Lateral ridge augmentation is conventionally accomplished by means of autogenous bone grafts. However, due to its complications, the application of autogenous bone graft substitutes, e.g. mineralized corticocancellous allograft, is ecommended. In the present study, twelve patients were included, with insufficient alveolar ridge widths in the designated sites for dental implant placement. During the primary surgery, mineralized corticocancellous block allografts were fixed in deficient sites with titanium screws and resorbable collagen membranes were used to cover the blocks. After a period of six months, a flap was raised and variations in ridge width values was measured. Finally, a micro-biopsy was obtained from the sites for histologic investigation prior to preparing them for subsequent implant placement. All the applied blocks were incorporated into the underlying bone except for one. A statistically significant difference was seen between the average ridge widths before placing the allografts compared with that of implant placement stage (2.62±1.02 mm vs. 7.75±1.63 mm, respectively). Vital bone tissue was detected in all the histological specimens obtained from the interface of blocks and the underlying bone. The results suggest that mineralized corticocancellous block allografts might be used as scaffolds for bone growth and ridge width augmentation.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC5768955 | PMC |
http://dx.doi.org/10.15171/joddd.2017.040 | DOI Listing |
Clin Spine Surg
December 2024
Sint Maartenskliniek, Hengstdal, Nijmegen, Netherlands.
Study Design: We performed a comprehensive cadaveric biomechanical study to compare the fixation strength of primary screws, screws augmented with bone allograft, and screws augmented with polymethylmethacrylate cement.
Objective: To evaluate a novel technique for screw augmentation using morselized cortico-cancellous bone allograft to fill the widened screw track of failed pedicle screws.
Background: To date, there are no known biological methods available for failed pedicle screw augmentation or fixation.
Int J Periodontics Restorative Dent
May 2024
Sinus floor augmentation is one of the most common approaches to obtain sufficient bone availability for placing implants in cases with severe bone atrophy in the posterior maxilla. Several bone substitutes are indicated for sinus augmentation, but they may achieve different clinical outcomes. This study aims to compare bovine bone mineral (BBM) with freeze-dried bone allograft (FDBA) in a two-stage lateral window sinus grafting approach.
View Article and Find Full Text PDFDent J (Basel)
January 2023
ARDEC Academy, 47923 Rimini, Italy.
Background: The Schneiderian membrane (SM) that is in contact with biomaterial granules may become thinner and eventually perforate. It has been shown that these events are related to the biomaterial used. Hence, the main aim of the present study was to compare the damaging effects of two xenografts with different resorbability rates on SM.
View Article and Find Full Text PDFOral Maxillofac Surg
June 2023
Oral Surgery Unit, Department of Stomatology, Faculty of Medicine and Dentistry, University of Valencia, C/Gasco Oliag 1, 46021, Valencia, Spain.
Aim: The purpose of this study was to evaluate using microCT and positron emission tomography (PET) analysis, the influence on bone healing of the placement of particulate autogenous bone in the antrostomy, and in the subjacent region after maxillary sinus elevation with xenograft.
Material And Methods: The sinus mucosa was elevated in sixteen male New Zealand rabbits and they were both grafted with a collagenated cortico-cancellous porcine bone. The antrostomy and the near subjacent region were filled with either the same xenograft (control site) or with particulate autogenous bone (test site) harvested from the tibia.
JBMR Plus
May 2021
Musculoskeletal Biology and Mechanics Lab, Department of Basic Medical Sciences Purdue University West Lafayette IN USA.
Strain magnitude has a controlling influence on bone adaptive response. However, questions remain as to how and if cancellous and cortical bone tissues respond differently to varied strain magnitudes, particularly at a molecular level. The goal of this study was to characterize the time-dependent gene expression, bone formation, and structural response of the cancellous and cortical bone of female C57Bl/6 mice to mechanical loading by applying varying load levels (low: -3.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!