Perfluorooctane sulfonate (PFOS) has been found in wastewater treatment plants (WWTPs) and in surface water as a result of domestic uses of textiles, electronics, and surfactants. The detection of PFOS in the aqueous environment has been linked to hazardous biological effects including estrogenicity and genotoxicity. To provide an alternative to conventional processes, one of the radical-based advanced oxidation and reduction processes being tested for treatment of refractory compounds in water, involves the use of an electron beam. Therefore, the aims of this study were to investigate the degradation efficiency of PFOS (100mg/L) by electron beam, to evaluate the predicted toxicity of the radiolysis products using the ECOSAR model, and to identify the radiolytic products of PFOS. As a result of using the ECOSAR model, the toxicity levels of by-products after electron beam treatment were reduced by decreasing the carbon-chain number of PFOS. The molecular structures of the radiolytic products were elucidated using authentic standards via liquid chromatography and tandem mass spectrometry, and by the interpretation of MS fragmentation patterns of each product using liquid chromatography with quadrupole time of-flight mass spectrometry (LC-QTOF-MS). In total, ten radiolytic products were confirmed by LC-MS/MS, HPLC, and IC data matching with commercial standards. The two radiolytic substances produced during irradiation with an electron beam were predicted by LC-QTOF-MS. This study led to an understanding of the role of electron beams in the transformation of parent compounds and to the decomposition products created when an electron beam is applied to treat perfluorinated compounds.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1016/j.scitotenv.2018.03.055 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Influence of Photoemission Geometry on Timing and Efficiency in 4D Ultrafast Electron Microscopy.
Chemphyschem
January 2025
University of Minnesota Twin Cities, Chemical Engineering and Materials Science, 421 Washington Avenue SE, 55455, Minneapolis, UNITED STATES OF AMERICA.
Broader adoption of 4D ultrafast electron microscopy (UEM) for the study of chemical, materials, and quantum systems is being driven by development of new instruments as well as continuous improvement and characterization of existing technologies. Perhaps owing to the still-high barrier to entry, the full range of capabilities of laser-driven 4D UEM instruments has yet to be established, particularly when operated at extremely low beam currents (~fA). Accordingly, with an eye on beam stability, we have conducted particle tracing simulations of unconventional off-axis photoemission geometries in a UEM equipped with a thermionic-emission gun.
View Article and Find Full Text PDFIn Situ Focused Ion Beam Redeposition Surface Coatings for Site-Specific, Near-Surface Characterization by Atom Probe Tomography.
Microsc Microanal
January 2025
Department of Materials Science and Engineering, McMaster University, Hamilton, Ontario L8S 4L7, Canada.
Atom probe tomography (APT) enables three-dimensional chemical mapping with near-atomic scale resolution. However, this method requires precise sample preparation, which is typically achieved using a focused ion beam (FIB) microscope. As the ion beam induces some degree of damage to the sample, it is necessary to apply a protective layer over the region of interest (ROI).
View Article and Find Full Text PDFRetrieval of Phase Information from Low-Dose Electron Microscopy Experiments: Are We at the Limit Yet?
Microsc Microanal
January 2025
EMAT, University of Antwerp, Groenenborgerlaan 171 2020, Antwerp, Belgium.
The challenge of imaging low-density objects in an electron microscope without causing beam damage is significant in modern transmission electron microscopy. This is especially true for life science imaging, where the sample, rather than the instrument, still determines the resolution limit. Here, we explore whether we have to accept this or can progress further in this area.
View Article and Find Full Text PDFVolume electron microscopy (vEM) enables biologists to visualize nanoscale 3D ultrastructure of entire eukaryotic cells and tissues prepared by heavy atom staining and plastic embedding. The highest resolution vEM technique is focused ion-beam scanning electron microscopy (FIB-SEM), which provides nearly isotropic (~5-10 nm) spatial resolution at fluences of > 10,000 e /nm . However, it is not clear how such high resolution is achievable because serial block-face (SBF) SEM, which incorporates an in-situ ultramicrotome instead of a Ga FIB beam, results in radiation-induced collapse of similar specimen blocks at fluences of only ~20 e /nm .
View Article and Find Full Text PDFSimultaneous Application of Electron Beam Irradiation and Freezing as an Effective Method for Shelf Life Extension of Minced Turkey Meat.
Food Sci Nutr
January 2025
Department of Food Science and Technology, Faculty of Technical and Engineering University of Science and Arts of Yazd Yazd Iran.
In this study, minced turkey meat samples were subjected to electron-beam irradiation with dosages of 0, 1.5, 3, and 5 kGy, and then microbial (mesophilic and psychrotrophic bacteria), physiochemical (pH, water activity [a], thiobarbituric acid reactive substances [TBARS], and peroxide value [PV]), and sensory (color, odor, texture, and overall acceptability) analyses were performed at 0 and 6 months of freezing storage (-18°C). Results showed that by 5 kGy irradiation and freezing treatments, the counts of psychrotrophic and mesophilic bacteria reduced remarkably ( < 0.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!