This paper deals with the use of tetrabutylammonium fluoride/dimethylsulfoxide (TBAF/DMSO) to characterize the molar mass distribution of non-derivatized cellulosic samples by size exclusion chromatography (SEC). Different cellulose samples with various average degree of polymerization (DP) were first solubilized in this solvent system, with increasing TBAF rates, and then analyzed by SEC coupled to a refractive index detector (RID), using DMSO as mobile phase. The Molar Masses (MM) obtained by conventional calibration were then discussed and compared with suppliers' data and MM determined by viscosimetry measurements. By this non-classic method, molar mass of low DP samples (Avicel and cotton fibers) have been determined. For high DP samples (α-cellulose and Vitacel), dissolution with TBAF concentration of 10 mg/mL involved elution of cellulose aggregates in the exclusion volume, related to an incomplete dissolution or the dilution of TBAF molecules in elution solvent, preventing the correct evaluation of their molar mass.
Download full-text PDF |
Source |
|---|---|
| http://www.ncbi.nlm.nih.gov/pmc/articles/PMC6150196 | PMC |
| http://dx.doi.org/10.3390/molecules22111985 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Accessibility of polycyclic aromatic hydrocarbon content in fishes from the region of the 2019 oil spill on the northeast Brazil coast.
Mar Pollut Bull
December 2024
Universidade Federal de Pernambuco, Departamento de Química Fundamental, Av. Jornalista Aníbal Fernandes, s/n, Cidade Universitária, 50740-560 Recife, PE, Brazil. Electronic address:
In August 2019, Brazil experienced its largest large oil spill, which impacted extensive areas and significantly affected the northeastern region, particularly Pernambuco. Polycyclic aromatic hydrocarbons (PAHs), major oil components, are critical for assessing fish contamination risks. This study presents two sample pretreatment methods for fish samples - ultrasound-enhanced air-assisted liquid-liquid microextraction (UE-AA-LLME) for low molar mass PAHs, and matrix solid-phase dispersion for high molar mass PAHs - followed by a Gas-Chromatography coupled to Mass Spectrometry (GC-MS) detection.
View Article and Find Full Text PDFEnergy-Resolved Mass Spectrometry and Mid-Infrared Spectroscopy for Purity Assessment of a Synthetic Peptide Cyclised by Intramolecular Huisgen Click Chemistry.
Methods Protoc
December 2024
Univ Brest, CEMCA, CNRS, UMR 6521, 29238 Brest, France.
Cyclic peptides have higher stability and better properties as therapeutic agents than their linear peptide analogues. Consequently, intramolecular click chemistry is becoming an increasingly popular method for the synthesis of cyclic peptides from their isomeric linear peptides. However, assessing the purity of these cyclic peptides by mass spectrometry is a significant challenge, as the linear and cyclic peptides have identical masses.
View Article and Find Full Text PDFAcid-Enhanced Photoiniferter Polymerization under Visible Light.
Angew Chem Int Ed Engl
December 2024
ETH Zurich, Materials, Vladimir-Prelog-Weg 1-5/10, 8093, Zürich, SWITZERLAND.
Photoiniferter (PI) is a promising polymerization methodology, often used to overcome restrictions posed by thermal reversible addition-fragmentation chain-transfer (RAFT) polymerization. However, in the overwhelming majority of reports, high energy UV irradiation is required to effectively trigger photolysis of RAFT agents and facilitate the polymerization, significantly limiting its potential, scope, and applicability. Although visible light PI has emerged as a highly attractive alternative, most current approaches are limited to the synthesis of lower molecular weight polymers, and typically suffer from prolonged reaction times, extended induction periods, and higher dispersities.
View Article and Find Full Text PDFPurification and structural characterization of a neutral polysaccharide from Boletus auripes using self-made quaternary chitosan cryogel.
Int J Biol Macromol
December 2024
College of Chemistry and Molecular Sciences, Hubei Engineering Center of Natural Polymer-Based Medical Materials, Wuhan University, Wuhan 430072, China. Electronic address:
The purification of polysaccharides is an essential preliminary step in determining their chemical structure, although it presents significant challenges. In this research, a macro-porous monolith of quaternary chitosan cryogel was synthesized for the purification of a neutral polysaccharide from Boletus auripes. A homogeneous neutral polysaccharide (BAP-1a1) with a weight-average molecular weight of 4.
View Article and Find Full Text PDFFabrication, structural, physical, optical characteristics and γ-ray attenuation capacity of borosilicate glasses doped with GdO.
Sci Rep
December 2024
Department of Physics, Faculty of Science, Menoufia University, Shebin El-Koom, Menoufia, 32511, Egypt.
Barium fluoride borosilicate glass samples reinforced with varying amounts of GdO (BSBLG0-BSBLG4) have been manufactured using the conventional melt quenching procedure in order to provide additional research on the type of borosilicate glass. Structural, physical, and linear optical characteristics as well as γ-ray attenuation capacity of barium fluoride borosilicate doped with GdO was investigated. X-ray diffraction pattern proving the amorphous nature of the glass samples due to the absence of a distinctive crystalline characteristic peak.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!