Thermal transport in ice features an unusual response. In addition to its intrinsic scientific interest, an understanding of the mechanisms determining the thermal conductivity of ice might be relevant in climate modelling and planetary science. Accurate microscopic models can provide important molecular insight into these mechanisms. In this work, we quantify using molecular simulations and state of the art forcefields, the thermal conductivity of ice Ih, VI, VII and a plastic phase that has been proposed very recently at pressures in the GPa range. The TIP4P models used in this study underestimate significantly the thermal conductivity of ice Ih and ice VII, while they show good agreement with experimental measurements of ice VI. The discrepancies observed are examined by investigating the temperature dependence of the thermal conductivity. The simulations indicate that the models are too anharmonic and they potentially feature a higher structural disorder than the experimental systems. We suggest that at high pressures the simulated thermal conductivities can be rationalized in terms of the performance of the models in predicting the equation of state of ice. The thermal conductivity of the plastic phase is very similar to that of the coexisting ice VII. Since the water molecules in the plastic phase feature orientational disorder, these results indicate that the hydrogen bond network does not play a significant role in defining the thermal transport mechanisms of ice at high pressures.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1039/c8cp01272e | DOI Listing |
Int J Biol Macromol
January 2025
Department of Pharmaceutics, School of Pharmacy, DRIEMS University, Tangi, Cuttack, Odisha, India. Electronic address:
To overcome the barriers often met by traditional ophthalmic formulations, polymeric films can be utilized as an alternative to enhance drug retention duration while managing medication release. In the current investigation, polymeric films made of poly (vinyl) alcohol (PVA) and chitosan (CS) loaded with Moxifloxacin Hydrochloride (M-HCl) and plasticized with Glutaraldehyde were formulated as potential ophthalmic delivery for the treatment of conjunctivitis. The thickness, surface pH, opacity, folding endurance, and % hemolysis were measured, followed by the transparency, microscopy, electrical conductivity, mechanical strength, swelling index, and invitro drug release studies.
View Article and Find Full Text PDFSci Rep
January 2025
Mechanical Engineering, Stanford University, Stanford, CA, 94305, USA.
Triply periodic minimal surface (TPMS) metamaterials show promise for thermal management systems but are challenging to integrate into existing packaging with strict mechanical requirements. Composite TPMS lattices may offer more control over thermal and mechanical properties through material and geometric tuning. Here, we fabricate copper-plated, 3D-printed triply periodic minimal surface primitive lattices and evaluate their suitability for battery thermal management systems.
View Article and Find Full Text PDFMaterials (Basel)
January 2025
Department of Mechanical Engineering, Samsun University, 55420 Samsun, Turkey.
This study addresses the thermal management challenge in battery systems by enhancing phase change material composites with Ni-P and Ni-P-Cu coatings on phase change material/expanded graphite structures. Traditional phase change materials are limited by low thermal conductivity and mechanical stability, which restricts their effectiveness in high-demand applications. Unlike previous studies, this work integrates Ni-P and Ni-P-Cu coatings to significantly improve both the thermal conductivity and mechanical strength of phase change material/expanded graphite composites, filling a crucial gap in battery thermal management solutions.
View Article and Find Full Text PDFMaterials (Basel)
January 2025
Department of Materials Science, Tokai University, Hiratsuka 259-1292, Kanagawa, Japan.
Semiconducting single-walled carbon nanotubes (SWCNTs) are significantly attractive for thermoelectric generators (TEGs), which convert thermal energy into electricity via the Seebeck effect. This is because the characteristics of semiconducting SWCNTs are perfectly suited for TEGs as self-contained power sources for sensors on the Internet of Things (IoT). However, the thermoelectric performances of the SWCNTs should be further improved by using the power sources.
View Article and Find Full Text PDFMaterials (Basel)
January 2025
School of Civil Engineering, Central South University, Changsha 410075, China.
Small-section steel-shell concrete immersed tube tunnels are intended for minibuses and have a low fire heat release rate. Standard fire rise curves do not apply to such tunnels. In this study, a coupled method of computational fluid dynamics (CFD) and the finite element method (FEM) was used to simulate the structural temperature distribution in tunnels.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!