A Simple and Convenient Aptasensor for Protein Using an Electronic Balance as a Readout.

The electronic balance, one of the most common pieces of equipment in the laboratory, is normally used to directly measure the weight of a target with high accuracy. However, little attention has been paid to the extension of its applications. In this study, an electronic balance was used as a readout to develop a novel aptasensor for protein quantification for the first time. Thrombin was selected as a model target, and its two aptamers recognizing different sites of the protein were used (one aptamer was immobilized on the surface of magnetic microparticles and the other aptamer was functionalized with platinum nanoparticles). The two aptamers were specifically bound with the thrombin to form a sandwich structure; thus, the platinum nanoparticles were linked to the magnetic microparticles, and they were separated by a magnet easily. The captured platinum nanoparticles effectively catalyzed the decomposition of HO, generating a large volume of O to discharge a certain amount of water in a drainage device, because the pressure in the vial is higher than that outside of the vial. The weight of water was accurately measured by an electronic balance. The weight of water increased with the increasing of the thrombin concentration in the range of 0 to 100 nM with a detection limit of 2.8 nM. This is the first time the use of an electronic balance as a signal readout for biomolecule quantitation in bioassay has been reported.