Introduction: The aim of this study was to evaluate the behavior of a penalized-likelihood image reconstruction method (Q.Clear) under different count statistics and lesion-to-background ratios (LBR) on a BGO scanner, in order to obtain an optimum penalization factor (β value) to study and optimize for different acquisition protocols and clinical goals.

Methods: Both phantom and patient images were evaluated. Data from an image quality phantom were acquired using different Lesion-to-Background ratios and acquisition times. Then, each series of the phantom was reconstructed using β values between 50 and 500, at intervals of 50. Hot and cold contrasts were obtained, as well as background variability and contrast-to-noise ratio (CNR). Fifteen F-FDG patients (five brain scans and 10 torso acquisitions) were acquired and reconstructed using the same β values as in the phantom reconstructions. From each lesion in the torso acquisition, noise, contrast, and signal-to-noise ratio (SNR) were computed. Image quality was assessed by two different nuclear medicine physicians. Additionally, the behaviors of 12 different textural indices were studied over 20 different lesions.

Results: Q.Clear quantification and optimization in patient studies depends on the activity concentration as well as on the lesion size. In the studied range, an increase on β is translated in a decrease in lesion contrast and noise. The net product is an overall increase in the SNR, presenting a tendency to a steady value similar to the CNR in phantom data. As the activity concentration or the sphere size increase the optimal β increases, similar results are obtained from clinical data. From the subjective quality assessment, the optimal β value for torso scans is in a range between 300 and 400, and from 100 to 200 for brain scans. For the recommended torso β values, texture indices present coefficients of variation below 10%.

Conclusions: Our phantom and patients demonstrate that improvement of CNR and SNR of Q.Clear algorithm which depends on the studied conditions and the penalization factor. Using the Q.Clear reconstruction algorithm in a BGO scanner, a β value of 350 and 200 appears to be the optimal value for 18F-FDG oncology and brain PET/CT, respectively.

Download full-text PDF

Source
http://dx.doi.org/10.1002/mp.12986DOI Listing

Publication Analysis

Top Keywords

texture indices
8
penalized-likelihood image
8
image reconstruction
8
reconstruction method
8
method qclear
8
lesion-to-background ratios
8
bgo scanner
8
penalization factor
8
image quality
8
reconstructed values
8

Similar Publications

The coherent spin waves, magnons, can propagate without accompanying charge transports and Joule heat dissipation. Room-temperature and long-distance spin waves propagating within nanoscale spin channels are considered promising for integrated magnonic applications, but experimentally challenging. Here we report that long-distance propagation of chiral magnonic edge states can be achieved at room temperature in manganite thin films with long, antiferromagnetically coupled spin spirals (millimetre length) and low magnetic Gilbert damping (~3.

View Article and Find Full Text PDF

Herein, a novel nanocomposite was developed to adjust the textural properties of metal-organic frameworks (MOFs) for adsorptive applications. To this end, nitrogen-doped carbon quantum dots/reduced graphene oxide nanocomposite (RC) was embedded into MIL-101(Cr) crystals, named RC-ML-x nanocomposites. The prepared nanoadsorbents were thoroughly characterized by different techniques.

View Article and Find Full Text PDF

Normal human life expectancy has increased; hence, growing interest in the field of skin quality is observed. Peels are common medical devices that stimulate new skin growth and improve texture. Injectable hyaluronic acid (HA)-based products act by replacing fragmented collagen.

View Article and Find Full Text PDF

Technological properties of the furcellaran-whey protein isolate emulgels with various evening primrose oil concentration.

Int J Biol Macromol

December 2024

Department of Chemistry, Faculty of Food Technology, University of Agriculture, Balicka St. 122, PL-30-149 Cracow, Poland; Department of Product Packaging, Cracow University of Economics, Rakowicka 27, PL-31-510 Cracow, Poland. Electronic address:

Effect of different evening primrose oil content (1-20 %) on the rheological, mechanical, textural and microstructure of furcellaran/whey protein isolate emulsion gels were investigated at neutral, unmodified pH environment. The results indicate that, irrespective of the concentration, the oil acted as an inactive filler and was not chemically bound in the polymer network but only physically immobilized in it. The increasing oil amount in the material from 1 to 20 % resulted in a percentage decrease in hardness (52 %), gumminess (71 %) and stress relaxation ratio (17 %) which means that presence of the hydrophobic components weakens the structure of the material, but all samples exhibit elastic behaviour.

View Article and Find Full Text PDF

Phosphorus (P) plays an essential role for plant growth, but conventional P sources used in agriculture are finite and non-renewable. As a result, there is a growing need to explore alternative P sources such as sewage sludge (SS) - a P-rich solid waste and valuable renewable resource that is often mismanaged globally. Pyrolysis is a promising technique for managing SS.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!