Biodiesels derived from the mahua seeds are established as a promising alternative for the diesel fuel owing to its non-edible nature and improved properties. TiO nanoparticle in powder form is added to neat mahua oil biodiesel (BD100) to examine its effect on emission characteristics. TiO nanoparticle is chosen as an additive owing to its catalytic effect, higher surface energy, and larger surface to volume ratio. TiO nanoparticle with an average size of 60 nm was synthesized by sol-gel route. TiO nanoparticles are added with mahua biodiesel (BD100) at 100 and 200 ppm. Mahua oil biodiesel doped with 100 and 200 ppm of TiO nanoparticles are referred as BD100T100 and BD100T200. A constant speed diesel engine is employed for the experimental trail. Engine is fueled with diesel, BD100, BD100T100, and BD100T200, respectively. Experimental result confirmed that the modified fuels (BD100T200 and BD100T100) showed a significant reduction in all the emissions. Further, the addition of TiO nanoparticle (200 ppm) to mahua biodiesel gave respective reduction of 9.3, 5.8, 6.6, and 2.7% in carbon monoxide, hydrocarbon, nitrogen oxide, and smoke emissions when compared to neat mahua biodiesel.

Download full-text PDF

Source
http://dx.doi.org/10.1007/s11356-017-9973-6DOI Listing

Publication Analysis

Top Keywords

tio nanoparticle
16
mahua biodiesel
12
diesel engine
8
neat mahua
8
mahua oil
8
oil biodiesel
8
biodiesel bd100
8
tio nanoparticles
8
100 200 ppm
8
200 ppm mahua
8

Similar Publications

Overcoming the challenges of integrating disparate components in nanoarchitectures, this study introduces a straightforward strategy based on a mixed-valence coordination approach, creating an ordered ternary heterostructure integrated with ultrasmall homojunction. This singular ordered homojunction-heterostructure unites ultrathin 1D rutile TiO nanowires (NWs) and ultrathin anatase TiO NWs with 0D Prussian Blue Analogs (PBAs) nanoparticles (NPs), all exhibiting crystallographic oriented alignment with each other, forming a ternary mesocrystals. Experimental and theoretical insights disclose that the complex interplay between these dissimilar components is governed by a spontaneous lattice match effect, which not only optimizes but also directs the charge transfer, thereby enhancing both efficiency and stability.

View Article and Find Full Text PDF

This research highlights the different behaviors of titanium (Ti) wires under the action of 500 W and 800 W microwave power levels. Following the interaction between microwaves and a titanium wire placed in the node of the (TM-transverse magnetic mode) waveguide in air at atmospheric pressure, plasma was generated. Using optical emission spectroscopy technique it was observed that during plasma generation at 500 W and 800 W microwaves powers, metallic ions, and gas ions were created, and the plasmas fulfilled the local thermodynamic equilibrium (LTE) conditions.

View Article and Find Full Text PDF

The present research is a comprehensive study that developed poly(lactic acid) PLA/natural wax (Wx)/non-functionalized titanium dioxide nanoparticles (TiO-NF) and PLA/Wx/titanium dioxide nanoparticles functionalized with triethoxysilane (TiO-F) composites by melt blending. This research systematically investigated their hydrolytic degradation, antibacterial properties, oxygen permeability, and optical transparency. The TiO-NF or TiO-F (0.

View Article and Find Full Text PDF

Effect of Various Nanofillers on Piezoelectric Nanogenerator Performance of P(VDF-TrFE) Nanocomposite Thin Film.

Nanomaterials (Basel)

March 2025

Department of Chemical and Biochemical Engineering, Dongguk University, 30 Pildong-ro 1-gil, Jung-gu, Seoul 04620, Republic of Korea.

Flexible polymer-based piezoelectric nanogenerators (PENGs) have gained significant interest due to their ability to deliver clean and sustainable energy for self-powered electronics and wearable devices. Recently, the incorporation of fillers into the ferroelectric polymer matrix has been used to improve the relatively low piezoelectric properties of polymer-based PENGs. In this study, we investigated the effect of various nanofillers such as titania (TiO), zinc oxide (ZnO), reduced graphene oxide (rGO), and lead zirconate titanate (PZT) on the PENG performance of the nanocomposite thin films containing the nanofillers in poly(vinylidene fluoride-co-trifluoro ethylene) (P(VDF-TrFE)) matrix.

View Article and Find Full Text PDF

Using sunlight as the driving force for photocatalytic processes holds great promise for sustainability. As a starting point for developing a material capable of degrading aquatic pollutants using solar energy as a stimulus, this work focuses on synthesizing Au-TiO nanocomposites using the deposition-precipitation method. Characterization of Au-TiO nanoparticles was performed by X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR), and Transmission Electron Microscopy (TEM).

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!