In recent years, functionalized photopolymer systems capable of holographic recording are in great demand due to their potential use in the development of holographic sensors. This work presents a newly developed N-isopropylacrylamide (NIPA)-based photopolymer for holographic recording in reflection and transmission modes. The optimized composition of the material is found to reach refractive index modulation of up to 5×10 and 1.6×10 after recording in transmission and reflection mode, respectively. In addition to fulfilling the requirements for holographic recording materials, the NIPA-based photopolymer is sensitive to temperature and has lower toxicity than acrylamide-based photopolymers. Possible application of the NIPA-based photopolymer in the development of a holographic temperature sensor is discussed.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1364/AO.56.006348 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
This Letter discusses the limitations of immersion-free recording schemes for holographic waveguide displays. Traditional holographic recording of waveguides requires recording angles exceeding the critical angle of the hologram-cladding interface. Achieving these angles necessitates edge-lit exposure using prisms and immersion liquids, which are challenging for roll-to-roll mass production and hinder widespread adoption.
View Article and Find Full Text PDFWavefront-aberration-tolerant diffractive deep neural networks using volume holographic optical elements.
Sci Rep
January 2025
Applied Electromagnetic Research Center, National Institute of Information and Communications Technology, Nukui-Kitamachi, Koganei, Tokyo, 184-8795, Japan.
As the demand for computational performance in artificial intelligence (AI) continues to increase, diffractive deep neural networks (DNNs), which can perform AI computing at the speed of light by repeated optical modulation with diffractive optical elements (DOEs), are attracting attention. DOEs are varied in terms of fabrication methods and materials, and among them, volume holographic optical elements (vHOEs) have unique features such as high selectivity and multiplex recordability for wavelength and angle. However, when those are used for DNNs, they suffer from unknown wavefront aberrations compounded by multiple fabrication errors.
View Article and Find Full Text PDFInvestigating the link between a layer thickness and surface relief depth in an azo poly(ether imide).
Sci Rep
January 2025
Faculty of Physics, Warsaw University of Technology, 75 Koszykowa Str., 00-662, Warszawa, Poland.
Surface relief grating formation in photo-responsive azo polymers under irradiation is a long-ago-found phenomenon, but all the factors governing its efficiency are still not fully recognized. Here, we report on the enormous impact of the polymer thickness on the possibility of fabrication of extremely high-amplitude surface deformations. We performed prolonged holographic recordings on the layers of the same azobenzene poly(ether imide), which had substantially different optical transmittances at the recording wavelength and revealed that the depths of the inscribed relief structures increased with the polymer thickness from a nondetectable value up to almost 2 µm, unaffected by the presence of a polymer-glass substrate interface in either sample.
View Article and Find Full Text PDFDesign of soft x-ray high diffraction efficiency and spectral flux Au/Ni bilayer coated laminar-type diffraction grating for objective soft x-ray flat-field spectrograph in a region of 250-550 eV.
Rev Sci Instrum
December 2024
Institute of Multidisciplinary Research for Advanced Materials (IMRAM), Tohoku University, Aoba-ku, Sendai, Miyagi 980-8577, Japan.
An objective soft x-ray flat-field spectrograph employing a laminar-type bilayer coated, varied-line-spacing, spherical grating was designed to improve the detection limit and sensitivity of soft x-ray flat-field spectrographs in a region of 250-550 eV. As a design criterion, spectral flux, SF, [Hatano et al., Appl.
View Article and Find Full Text PDFUsing a mixed-reality headset to elicit and track clinically relevant movement in the clinic.
J Neurosci Methods
December 2024
Charleston Area Medical Center, Charleston, WV, USA.
Background: 21st century neurology will require scalable and quantitative tools that can improve neurologic evaluations over telehealth and expand access to care. Commercially available mixed-reality headsets allow for simultaneous presentation of stimuli via holograms projected into the real world and objective and quantitative measurement of hand movement, eye movement, and phonation.
New Method: We created 6 tasks designed to mimic standard neurologic assessments and administered them to a single participant via the Microsoft HoloLens 2 mixed-reality headset.
Want AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!