This study aimed to investigate slow crack growth (SCG) behavior of a zirconia ceramic after grinding and simulated aging with low-temperature degradation (LTD). Complementary analysis of hardness, surface topography, crystalline phase transformation, and roughness were also measured. Disc-shaped specimens (15 mm Ø × 1.2 mm thick, n = 42) of a full-contour Y-TZP ceramic (Zirlux FC, Amherst) were manufactured according to ISO:6872-2008, and then divided into: Ctrl - as-sintered condition; Ctrl LTD - as-sintered after aging in autoclave (134°C, 2 bar, 20 h); G - ground with coarse diamond bur (grit size 181 μm); G LTD - ground and aged. The SCG parameters were measured by a dynamic biaxial flexural test, which determines the tensile stress versus stress rate under four different rates: 100, 10, 1 and 0.1 MPa/s. LTD led to m-phase content increase, as well as grinding (m-phase content: Ctrl - 0%; G - 12.3%; G LTD - 59.9%; Ctrl LTD - 81%). Surface topography and roughness analyses showed that grinding created an irregular surface (increased roughness) and aging did not promote any relevant surface change. There was no statistical difference on surface hardness among different conditions. The control group presented the lowest strength values in all tested rates. Regarding SCG, ground conditions were less susceptible to SCG, delaying its occurrence. Aging (LTD) caused an increase in SCG susceptibility for the as-sintered condition (i.e. G < G LTD < Ctrl < Ctrl LTD).
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1590/1807-3107bor-2018.vol32.0032 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Spotlight on the long-term effects of micro/nanoplastics exposure on Spirulina platensis: Algal cells, extracellular polymeric substances, and phycocyanin.
Food Chem
January 2025
College of Food Science and Engineering, Wuhan Polytechnic University, Wuhan 430023, Hubei, China. Electronic address:
Spirulina platensis (SP) provides humans with proteins and natural pigments. The effects of micro/nanoplastics (MNPs) on SP are of great interest. We focused on the effects of high concentrations (100-300 mg/L) of polystyrene MNPs on SP for 50 days.
View Article and Find Full Text PDFAmmonia Decomposition Catalyzed by Co Nanoparticles Encapsulated in Rare Earth Oxide.
J Phys Chem Lett
January 2025
Research Center for Materials Nanoarchitectonics (MANA), National Institute for Materials Science (NIMS), 1-1 Namiki, Tsukuba, Ibaraki 305-0044, Japan.
We fabricated Co-based catalysts by the low-temperature thermal decomposition of R-Co intermetallics (R = Y, La, or Ce) to reduce the temperature of ammonia cracking for hydrogen production. The catalysts synthesized are nanocomposites of Co/RO with a metal-rich composition. In the Co/LaO catalyst derived from LaCo, Co nanoparticles of 10-30 nm size are enclosed by the LaO matrix.
View Article and Find Full Text PDFPhysics-Based Synthetic Data Model for Automated Segmentation in Catalysis Microscopy.
Microsc Microanal
January 2025
Fritz-Haber-Institut der Max-Planck-Gesellschaft, Berlin 14195, Germany.
In catalysis research, the amount of microscopy data acquired when imaging dynamic processes is often too much for nonautomated quantitative analysis. Developing machine learned segmentation models is challenged by the requirement of high-quality annotated training data. We thus substitute expert-annotated data with a physics-based sequential synthetic data model.
View Article and Find Full Text PDFFatigue Experiment and Failure Mechanism Analysis of Aircraft Titanium Alloy Wing-Body Connection Joint.
Sensors (Basel)
December 2024
Department of Industrial Engineering and Management, Shanghai Jiao Tong University, Shanghai 200240, China.
Taking the titanium alloy wing-body connection joint at the rear beam of a certain type of aircraft as the research object, this study analyzed the failure mechanism and verified the structural safety of the wing-body connection joint under actual flight loads. Firstly, this study verified the validity of the loading system and the measuring system in the test system through the pre-test, and the repeatability of the test was analyzed for error to ensure the accuracy of the experimental data. Then, the test piece was subjected to 400,000 random load tests of flight takeoffs and landings, 100,000 Class A load tests, and ground-air-ground load tests, and the test piece fractured under the ground-air-ground load tests.
View Article and Find Full Text PDFStudy on the Aging Effects of Relative Humidity on the Primary Chemical Components of Palm Leaf Manuscripts.
Polymers (Basel)
December 2024
Key Laboratory of Archaeomaterials and Conservation, Ministry of Education, Institute of Cultural Heritage and History of Science & Technology, University of Science and Technology Beijing, Beijing 100083, China.
Palm Leaf Manuscripts represent a significant component of the world's cultural heritage. Investigating their primary chemical components and understanding the transformations these materials undergo under environmental influences are crucial for elucidating their material characteristics and aging mechanisms and developing effective strategies for preventive conservation. This study utilized infrared absorption spectroscopy and X-ray diffraction analysis to examine changes in the primary chemical components of Palm Leaf Manuscripts under varying relative humidity conditions over extended periods.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!