The effect of thermal annealing on the luminescent and laser properties of high-germania-core silicate fibers doped with bismuth was investigated. We studied the behavior of optical absorption assigned to the bismuth-related active centers associated with germanium as well as the behavior of unsaturable absorption in annealed fibers with respect to the Bi content. The dependence of the increment of the active center content on the Bi concentration in the annealed fibers was obtained. We achieved laser oscillations near a wavelength of 1700 nm with a slope efficiency of 18% using a 8.5 m long Bi-doped fiber. The comparison of the output parameters of the laser based on an annealed Bi-doped fiber with the ones of a pristine Bi-doped fiber laser is given. The performance of the obtained bismuth-doped fiber lasers was modeled using the propagation and rate equations of a homogeneous quasi-two-level laser medium. Theoretical results are compared with experimental ones.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1364/OE.26.012363 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
In this Letter, we present an all-fiber bismuth (Bi)-doped germanosilicate fiber laser that is continuously tunable within the range of 1425-1475 nm, enabled by a tunable optical filter. A maximum output power of 86.4 mW was achieved at 1450 nm with a slope efficiency of 13.
View Article and Find Full Text PDFMulticore fibers are promising structures with specific light propagation properties, which can be managed to benefit several applications in optical communications, fiber lasers and amplifiers, high-resolution imaging, and fiber-based sensors. The current use of multicore fibers in laser technology is mainly focused on in-phase coherent beam combining in far-field regions (out-cavity) using bulk optical elements. However, this approach is challenging in terms of the power scalability of all-fiber lasers (intra-cavity), particularly with using low-gain media, where it is needed to provide mode-coupling (supermode propagation) stability along relatively long lengths.
View Article and Find Full Text PDFWe present a double-pass bismuth (Bi)-doped fiber amplifier (BDFA) providing high-gain wideband amplification from 1330 to 1480 nm. A peak gain of 38 dB with 4.7 dB noise figure (NF) was obtained at 1420 nm for a -23 dBm input signal, with >20 dB gain from 1335 to 1475 nm.
View Article and Find Full Text PDFIn this study, a Si defect structure was added into the silica network in order to activate the bismuth and silica structure active center. TD-DFT theoretical simulations show that the Bi and Si ODC(I) models can excite the active center of the E-band at 1408 nm. Additionally, the Bi-doped silica fiber (BDSF) with improved fluorescence was fabricated using atomic layer deposition (ALD) combined with the modified chemical vapor deposition (MCVD) technique.
View Article and Find Full Text PDFIn this Letter, we investigated the potential scalability of output power of a cladding-pumped laser and a power amplifier (booster) based on a multimode Bi-doped fiber (BDF) using the mode-selection approach. We fabricated the multimode double-clad graded-index (GRIN) fiber with a confined Bi-doped germanosilicate glass core with a diameter of ≈30 and ≈60 µm. Using femtosecond (fs) inscription technology with high spatial resolution, Bragg gratings of a special transverse structure allowing the selection of low-order modes were written into the core of BDFs.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!