Performance of different substrates in constructed wetlands planted with E. crassipes treating low-strength sewage under subtropical conditions.

Sci Total Environ

The Federal University of Technology - Paraná (UTFPR), Civil Construction Academic Department, Deputado Heitor de Alencar Furtado St., 5000, Ecoville, 81280-340 Curitiba, Paraná, Brazil. Electronic address:

Published: July 2018

The present study aimed to assess removal potential of chemical oxygen demand (COD), total Kjeldahl nitrogen (TKN), total ammonia nitrogen (TAN), total phosphorus (TP) and acetylsalicylic acid (ASA) in synthetic wastewater simulating low-strength sewage by sequencing-batch mode constructed wetlands (CWs). Six CWs with three substrates (gravel, light expanded clay and clay bricks) and one CW of each substrate was planted with E. crassipes to verify the feasibility of using a floating macrophyte in CWs and verify the best optimized substrate. Results showed that the presence of E. crassipes enhanced the removal of COD for systems with gravel, increasing the removal efficiency from 37% in the unplanted system (CW) to 60% in the planted system (CW). The vegetated CW with clay bricks (CW) presented the best performance for both TKN and TAN removal, with maximum removal efficiencies of 68% and 35%, respectively. Phosphorus was observed to be efficiently removed in systems with clay bricks, both planted (CW) and unplanted (CW), with mean removal efficiencies of 82% and 87%, respectively, probably via adsorption. It was also observed that after 296days of operation, no desorption or increase on phosphorus in effluent samples were observed, thus indicating that the material was not yet saturated and phosphorus probably presents a strong binding to the media. ASA removal efficiency varied from 34% to 92% in CWs, probably due to plant uptake through roots and microbial biodegradation. Plant direct uptake varied from 4 to 74% of the total nitrogen and from 26 to 71% of the total phosphorus removed in CW, CW and CW. E. crassipes was able to uptake up to 4.19g of phosphorus in CW and 11.84g of nitrogen in CW. The findings on this study suggest that E. crassipes could be used in CWs and clay bricks could significantly enhance phosphorus removal capacity in CWs.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.scitotenv.2018.02.342DOI Listing

Publication Analysis

Top Keywords

clay bricks
16
constructed wetlands
8
planted crassipes
8
low-strength sewage
8
removal
8
total phosphorus
8
removal efficiency
8
removal efficiencies
8
phosphorus
7
cws
6

Similar Publications

Valorization of piassava fiber by its incorporation in adobe bricks.

An Acad Bras Cienc

December 2024

Federal University of Pelotas, Department of Civil Engineering, Rua Gomes Carneiro, 01, 96010-610 Pelotas, RS, Brazil.

This study investigates valorization of piassava fiber through its incorporation in adobe bricks. The objective was to analyze the properties of adobe bricks reinforced with varying weight fractions of piassava fiber. The fibers were characterized for their chemical and physical characteristics, while the sand and clay were characterized for granulometry, XRD patterns, and EDX.

View Article and Find Full Text PDF

The availability of industrially used supplementary cementitious materials (SCMs, e.g., fly ash) decreases due to the rise in renewable energy sources and recycling technologies.

View Article and Find Full Text PDF

Radiation doses received by humans in their dwellings - A baseline report on radionuclides exposure from construction materials used in Chennai, Tamil Nadu, India.

J Hazard Mater

December 2024

Unit of Research in Radiation Biology & Environmental Radioactivity (URRBER), P.G. & Research Department of Zoology, The New College (Autonomous), Affiliated to University of Madras, Chennai, Tamil Nadu 600 014, India. Electronic address:

Gamma-ray spectrometry was employed to assess the activity concentrations of primordial radionuclides (U, Th, and K) in various construction materials, including those used for building, roofing, furnishing, flooring, and plastering. The measured activity concentrations of the radionuclides ranged as follows: U (25 to 477 Bq kg), Th (below detection limit to 239 Bq kg), and K (285 to 1915 Bq kg). Based on these values, the materials were categorized in descending order of radioactivity threat as: Furnishing > Roofing > Building > Flooring > Plastering.

View Article and Find Full Text PDF

The use of recycled aggregates in the production of concrete and mortar represents a sustainable way to reintroduce these constituents-which are typically treated as waste and disposed of-in the production chain, providing new value to potentially polluting materials. The effect of recycled aggregates has been widely studied in the production of concrete due to the directions of National Standards in Italy; however, their role in the manufacturing of mortar must be investigated further due to the high variability that can be observed in the literature. In particular, the aim of this paper is the mechanical characterization of sustainable mortars defined by different mix designs and different binders, in which the aggregates are gradually replaced by a recycled sand obtained from the grinding of construction and demolition wastes, which could include old concrete, clay bricks, and minimal amounts of other kinds of residual materials.

View Article and Find Full Text PDF
Article Synopsis
  • The paper addresses the urgent need for sustainable building materials by exploring the reuse of post-consumer plastic waste aggregate (PWA) to create lightweight mortar as an alternative to traditional sand in construction.
  • Incorporating PWA at levels of 0.00% to 10.00% by weight significantly increased the mortar's water absorption and flow, but drastically reduced its strength by up to 92.29%, indicating a trade-off between lightweight properties and structural integrity.
  • The study suggests that using 7.50% and 10.00% PWA can produce effective lightweight wall panels, which not only help manage plastic waste but also lessen the weight of buildings and improve their seismic resistance while lowering environmental impact from brick production.
View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!