Controlling Long-Lived Triplet Generation from Intramolecular Singlet Fission in the Solid State.

J Phys Chem Lett

National Renewable Energy Laboratory , 15013 Denver West Parkway, Golden, Colorado 80401, United States.

Published: December 2017

The conjugated polymer poly(benzothiophene dioxide) (PBTDO1) has recently been shown to exhibit efficient intramolecular singlet fission in solution. We investigate the role of intermolecular interactions in triplet separation dynamics after singlet fission. We use transient absorption spectroscopy to determine the singlet fission rate and triplet yield in two polymers differing only by side-chain motif in both solution and the solid state. Whereas solid-state films show singlet fission rates identical to those measured in solution, the average lifetime of the triplet population increases dramatically and is strongly dependent on side-chain identity. These results show that it may be necessary to carefully engineer the solid-state microstructure of these "singlet fission polymers" to produce the long-lived triplets needed to realize efficient photovoltaic devices.

Download full-text PDF

Source
http://dx.doi.org/10.1021/acs.jpclett.7b02750DOI Listing

Publication Analysis

Top Keywords

singlet fission
20
intramolecular singlet
8
solid state
8
fission
6
singlet
5
controlling long-lived
4
triplet
4
long-lived triplet
4
triplet generation
4
generation intramolecular
4

Similar Publications

Activated intramolecular singlet fission is known to occur in the conjugated polymer polythienylene-vinylene (P3TV). Instead, efficient intersystem crossing has been observed in a short 3-alkyl(thienylene-vinylene) dimer. Here, we investigate a series of oligomers covering the conjugation length gap between the dimer and polymer.

View Article and Find Full Text PDF

Singlet exciton fission has the potential to increase the efficiency of crystalline silicon solar cells beyond the conventional single junction limit. Perhaps the largest obstacle to achieving this enhancement is uncertainty about energy coupling mechanisms at the interfaces between silicon and exciton fission materials such as tetracene. Here, the previously reported silicon-hafnium oxynitride-tetracene structure is studied and a combination of magnetic-field-dependent silicon photoluminescence measurements and density functional theory calculations is used to probe the influence of the interlayer composition on the triplet transfer process across the hafnium oxynitride interlayer.

View Article and Find Full Text PDF

Intermolecular Interactions and their Implications in Solid-State Photon Interconversion.

Chimia (Aarau)

December 2024

Dept. of Chemistry, Dept. of Physics and Astronomy, Dept. of Materials Science and Nanoengineering, Rice Advanced Materials Institute, Rice University, Houston, Texas 77005, USA.

Photon interconversion promises to alleviate thermalization losses for high energy photons and facilitates utilization of sub-bandgap photons - effectively enabling the optimal use of the entire solar spectrum. However, for solid-state device applications, the impact of intermolecular interactions on the energetic landscape underlying singlet fission and triplet-triplet annihilation upconversion cannot be neglected. In the following, the implications of molecular arrangement, intermolecular coupling strength and molecular orientation on the respective processes of solid-state singlet fission and triplet-triplet annihilation are discussed.

View Article and Find Full Text PDF

The radical character of molecules exhibiting singlet fission is related to the energy level matching relationships that facilitate this process. Using a linear H model molecule, we employ quantum chemical topology descriptors based on full configuration interaction calculations to rationalize singlet fission. In this context, the influence of the closed-shell to diradical and diradical to tetraradical character on the singlet fission energy matching conditions is analyzed.

View Article and Find Full Text PDF

Intramolecular singlet fission (SF) in multichromophore systems is of high interest for photovoltaic application. As an attractive candidate for SF-based devices, enabling efficient SF in covalent oligomers of perylene diimide (PDI) still remains challenging. In this work, inter-PDI SF with τ = ∼150 ps and ∼150% triplet yield in a covalent tetramer COTh-FPDI was facilitated by employing a saddle-shaped cyclooctatetrathiophene (COTh) core and fused linking with PDIs.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!