Effects of different surface treatments on the cyclic fatigue strength of one-piece CAD/CAM zirconia implants.

Objectives: The effects of different surface treatments on cyclic fatigue strengths of computer-aided design and computer-aided manufacturing (CAD/CAM) zirconia implants and its mechanisms were evaluated.

Material And Methods: One-piece cylindrical screw-type zirconia (Y-TZP) implants with diameters of 4.1-mm were fabricated using CAD/CAM technique; they were divided into four groups according to the type of surface treatment: (i) sintering (control group, CTRL), (ii) sandblasting (SB), (iii) sandblasting and etching with an experimental hot etching solution (SB-ST), and (iv) sandblasting and etching with hydrofluoric acid (SB-HF). The surface morphology and roughness of the implants were evaluated. Tetragonal to monoclinic transformation was measured on the surface by micro Raman spectroscopy. Static and fatigue tests were carried out at room temperature following the ISO 14801:2014 Standard. The cyclic fatigue strength of each group was determined using the staircase method. Specimens that survived the fatigue test were statically loaded to measure the residual fracture strength.

Results: Among the four groups, SB-HF exhibited the highest surface roughness. Compared with the CTRL group, the surface monoclinic content was higher after all three types of surface treatments, amongst which, SB-HF had the highest content (39.14%), significantly more than the other three groups (P < 0.01). The cyclic fatigue strengths of CTRL, SB, SB-ST, and SB-HF implants were 530 N, 662.5 N, 705 N, and 555 N, respectively. The fracture strength after fatigue loading was higher than that before fatigue loading with no significant difference (P＞0.05).

Conclusions: SB and SB-ST remarkably enhanced the fatigue resistance of zirconia implants, while SB-HF did not. One-piece 4.1-mm diameter CAD/CAM zirconia implants have sufficient durability for application in dental implants.