On the measurement of relaxation times of acoustic vibrations in metal nanowires.

Phys Chem Chem Phys

Department of Chemistry and Biochemistry, University of Notre Dame, Notre Dame, Indiana 46556, USA.

Published: July 2018

The mechanical resonances of metal nanostructures are strongly affected by their environment. In this paper the way the breathing modes of single metal nanowires are damped by liquids with different viscosities was studied by ultrafast pump-probe microscopy experiments. Both nanowires supported on a glass substrate and nanowires suspended over trenches were investigated. The measured quality factors for liquid damping for the suspended nanowires are in good agreement with continuum mechanics calculations for an inviscid fluid that assume continuity in stress and displacement at the nanowire-liquid interface. This shows that liquid damping is controlled by radiation of sound waves into the medium. For the nanowires on the glass surface the quality factors for liquid damping are approximately 60% higher than those for the suspended nanowires. This is attributed to a shadowing effect. The nanowires in our measurements have pentagonal cross-sections. This produces two different breathing modes and also means that one of the faces for the supported nanowires is blocked by the substrate, which reduces the amount of damping from the liquid. Comparing the supported and suspended nanowires also allows us to estimate the effect of the substrate on the acoustic mode damping. We find that the substrate has a weak effect, which is attributed to poor mechanical contact between the nanowires and the substrate.

Download full-text PDF

Source
http://dx.doi.org/10.1039/c8cp03230kDOI Listing

Publication Analysis

Top Keywords

liquid damping
12
suspended nanowires
12
nanowires
11
metal nanowires
8
breathing modes
8
quality factors
8
factors liquid
8
substrate
5
damping
5
measurement relaxation
4

Similar Publications

Cavity correlations and the onset of charge ordering at charged interfaces: A modified Poisson-Fermi approach.

J Chem Phys

January 2025

Instituto de Física, Universidade Federal de Ouro Preto, 35400-000 Ouro Preto, MG, Brazil.

Charge layering in the close vicinity of charged interfaces is a well-known effect, extensively reported in both experiments and simulations of Room Temperature Ionic Liquids (RTILs) and concentrated electrolytes. The traditional Poisson-Fermi (PF) theory is able to successfully describe overcrowding effects but fails to reproduce charge ordering even in strong coupling regimes. Simple models, yet capable of investigating the interplay between these important interfacial phenomena, are still lacking.

View Article and Find Full Text PDF

Effect of a Wrist Harmonic Liquid Tremor Absorber-Damping on the Upper Extremity Essential Tremor.

Mov Disord

January 2025

ALEA Neurotechnology Research and Development Company, Ankara, Türkiye.

Background: Essential tremor (ET) is a common type of tremor. Previous research has shown that wearable orthoses and biomechanical loading methods can suppress tremors.

Objective: This study aims to investigate the effect of a harmonic liquid dampener on upper extremity ET.

View Article and Find Full Text PDF

Crystallization and amorphization are important processes and different cooling rates cause these transitions. Obtaining pure metals from their molten state is a challenge unless these two are well understood. Here we study both these transitions in liquid Ti using molecular dynamics simulations wherein Ti is modeled with embedded atom potential.

View Article and Find Full Text PDF

The Shrinking Fermi Liquid Scenario for Cuprates Under the Scrutiny of Optical Conductivity Measurements.

Materials (Basel)

November 2024

Istituto dei Sistemi Complessi-Consiglio Nazionale delle Ricerche and Dipartimento di Fisica, Università di Roma Sapienza, Piazzale Aldo Moro 5, 00185 Roma, Italy.

In a recent paper [B. Michon et al., Nat.

View Article and Find Full Text PDF

Mechanical Behavior of Plasma-Treated Metal-Rubber Assemblies.

Molecules

November 2024

Institut des Molécules et Matériaux du Mans, IMMM, UMR CNRS n° 6283, Le Mans Université, Avenue Olivier Messiaen, 72085 Le Mans, France.

Metal-elastomer assemblies, such as aluminum-NBR and stainless steel-FKM, widely used for sealing or damping functions in various fields, are currently prepared with highly toxic bonding agents. To substitute the use of these liquids, plasma technologies were applied. The chemical nature of the plasma polymerized adhesives is found to have no influence on the viscoelastic properties of the elastomer.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!