This study describes the characterization of an AlO:C OSLD (Landauer's Luxel™ tape) for dose evaluation in Computed Tomography. The irradiations were conducted using both a constant potential X-ray equipment and a 64-slice clinical CT scanner, and the readouts were performed using a Risø TL/OSL reader. The following aspects were studied: batch homogeneity, energy response, linearity of dose response, reproducibility, reusability, and effect of uncertainties with the normalization of OSL signals per their response to beta radiation. A group of 330 dosimeters from the 452 irradiated with the same dose presented OSL signals within the interval of 4.7% from the average. The dosimeters presented energy-dependent response in good agreement with results found in the literature. The air kerma response of the OSL signal showed a linear trend for both the constant potential X-ray device and the clinical CT scanner, with differences in their slopes of approximately 10%. Reproducibility, reusability, and effect of beta normalization were analyzed by separating 72 dosimeters in 3 groups. The results obtained in this study together with those of previous works indicate that this type of dosimeter is adequate for dose evaluation in CT clinical applications.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.ejmp.2018.02.009DOI Listing

Publication Analysis

Top Keywords

computed tomography
8
dose evaluation
8
constant potential
8
potential x-ray
8
clinical scanner
8
reproducibility reusability
8
osl signals
8
dose
5
response
5
characterization osl
4

Similar Publications

Prognostic Value of Myocardial CT-ECV in Severe Aortic Stenosis Requiring Aortic Valve Replacement: A Systematic Review and Meta-analysis.

Eur Heart J Cardiovasc Imaging

January 2025

Department of Perioperative Cardiology and Cardiovascular Imaging, Centro Cardiologico Monzino IRCCS, Milan, Italy.

Aim: Computed tomography (CT)-derived extracellular volume fraction (ECV) is a non-invasive method to quantify myocardial fibrosis. Evaluating CT-ECV during aortic valve replacement (AVR) planning CT in severe aortic stenosis (AS) may aid prognostic stratification. This meta-analysis evaluated the prognostic significance of CT-ECV in severe AS necessitating AVR.

View Article and Find Full Text PDF

Objective: To describe the presentation, outcomes, and management strategies for cases of subcapsular liver hematoma associated with preeclampsia, eclampsia, or HELLP (hemolysis, elevated liver enzymes, and low platelet count) syndrome.

Methods: This was a case series of individuals with subcapsular liver hematoma managed at a single level IV center over a 10-year period, from 2013 to 2024. Presenting signs and symptoms, laboratory findings, time of onset, management strategies, acute perinatal and maternal outcomes, and long-term outcomes such as subsequent pregnancies were reviewed in the medical record and recorded.

View Article and Find Full Text PDF

Objectives: To compare the consolidation quality between the anteromedial aspect of regenerated bone (AMRB) and other areas of regenerated bone (TORB) following the induced membrane technique (IMT) for managing critical-sized tibial shaft bone defects, and determine the factors affecting consolidation quality in the AMRB.

Methods: Design: Retrospective comparative study.

Setting: Academic Level I trauma center.

View Article and Find Full Text PDF

Simultaneous Lefort 2 Distraction and Fronto-Orbito-Malar Advancement: Correcting Severe Upper and Midface Retrusion in a Patient With Crouzon Syndrome.

J Craniofac Surg

December 2024

Member of Sociedad Argentina de Ortodoncia, Member of International Society of Craneofacial Surgery, Member of Asociación Latinoamericana de Ortodoncia, Buenos Aires, Argentina.

Craniofacial syndromes present with exorbitism and airway obstruction as a result of upper and middle facial hypoplasia. Classical subcranial Lefort III (LF III) or monobloc distraction osteogenesis (DO) using an external craniofacial device is used to treat these deformities. These procedures are done during mixed dentition, in most cases, advancing an abnormal face, to a more normal position.

View Article and Find Full Text PDF

Background: Surgical treatment of comminuted and multiple facial fractures is challenging, as identifying the bone anatomy and restoring the alignment are complicated. To overcome the difficulties, 3D-printed "jigsaw puzzle" has been innovated to improve the surgical outcome. This study aimed to demonstrate the feasibility of 3D-printed model in facial fracture restoration procedures.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!