We demonstrate a simple and efficient one-step procedure for synthesizing a solid state polypyrrole (PPy) thin film for supercapacitor applications using alternating current impedance spectroscopy. By controlling the frequency and amplitude we were able to create unique PPy nano/microstructures with a particular morphology of the loop. Our PPy micro/nanosphere shows extremely high capacitance of 568 F/g, which is close to the theoretical value of 620 F/g and 20-100% higher than that of other reported PPy electrodes. Most of all, this material presents high capacitance and significantly improved electrochemical stability without pulverization of its structure, demonstrating 77% retention of the capacitance value even after 10 000 charge/discharge cycles. These results are a consequence of the larger surface area and adequate porosity generated due to the balance between the nano/micro PPy loops. This created porous structure also allows the favored penetration of electrolyte and high ion mobility within the polymer and prevents the mechanical failure of the physical structure during volume variation associated with the insertion/deinsertion of ions upon cycling.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1021/acsami.7b11574 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Cobalt Hexacyanoferrate Cathode with Stable Structure and Fast Kinetics for Aqueous Zinc-Ion Batteries.
ACS Appl Mater Interfaces
January 2025
Center of Nanomaterials for Renewable Energy, State Key Laboratory of Electrical Insulation and Power Equipment, School of Electrical Engineering, Xi'an Jiaotong University, Xìan, Shaanxi 710049, China.
Prussian blue analogues (PBAs) show great promise as cathode candidates for aqueous zinc-ion batteries thanks to their high operating voltage, open-framework structure, and low cost. However, suffering from numerous vacancies and crystal water, the electrochemical performance of PBAs remains unsatisfactory, with limited capacity and poor cycle life. Here, a simple coprecipitation method is shown to synthesize well-crystallized cobalt hexacyanoferrate (CoHCF) with a small amount of water and high specific surface area.
View Article and Find Full Text PDFSacrificial MOF-derived MnNi hydroxide for high energy storage supercapacitor electrodes via DFT-based quantum capacitance study.
Heliyon
January 2025
Materials and Process Simulation Center, California Institute of Technology, Pasadena, CA, 91125, USA.
Electrochemical energy storage plays a critical role in the transition to clean energy. With the growing demand for efficient and sustainable energy solutions, supercapacitors have gained significant attention due to their high specific capacitance, rapid charge/discharge capabilities, long lifespan, safe operation across various temperatures, and minimal maintenance needs. This study introduces a novel approach for the synthesis of high-performance supercapacitor electrodes by using MnNi-MOF-74 as a precursor.
View Article and Find Full Text PDFRate capability and electrolyte concentration: Tuning MnO supercapacitor electrodes through electrodeposition parameters.
Heliyon
January 2025
Sharif Institute of Energy, Water and Environment, Sharif University of Technology, Azadi Avenue, P.O.Box11365-9465, Tehran, Iran.
Manganese dioxide (MnO) is a well-known pseudocapacitive material that has been extensively studied and highly regarded, especially in supercapacitors, due to its remarkable surface redox behavior, leading to a high specific capacitance. However, its full potential is impeded by inherent characteristics such as its low electrical conductivity, dense morphology, and hindered ionic diffusion, resulting in limited rate capability in supercapacitors. Addressing this issue often requires complicated strategies and procedures, such as designing sophisticated composite architectures.
View Article and Find Full Text PDFElectrocatalytic Reduction of Nitrate to Ammonia in an Aqueous Environment Using Nanoporous N- and P-Enriched Carbonaceous Material.
Langmuir
January 2025
Functional Materials Laboratory, Department of Chemistry, Indian Institute of Technology Roorkee, Roorkee, Uttarakhand 247667, India.
Carbonization (Argon atmosphere, 900 °C, 2 h) of heteroatom-enriched pyridine-bridged inorganic-organic hybrid material (HPHM) resulted in the formation of a high specific surface area (SA of 1080 m g) carbonaceous material designated as HPHMC900. The HPHMC900 serves as an effective electrocatalyst for the reduction of nitrate in an aqueous environment to ammonia (NORR). Importantly, HPHMC900 demonstrated fast kinetics for the NORR with a low Tafel slope of 70 mV decade.
View Article and Find Full Text PDFUnderstanding the phase structure evolution and charge storage mechanism of FeCoNi-MOFs as electrodes for asymmetric supercapacitors.
J Colloid Interface Sci
January 2025
State Key Laboratory of Featured Metal Materials and Life-cycle Safety for Composite Structures, MOE Key Laboratory of New Processing Technology for Nonferrous Metals and Materials, and School of Resources, Environment and Materials, Guangxi University, Nanning 530004, PR China. Electronic address:
Metal-organic frameworks (MOFs) due to abundant apertures, adjustable components, and multi-purpose structures have broad application prospects in supercapacitors. However, its low conductivity, poor stability, and difficulty growing evenly on the conductive substrate limit the electrochemical energy storage performance. Herein, with FeCoNi-OH nanosheets serving as the precursors, the trimetallic FeCoNi-MOF (FCNM) multilayer structure is successfully synthesized on activated carbon cloth (AC), and its optimal growth state (FCNM/AC-12 h) is achieved by regulating the reaction time.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!