In the present work, by performing chemostat experiments at 400 and 600 RPM, two typical power inputs representative of industrial penicillin fermentation (P/V, 1.00 kW/m in more remote zones and 3.83 kW/m in the vicinity of the impellers, respectively) were scaled-down to bench-scale bioreactors. It was found that at 400 RPM applied in prolonged glucose-limited chemostat cultures, the previously reported degeneration of penicillin production using an industrial Penicillium chrysogenum strain was virtually absent. To investigate this, the cellular response was studied at flux (stoichiometry), residual glucose, intracellular metabolite and transcript levels. At 600 RPM, 20% more cell lysis was observed and the increased degeneration of penicillin production was accompanied by a 22% larger ATP gap and an unexpected 20-fold decrease in the residual glucose concentration (C ). At the same time, the biomass specific glucose consumption rate (q ) did not change but the intracellular glucose concentration was about sixfold higher, which indicates a change to a higher affinity glucose transporter at 600 RPM. In addition, power input differences cause differences in the diffusion rates of glucose and the calculated Batchelor diffusion length scale suggests the presence of a glucose diffusion layer at the glucose transporting parts of the hyphae, which was further substantiated by a simple proposed glucose diffusion-uptake model. By analysis of calculated mass action ratios (MARs) and energy consumption, it indicated that at 600 RPM glucose sensing and signal transduction in response to the low C appear to trigger a gluconeogenic type of metabolic flux rearrangement, a futile cycle through the pentose phosphate pathway (PPP) and a declining redox state of the cytosol. In support of the change in glucose transport and degeneration of penicillin production at 600 RPM, the transcript levels of the putative high-affinity glucose/hexose transporter genes Pc12g02880 and Pc06g01340 increased 3.5- and 3.3-fold, respectively, and those of the pcbC gene encoding isopenicillin N-synthetase (IPNS) were more than twofold lower in the time range of 100-200 hr of the chemostat cultures. Summarizing, changes at power input have unexpected effects on degeneration and glucose transport, and result in significant metabolic rearrangements. These findings are relevant for the industrial production of penicillin, and other fermentations with filamentous microorganisms.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1002/bit.26447 | DOI Listing |
Inorg Chem
December 2024
School of Mineral Processing and Bioengineering, Central South University, Changsha 410083, Hunan, China.
The preparation of high-performance electrode materials from metallurgical solid waste is an effective strategy to address current energy and environmental challenges. This study utilizes a mixed acid leaching and ultrasound-assisted precipitation process to extract valuable metallic iron from titanium-extraction tailings (TET) to produce high-purity nano-FePO electrode material precursors with unique crystal structures. A leaching efficiency of 95.
View Article and Find Full Text PDFBioprocess Biosyst Eng
November 2024
School of Biological Sciences, Universiti Sains Malaysia, 11800 USM, Pulau Pinang, Malaysia.
The study focused on rhamnolipid production by batch fermentation of Pseudomonas aeruginosa USM-AR2 in a 3-L stirred-tank reactor (STR) using palm sludge oil (PSO) as the sole carbon source. The impact of various agitation rates towards the dispersion of PSO in the medium was evaluated to improve biomass growth and rhamnolipid production. A mechanical foam collection and recycling system was designed and retrofitted to the STR to overcome severe foam formation during fermentation.
View Article and Find Full Text PDFMaterials (Basel)
October 2024
Department of Metallurgical Engineering, UPTC, Tunja 47215, Colombia.
Heavy crude oil processing presents significant challenges owing to its complex composition and requirement for processing conditions, which increase the process safety risk in crude processing units, such as fixed equipment, for instance pressure vessels and pipes. The aim of this work is to evaluate the influence of heavy crude oils named A and B and the effect of sulfur-rich compounds and organic acids on the performance at high temperatures of three metallic alloys (5Cr-1/2Mo/ASTM A335GP5, X6CrNiMoTi17122/AISI-SAE 316Ti and Ni66.5Cu31.
View Article and Find Full Text PDFFoods
October 2024
Characterization and Interventions for Foodborne Pathogens Research Unit, Eastern Regional Research Center, Agricultural Research Service, United States Department of Agriculture, 600 East Mermaid Lane, Wyndmoor, PA 19038, USA.
During conventional pasteurization, eggs are submerged for 60 min at 56.7 °C, a lengthy and costly process that affects egg quality. Radio frequency (RF), a means to pasteurize eggs without affecting quality, is a novel option based on fast volumetric heating; however, there is scarce information about the quality of such treated food.
View Article and Find Full Text PDFJ Vis Exp
October 2024
Faculty of Dentistry Department of Endodontics, Marmara University.
This study aimed to evaluate surface defects of Remover rotary Nickel-Titanium (NiTi) files after single and multiple uses in conventional endodontic retreatment procedures using scanning electron microscopy (SEM). Eighty acrylic blocks, simulating root canals with a 1.5 mm internal diameter, a 5 mm radius of curvature, and a 55° curvature, were utilized.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!