Kinetics of the Gas-Phase O(D) + CO and C(D) + CO Reactions over the 50-296 K Range.

J Phys Chem A

Université de Bordeaux, Institut des Sciences Moléculaires , F-33400 Talence , France.

Published: April 2018

The kinetics of the reactions of CO with atomic oxygen and atomic carbon in their first excited singlet states have been studied at room temperature and below using the Laval nozzle reactor method. O(D) and C(D) atoms were created in situ by the 266 nm pulsed laser photolysis of O and CBr precursor molecules, respectively. While O(D) atoms were detected directly by vacuum ultraviolet laser-induced fluorescence at 115 nm, C(D) atoms were followed indirectly through a chemical tracer method. The measured rate constants for the O(D) + CO reaction are found to be in excellent agreement with earlier work and extend the available kinetic data for this process down to 50 K. The present work represents the first kinetics study of the C(D) + CO reaction below room temperature. Both reactions display rate constants that increase as the temperature falls, with a more substantial rate increase observed for the O(D) + CO reaction. This finding could be due to the increasing lifetimes of the intermediate species involved at lower temperatures.

Download full-text PDF

Source
http://dx.doi.org/10.1021/acs.jpca.8b01964DOI Listing

Publication Analysis

Top Keywords

room temperature
8
rate constants
8
kinetics gas-phase
4
gas-phase reactions
4
reactions 50-296
4
50-296 range
4
range kinetics
4
kinetics reactions
4
reactions atomic
4
atomic oxygen
4

Similar Publications

Objective: The process of glycolysis from blood collection to centrifugation impacts the diagnosis of gestational diabetes mellitus (GDM). However, the specific characteristics of the working environment in China and its influence on GDM diagnosis still need to be clarified.

Methods: Firstly, 15 pregnant women were recruited, and six specimens were collected from each in a fasting state.

View Article and Find Full Text PDF

Room-Temperature CsPbI-Quantum-Dot Reinforced Solid-State Li-Polymer Battery.

Small

January 2025

Key Laboratory of Advanced Technologies of Materials, Ministry of Education, School of Materials Science and Engineering, Southwest Jiaotong University, Chengdu, 610031, China.

A novel polymer electrolyte based on CsPbI quantum dots (QDs) reinforced polyacrylonitrile (PAN), named as PIL, is exploited to address the low room-temperature (RT) ion conductivity and poor interfacial compatibility of polymer solid-state electrolytes. After optimizing the content of CsPbI QDs, RT ion conductivity of PIL largely increased from 0.077 to 0.

View Article and Find Full Text PDF

The use of hydrogen as fuel presents many safety challenges due to its flammability and explosive nature, combined with its lack of color, taste, and odor. The purpose of this paper is to present an electrochemical sensor that can achieve rapid and accurate detection of hydrogen leakage. This paper presents both the component elements of the sensor, like sensing material, sensing element, and signal conditioning, as well as the electronic protection and signaling module of the critical concentrations of H.

View Article and Find Full Text PDF

The practical implementation of terahertz (THz) imaging and spectroscopic systems in real operational conditions requires them to be of a compact size, to have enhanced functionality, and to be user-friendly. This work demonstrates the single-sided integration of Fresnel-zone-plate-based optical elements with InGaAs bow-tie diodes directly on a semiconductor chip. Numerical simulations were conducted to optimize the Fresnel zone plate's focal length and the InP substrate's thickness to achieve constructive interference at 600 GHz, room-temperature operation and achieve a sensitivity more than an order of magnitude higher-up to 24.

View Article and Find Full Text PDF

Gold-Mercury-Platinum Alloy for Light-Enhanced Electrochemical Detection of Hydrogen Peroxide.

Sensors (Basel)

December 2024

Center for Experimental Chemistry Education of Shandong University, School of Chemistry and Chemical Engineering, Shandong University, Jinan 250100, China.

In this study, a simple and easy synthesis strategy to realize the modification of AuHgPt nanoalloy materials on the surface of ITO glass at room temperature is presented. Gold nanoparticles as templates were obtained by electrochemical deposition, mercury was introduced as an intermediate to form an amalgam, and then a galvanic replacement reaction was utilized to successfully prepare gold-mercury-platinum (AuHgPt) nanoalloys. The obtained alloys were characterized by scanning electron microscopy, UV-Vis spectroscopy, X-ray photoelectron spectroscopy and X-ray diffraction techniques.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!