This review focuses on the research literatures published in 2016 relating to thermal effects in water pollution control. This review is divided into five sections: biological nitrogen removal, organic pollutant degradation, resource recovery, pretreatment and anaerobic digestion, microbial community.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.2175/106143017X15023776270656 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Chronic impacts of natural infrastructure on the physical and psychological health of university students during and after COVID-19: a case study of Chengdu, China.
Front Public Health
December 2024
Landscape Architecture College, Sichuan Agricultural University, Chengdu, China.
Introduction: The COVID-19 pandemic has underscored the health benefits of green spaces, yet research on how specific elements of natural infrastructure affect well-being during the pandemic has been limited.
Methods: This study, conducted at Sichuan Agricultural University with 300 students in 2022, investigated how urban natural infrastructure impacts physical and psychological well-being during the pandemic. Different aspects of natural infrastructure, such as thermal comfort, air quality (negative ion concentration), and noise and light levels, varied in their positive effects on students' health.
A high-resolution in situ X-ray diffraction study of mineral transitions due to post-hydration heating in CM chondrite meteorites.
Earth Planets Space
December 2024
School of Geographical and Earth Sciences, The University of Glasgow, Glasgow, G12 8RZ Scotland, UK.
Abstract: The effects of post-hydration heating over a broad range of temperatures are evident in many Mighei-like carbonaceous (CM) chondrites as a variety of mineral transitions. To better understand these processes and how a CM chondrite's starting composition may have affected them, we experimentally heated two meteorites with different degrees of aqueous alteration, Allan Hills 83100 and Murchison, at 25 °C temperature steps from 200 °C to 950 °C and 300 °C to 750 °C, respectively. During heating, synchrotron in situ X-ray diffraction patterns were collected.
View Article and Find Full Text PDFHigh Joule heat as a risk factor for post-endoscopic submucosal dissection electrocoagulation syndrome: A multicenter prospective study.
World J Gastrointest Endosc
December 2024
Department of Gastroenterology, Hitachi General Hospital, Ibaraki 317-0077, Japan.
Background: Thermal damage may lead to inflammation of the peeled mucosal surface during endoscopic submucosal dissection (ESD).
Aim: To determine the effect of Joule heat on the onset of post-ESD electrocoagulation syndrome (PECS).
Methods: In this prospective study, PECS was characterized by in-hospital fever (white blood cell count: ≥ 10000 μ/L or body temperature ≥ 37.
Sensitivity Analysis of Directed Energy Deposition Simulation Results to Aluminum Material Properties.
3D Print Addit Manuf
December 2024
Mechanical and Aerospace Engineering, Missouri University of Science and Technology, Rolla, Missouri, USA.
Due to the high cost of each experimental run in additive manufacturing (AM), there has been a drive to develop simulations that can find the optimal processing parameters. The accuracy of these simulations is dependent on the accuracy of the material parameters recorded in literature. These reported parameters can vary widely resulting in differing simulation results.
View Article and Find Full Text PDFThe Effect of Thermal Cycle on Hot Cracking Evolution and Formation Mechanism in Thin Wall, Single Layer, and Cubic Samples of High-Strength Al-Cu-Mg-Mn Alloys Fabricated by Laser Powder Bed Fusion.
3D Print Addit Manuf
December 2024
School of Optical and Electronic Information, Huazhong University of Science and Technology, Wuhan, P.R. China.
Thermal cracking is one of the serious issues that deteriorates the processibility of laser powder bed fusion (LPBF) high-strength aluminum components. To date, the effects of processing parameters on crack formation are still not well understood. The purpose of this study is to understand the correlation between the thermal cycle and the hot cracking during LPBF of Al-Cu-Mg-Mn alloys.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!