The draining of a dam is a relatively rare event, however, it can have severe consequences for a watercourse connected to that reservoir. In order to understand the effects of the draining on the mobility of pollutants stored in the bottom sediments, the concentrations of heavy metals and arsenic were measured in pore water, river water, and sediments sampled from three emptied reservoirs in Germany. Two of these sites were analyzed immediately after the draining, while the third reservoir was studied one and a half years after the complete discharge of the stored water. Heavy metal and arsenic concentrations within the sediments varied among the studied dams as a result of different geological characteristics and the degree of anthropogenic impacts. Based on the analysis of pore water samples, the concentrations of heavy metals and arsenic were not significantly altered shortly after the draining. However, increased concentrations of As, Fe, Cd, Ni, and Zn were measured in pore water samples after a longer duration of sediment exposure, which altered the redox conditions and sediment properties. The changes in Cu, Cr, Mn, and Pb concentrations in pore water samples were less pronounced. As a result of the pore water drainage increased dissolved heavy metal concentrations were found in the discharge water immediately after draining. At the third site, which had been emptied for one and a half years, only for Mn, a concentration increase was detected in the reservoir discharge water, which emphasizes the strong temporal dynamic of the mobilization of the analyzed elements.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.scitotenv.2018.05.295DOI Listing

Publication Analysis

Top Keywords

pore water
20
heavy metals
12
metals arsenic
12
water samples
12
water
10
draining mobility
8
bottom sediments
8
studied dams
8
concentrations heavy
8
measured pore
8

Similar Publications

Biosorption of cobalt (II) from an aqueous solution over acid modified date seed biochar: an experimental and mass transfer studies.

Environ Sci Pollut Res Int

January 2025

Department of Chemical Engineering, Zakir Hussain College of Engineering and Technology, Aligarh Muslim University, Aligarh, 202002, Uttar Pradesh, India.

Water pollution because of the presence of heavy metals remains a serious worry. The present work demonstrates the exclusion of cobalt ion (or Co(II)) from water using novel and cost-effective biosorbents. Initially, the biosorbent was chemically modified using orthophosphoric acid and then subjected to calcination to result acid modified date seed biochar (AMDB).

View Article and Find Full Text PDF

This study aims to utilize secondary aluminum dross waste to synthesize Fe-Al layered double hydroxide (Fe-Al LDH) for efficient adsorption of arsenic from drinking water. The synthesis process was based on a multi-step hydrometallurgical approach, in which the aluminum content in the waste was first converted to sodium aluminate. This was followed by the transformation into Fe-Al LDH through a series of processes, including gelation, sol formation, simultaneous precipitation, and aging.

View Article and Find Full Text PDF

The conversion of water hyacinth into biochar offers a sustainable solution to mitigate its proliferation and enhances its potential as a soil amendment for agriculture. This study examined the physicochemical properties of water hyacinth biochar (WHBC) and its impact on soil fertility. Water hyacinth (Eichhornia crassipes) was pyrolyzed at 300 °C for 40 minute with restricted airflow (2-3 m/s), producing biochar with desirable properties and a yield of 44.

View Article and Find Full Text PDF

Historic copper mining left a legacy of metal-rich tailings resulting in ecological impacts along and within Torch Lake, an area of concern in the Keweenaw Peninsula, Michigan, USA. Given the toxicity of copper to invertebrates, this study assessed the influence of this legacy on present day nearshore aquatic and terrestrial ecosystems. We measured the metal (Co, Cu, Ni, Zn, Cd) and metalloid (As) concentrations in sediment, pore water, surface water, larval and adult insects, and two riparian spider taxa collected from Torch Lake and a nearby reference lake.

View Article and Find Full Text PDF

Porous polymers: structure, fabrication and application.

Mater Horiz

January 2025

Department of Precision Machinery and Precision Instrumentation, University of Science and Technology of China, Hefei, Anhui, 230027, China.

The porous polymer is a common and fascinating category within the vast family of porous materials. It offers valuable features such as sufficient raw materials, easy processability, controllable pore structures, and adjustable surface functionality by combining the inherent properties of both porous structures and polymers. These characteristics make it an effective choice for designing functional and advanced materials.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!