Electrochemical fluorination of methyl(phenylthio)acetate was achieved using tetrabutylammonium fluoride (TBAF). Electrochemical fluorination was performed under potentiostatic anodic oxidation using an undivided cell in acetonitrile containing TBAF and triflic acid. The influence of several parameters including: oxidation potential, time, temperature, sonication, TBAF concentration and triflic acid concentration on fluorination efficiency were studied. It was found that the triflic acid to TBAF concentration ratio plays a key role in the fluorination efficiency. Electrochemical fluorination resulted in formation of mono-fluorinated methyl 2-fluoro-2-(phenylthio)acetate verified by gas chromatography-mass spectrometry (GC-MS) and nuclear magnetic resonance (NMR) Spectroscopy. Under optimum conditions 44 ± 3% mono fluorination yield was obtained after a 30 min electrolysis. Electrochemical radiofluorination for the synthesis of methyl 2-[F]fluoro-2-(phenothio) acetate was also achieved with the same optimized electrochemical cell parameters where TBAF was first passed through an anion exchange resin containing fluorine-18. A radiochemical fluorination efficiency of 7 ± 1% was achieved after 30 min of electrolysis.
Download full-text PDF |
Source |
|---|---|
| http://www.ncbi.nlm.nih.gov/pmc/articles/PMC5589193 | PMC |
| http://dx.doi.org/10.1149/2.0941709jes | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Electrochemical Fluorination of Organic Compounds Using a Hexafluorosilicate Salt as an Inexpensive and Widely Available Fluorine Source.
Org Lett
January 2025
Institute of Chemistry, NAWI Graz, University of Graz, Heinrichstrasse 28, 8010 Graz, Austria.
The introduction of fluorine into organic molecules is of the utmost importance in the preparation of active pharmaceutical ingredients (APIs). While a wide range of fluorine sources for organic synthesis have been used over the past decades, the associated safety risks, cost, or environmental impact are still serious limitations. Hexafluorosilicate salts are one of the most inexpensive and readily available sources of nucleophilic fluorine, but they have so far not been used in organic synthesis.
View Article and Find Full Text PDFFacile Synthesis of Selenium Nanoparticles for Enhanced Oxygen Evolution Reaction: Insights into Electrochemical and Photoelectrochemical Catalysis.
ACS Omega
January 2025
Department of Chemistry, School of Natural Sciences, National University of Sciences and Technology, H-12, Islamabad 44000, Pakistan.
Implementing a hydrogen economy on an industrial scale poses challenges, particularly in developing cost-effective and stable catalysts for water electrolysis. This study explores the catalytic potential of selenium nanoparticles (Se-NPs) synthesized via a simple chemical bath deposition method for electrochemical and photoelectrochemical (PEC) water splitting. The successful fabrication of Se-NPs on fluorine-doped tin oxide (FTO) electrodes has been confirmed using a wide range of analytical tools like X-ray diffraction, energy-dispersive X-ray spectroscopy, and scanning electron microscopy.
View Article and Find Full Text PDFNano- and Micro-SiO With Integrated Green Chemistry-Based Superhydrophobic Coating for Robust Antifouling and Anticorrosion Properties.
ACS Appl Mater Interfaces
January 2025
Graduate Institute of Applied Science and Technology, National Taiwan University of Science and Technology, 43 Section 4, Keelung Road, Taipei 10607, Taiwan, ROC.
With increasing energy demands, the need for coating materials with exceptional superhydrophobic properties has grown substantially. However, the widespread use of fluorinated compounds, solvents, and polymer-based synthetic materials has led to heightened levels of microplastics and pollutants. Here, we used a self-curing, solvent-free, and recyclable polyester polyol polymer material combined with (5 and 6.
View Article and Find Full Text PDFBreaking Anionic Solvation Barrier for Safe and Durable Potassium-ion Batteries Under Ultrahigh-Voltage Operation.
Angew Chem Int Ed Engl
January 2025
Northeast Normal University, Faculty of Chemistry, Remin Street 5268, 130024, Changchun, CHINA.
Ultrahigh-voltage potassium-ion batteries (PIBs) with cost competitiveness represent a viable route towards high energy battery systems. Nevertheless, rapid capacity decay with poor Coulombic efficiencies remains intractable, mainly attributed to interfacial instability from aggressive potassium metal anodes and cathodes. Additionally, high reactivity of K metal and flammable electrolytes pose severe safety hazards.
View Article and Find Full Text PDFIn situ oxidized MoCT MXene film via electrochemical activation for smart electrochromic supercapacitors.
J Colloid Interface Sci
January 2025
College of Chemical and Pharmaceutical Engineering, Jilin Institute of Chemical Technology, Jilin 132022, PR China. Electronic address:
MoCT MXenes have great potential for multifunctional energy storage applications because of their outstanding electrical conductivity, superior cycling stability, and high optical transmittance. In this study, we fabricate MoCT film electrodes (referred to as MoC) on fluorine-doped tin oxide (FTO) substrates using the layer-by-layer (LbL) self-assembly technique. To improve the energy-storage performance of MoCT film electrodes, we develop a convenient electrochemical activation process to prepare in situ oxidized MoCT/MoO film electrodes (referred to as EA-MoC).
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!