TiNbO (TNO) has been regarded as a promising anode material for high-power lithium-ion batteries because of the high theoretical capacity and rate performance within the operation voltage range of 1.0-3.0 V. Herein, the electrochemical performance and interface evolution of TNO are comprehensively investigated by scanning electron microscopy, high-resolution transmission electron microscopy, X-ray photoelectron spectroscopy, and Fourier transform infrared spectroscopy. The prepared TNO shows a high initial reversible capacity of 256 mA h g and a satisfactory capacity retention of 68.4% after 200 cycles at 0.1 C. It is generally believed that the formation of solid electrolyte interface (SEI) film could be avoided at the high operating voltage beyond 1.0 V. However, we find that the thin SEI layer is formed during the lithium insertion process and partially dissolved during the following lithium extraction process, and subsequently the SEI layer increases gradually during long-term cycles. Most importantly, we find obvious gassing behavior in the TNO/LiFePO pouch cell for the first time and demonstrate effective suppression effects of VC additive on the swelling phenomenon of full batteries.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1021/acsami.8b08425 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Temperature-Dependent Formation of Carbon Nanodomains in Silicon Oxycarbide Glass-A Reactive Force Field MD Study.
J Phys Chem C Nanomater Interfaces
January 2025
Institute of General, Inorganic and Theoretical Chemistry Center for Chemistry and Biomedicine, University of Innsbruck, Innrain 80-82, A-6020 Innsbruck, Austria.
Novel anode materials for lithium-ion batteries (LIBs) are constantly being explored to further improve battery performance. In this work, ReaxFF molecular dynamics (MD) simulations are performed to model the early stages in the synthesis of nanostructured silicon carbide (SiC), which is one such promising material. The focus lies on its precursor, silicon oxycarbide glass of composition (SiOC) (17 mol% Si, 28 mol% O, and 54 mol% C), in the following referred to as SiOC.
View Article and Find Full Text PDFElectrolyte design weakens lithium-ion solvation for a fast-charging and long-cycling Si anode.
Chem Sci
January 2025
School of Materials and Energy, University of Electronic Science and Technology of China Chengdu 611731 China
Silicon (Si) is considered a promising anode material for next-generation lithium-ion batteries due to its high theoretical specific capacity and earth-abundancy. However, challenges such as significant volume expansion, unstable solid electrolyte interphase (SEI) formation in incompatible electrolytes, and slow lithium-ion transport lead to its poor cycling and rate performance. In this work, it is demonstrated that superior cyclability and rate capability of Si anodes can be achieved using ethyl fluoroacetate (EFA) and fluoroethylene carbonate (FEC) solvents with low binding energy with Li but with sufficiently high relative dielectric constants.
View Article and Find Full Text PDFEnhanced ALD Nucleation on Polymeric Separator for Improved Li-S Batteries.
ACS Appl Mater Interfaces
January 2025
Department of Chemical Engineering, Stanford University, Stanford, California 94305, United States.
Lithium-sulfur (Li-S) batteries, with their superior energy densities, are emerging as promising successors to conventional lithium-ion batteries. However, their widespread adoption is hindered by challenges such as the shuttle effect of polysulfides, which affects discharge capacity and cycling stability. This study explores the transformative potential of atomic layer deposition (ALD) of AlO on commercial PP/PE/PP separators (Celgard), combined with the use of UV ozone exposure to enhance ALD nucleation on the separator surface, to address these challenges.
View Article and Find Full Text PDFPt ( = 1, 3, and 4) Cluster-Modified MoSe Nanosheets: A Potential Sensing and Scavenging Candidate for Lithium-Ion Battery State Characteristic Gases.
Langmuir
January 2025
State Key Laboratory of Power Transmission Equipment Technology, School of Electrical Engineering, Chongqing University, Chongqing 400044, China.
Realizing reliable online detection of characteristic gases (H, CH, CO, and CO) in lithium-ion batteries is crucial to maintain the safe and stable operation of power equipment and new energy storage power plants. In this study, transition metal Pt ( = 1, 3, and 4) clusters are attached to MoSe nanosheets for the first time based on density functional theory using the perfect crystalline facet modification method, and the adsorption characteristics and electronic behaviors of H, CH, CO, and CO are investigated and enhanced. The results show that Pt ( = 1, 3, and 4) is reliably chemically connected to the substrate without any significant deformation of the geometry.
View Article and Find Full Text PDFRational Electrolyte Design for Elevated-Temperature and Thermally Stable Lithium-Ion Batteries with Nickel-Rich Cathodes.
ACS Appl Mater Interfaces
January 2025
Energy and Environment Directorate, Pacific Northwest National Laboratory, Richland, Washington 99354, United States.
As the energy density of lithium-ion batteries (LIBs) increases, the shortened cycle life and the increased safety hazards of LIBs are drawing increasing concerns. To address such challenges, a series of localized high-concentration electrolytes (LHCEs) based on a solvating-solvent mixture of tetramethylene sulfone and trimethyl phosphate and a high flash-point diluent 1H,1H,5H-octafluoropentyl 1,1,2,2-tetrafluoroethyl ether were designed. The LHCEs exhibited nonflammability and greatly suppressed heat release at elevated temperatures, which would potentially improve the safety performance of the LIBs.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!