Chromium (Cr(VI)) is a very toxic and carcinogenic element, which is widely present in groundwaters, mainly due to geogenic conditions. The limit of Cr(VI) in drinking water is expected to be reduced to 10 μg/L in both the USA and the European Union. Recent literature findings indicated that the most efficient process in reducing Cr(VI) levels to below 10 μg/L proved to be Cr(VI) reduction by Fe(II), by applying a molar ratio Fe(II)/Cr(VI) of around 9. In the present work, we investigated the reduction of Cr(VI) by Fe(II) in pipe flocculation reactors followed by filtration of insoluble products by microfiltration. The proposed technology involves re-circulation of a part of the sludge in the pipe reactors, in order to improve kinetics and efficiency of the process. The obtained results showed that with a Fe(II) dose of around 1 mg/L, Cr(VI) was reduced to below 10 μg/L, by even an initial concentration as high as 300 μg/L of Cr(VI), corresponding to a molar ratio Fe(II)/Cr(VI) of around 3, thus reducing the overall quantity of reductive reagents and of the produced sludge. This ratio was also confirmed by the XPS analysis, which also showed that Cr(VI) was reduced to Cr(III) and then precipitated either as Cr(OH) or associated with the produced iron oxides.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1007/s11356-017-9967-4 | DOI Listing |
BMC Chem
January 2025
Chemistry Department, Faculty of Science, Alexandria University, Alexandria, Egypt.
Surfactant-modified biochar is a viable adsorbent for eliminating Cr(VI) from synthetic wastewater. The biochar obtained from the zea mays plant (BC) was tailored with sodium dodecyl sulfate (SDS) as an anionic surfactant forming SDS-BC adsorbent. Different controlling conditions have been evaluated including pH of the solution, biomass concentration, primary Cr(VI) concentration, time of adsorption, and temperature.
View Article and Find Full Text PDFJ Colloid Interface Sci
January 2025
Faculty of Science, Kunming University of Science and Technology, Kunming 650500, China.
The fabrication of dual-quantum dot heterostructures offers a promising strategy to enhance the environmental remediation performance of photocatalysts. Herein, a BiWO-based Z-scheme heterojunction was constructed by incorporating carbonized polymer dots (CPDs) and CdS quantum dots (QDs) via a microwave-assisted solvothermal method. The 1 wt% CPDs/CdS QDs/BiWO (CCBW-1) composite achieved optimal Cr(VI) removal, reaching 97.
View Article and Find Full Text PDFSci Rep
January 2025
Department of Physics, Faculty of Science, Islamic University of Madinah, Al-Jamia, Madinah, 42351, Saudi Arabia.
This study focuses on the synthesis of a novel Cerium-Magnesium (CeO-MgO) binary oxide nanomaterials by a simple co-precipitation process and used to remove harmful pollutants such as Cr(VI), Cu(II), and F. The morphology, phase, crystallite size, thermal stability, functional groups, surface area, and porosity of the synthesized nanomaterial were determined by using XRD, SEM, FTIR, TGA/DTA, and BET studies. The prepared nanomaterials showed adsorption selectivity of Cu(II) ≈ F> Cr(VI) with a high adsorption capacity of 84.
View Article and Find Full Text PDFJ Hazard Mater
January 2025
CAS Key Laboratory of Urban Pollutant Conversion, Department of Environmental Science and Engineering, University of Science and Technology of China, Hefei 230026, China.
The introduction of structural defects can improve the charge separation efficiency of metal-organic frameworks (MOFs)-based photocatalysts, which however come with suboptimal decontamination performance, due to steric hindrance and limited binding capacity of the involved modulators. In this work, hydroxyl group capturing the advantages of both worlds was utilized as new modulator to improve the photocatalytic performance of Fe-based defective MOFs. Benefited from its low steric effect and strong coordination bonding capability, hydroxyl-induced defects in Fe-MOF contributed to a nearly 8-fold increase of rate constant for the photocatalytic removal of hexavalent chromium (Cr(VI)) compared to that of pristine one, which also exceeded the defective one induced by acetic acid as modulator.
View Article and Find Full Text PDFWorld J Microbiol Biotechnol
January 2025
Engineering Research Centre for Waste Oil Recovery Technology and Equipment, Ministry Education, Chongqing Technology and Business University, Chongqing, 400067, China.
In recent years, it has become widely acknowledged that heavy metals are often present in oil-contaminated sites. This study utilized three specific types of microorganisms with different functions to construct a composite bacterial consortium for treating lubricant-Cr(VI) composite pollutants. The selected strains were Lysinbacillus fusiformis and Bacillus tropicus.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!