally encoded imaging with improved signal efficiency and lower speckle noise, and only a minor, negligible reduction in lateral and axial resolutions.
View Article and Find Full Text PDFA novel, to the best of our knowledge, approach for the modal decomposition of a fiber laser beam is demonstrated using a spatial mode multiplexer. Since the modal decomposition is carried out optically, this approach is able to obtain the modal content at speeds up to the GHz level. In order to demonstrate such performance, we have applied this approach to the modal analysis of a -switched pulse generated in a multimode fiber with alternating intra-pulse mode content.
View Article and Find Full Text PDFFree space optical communication (FSOC) technology can be used for data transmission between ocean islands as backup wireless communication networks to cope with traffic surges and emergencies. In this paper, we experimentally demonstrate the results of a 24-h real-time single-wavelength 2.5-Gbps FSOC between two islands 29 km apart at a low altitude with low complexity.
View Article and Find Full Text PDFPolarization-resolved transmission matrices of specialty optical fibers.
Rev Sci Instrum
December 2024
OFS Laboratories, 19 Schoolhouse Road, Somerset, New Jersey 08873, USA.
Transmission matrix measurements of multimode fibers are now routinely performed in numerous laboratories, enabling control of the electric field at the distal end of the fiber and paving the way for the potential application to ultrathin medical endoscopes with high resolution. The same concepts are applicable to other areas, such as space division multiplexing, targeted power delivery, fiber laser performance, and the general study of the mode coupling properties of the fiber. However, the process of building an experimental setup and developing the supporting code to measure the fiber's transmission matrix remains challenging and time consuming, with full details on experimental design, data collection, and supporting algorithms spread over multiple papers or lacking in detail.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!