The study aim was to investigate the effect of antierosive agents on enamel under normal and hyposalivatory conditions. This double-blind crossover in situ pilot study evaluated 4 toothpastes: placebo (0 ppm F), sodium fluoride (NaF, 1,450 ppm), stannous/sodium fluoride (SnF/NaF, 1,450 ppm F-, 1,090 ppm Sn2+), and sodium fluoride, stannous chloride and chitosan (NaF/Sn/Ch, 1,450 ppm F-, 3,500 ppm Sn2+, 0.5% Ch). Twenty participants were assigned to 2 groups (n = 10 each): normal and low salivary flow. Participants wore palatal appliances holding 4 bovine enamel specimens previously eroded in vitro (D1) for 20 min prior to an in situ phase after which they were eroded again (D2). Surface microhardness was determined at baseline (BL), after D1, in situ phase and D2 to assess hardness loss (%SMH), residual hardness loss (%RHL) and erosion resistance (%RER). Additional specimens were evaluated by scanning electron microscopy after the in situ phase. ANOVA and a factorial analysis for between-subject effects were performed. Sn-based toothpastes showed the best effects (p < 0.05). Under normal flow, SnF/NaF showed higher efficacy, with a significant difference compared to NaF/Sn/Ch, NaF, and placebo (p < 0.05). Under low flow, SnF/NaF and NaF/Sn/Ch were comparable (p > 0.05); NaF and placebo were statistically similar. Comparing salivary conditions, there were significant differences for SnF/NaF for %SMH after the in situ phase (%SMHtotal)), %RHL and for all toothpastes in case of %RER. Factorial analysis revealed interactions between toothpaste and saliva flow for %SMHtotal and %RHL. Salivary flow can influence the efficacy of the antierosive toothpastes; however, Sn2+ preparations show even under low salivary flow conditions the highest efficacy in the prevention of enamel erosion.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1159/000479041 | DOI Listing |
Small
January 2025
School of Materials Science and Engineering, Tianjin Key Laboratory of Composite and Functional Materials Key Laboratory of Advanced Ceramics and Machining Technology (Ministry of Education), Tianjin University, Tianjin, 300072, China.
Enhancing the catalytic performance and durability of M-N─C catalyst is crucial for the efficient operation of proton exchange membrane fuel cells (PEMFCs) and Zn-Air batteries (ZABs). Herein, an approach is developed for the in situ fabrication of a MOFs-derived porous carbon material, co-loaded with Co nanoparticles (NPs) and Co-N sites and integrated onto Fe-doped carbon nanotubes (CNTs), named Co-NC/Fe-NCNTs. Incorporating polymer-wrapped CNTs improves MOFs dispersion annealing at high temperature, which amplifies the three-phase boundary (TPB) by generating much more mesopores and exposing additional active sites within the catalysts layer.
View Article and Find Full Text PDFAnal Chim Acta
February 2025
School of Physics and Electronic Information Engineering, Henan Polytechnic University, Jiaozuo, 454003, China. Electronic address:
Background: Trimethylamine (TMA) is a colorless, volatile gas with a strong irritating odor. Prolonged exposure to a certain amount of TMA can cause symptoms such as dizziness, nausea and difficulty breathing, and may even be life-threatening. Therefore, effective detection of TMA is crucial.
View Article and Find Full Text PDFActa Biomater
January 2025
Department of Biomedical Engineering, Lund University, Box 118, 221 00 Lund, Sweden.
While the number of studies investigating Achilles tendon pathologies has grown exponentially, more research is needed to gain a better understanding of the complex relation between its hierarchical structure, mechanical response, and failure. At the microscale, collagen fibers are, with some degree of dispersion, primarily aligned along the principal loading direction. However, during tension, rearrangements and reorientations of these fibers are believed to occur.
View Article and Find Full Text PDFInt J Pharm
January 2025
Key Laboratory of Biopharmaceutical Preparation and Delivery, State Key Laboratory of Biochemical Engineering, Chinese Academy of Sciences, Beijing 100190 China; Key Laboratory of Industrial Microbiology, Ministry of Education, College of Biotechnology, Tianjin University of Science and Technology, Tianjin 300457 China. Electronic address:
Trauma healing is the process of healing after the body has been subjected to an external force and the skin and other tissues have become dissected or defective, showing the synergistic effect of various processes. Therefore, the investigation of innovative wound dressings has significant research and clinical implications. In this study, we constructed a zinc based metal-organic framework (MOF) and loaded with antimicrobial peptide LL37 to prepare LL37@ZPF-2 (ZPF = zeolite pyrimidine backbone), which was subsequently integrated with Poloxamer 407 to fabricate LL37@ZPF-2 thermosensitive hydrogel.
View Article and Find Full Text PDFMaterials (Basel)
January 2025
School of Civil Engineering, Beijing Jiaotong University, Beijing 100044, China.
Cemented Sand, Gravel, and Rock (CSGR) dams have traditionally used either Conventional Vibrated Concrete (CVC) or Grout-Enriched Roller Compacted Concrete (GERCC) for protective and seepage control layers in low- to medium-height dams. However, these methods are complex, prone to interference, and uneconomical due to significant differences in the expansion coefficient, elastic modulus, and hydration heat parameters among CSGR, CVC, and GERCC. This complexity complicates quality control during construction, leading to the development of Grout-Enriched Vibrated Cemented Sand, Gravel, and Rock (GECSGR) as an alternative.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!