A laser diode's junction voltage is a sensitive measure of its temperature and can be used in a thermal control feedback loop. To compensate for the temperature dependence of the laser's internal resistance, we have measured the dynamic resistance, ∂V/∂I, by modulating the injection current and measuring the demodulated voltage. The junction voltage was thus controlled while operating at fixed DC injection current. Over an external temperature range of 15°C to 35°C, this stabilised the centre frequency (wavelength) of a 1651 nm DFB laser diode with a residual mean frequency shift of 60 MHz (0.5pm), less than the uncertainty on the centre frequency of 80 MHz (0.7 pm). Under the same conditions, conventional thermistor control gave a systematic wavelength shift of -8.4 GHz (-76 pm), and control of the uncompensated forward voltage gave a shift of 9.9 GHz (90 pm).
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1364/OE.25.011679 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
We demonstrate a compact ring-assisted Mach-Zehnder interferometer (RAMZI)-based silicon photonic interleaver with a 400 GHz free spectral range (FSR), featuring flat passbands exceeding a spectral range of 50 nm. Additionally, we introduce a novel, to the best of our knowledge, add-on structure and tuning method enabling automated compensation for fabrication imperfections, precise shaping of the RAMZI flat-top passbands, and alignment with Kerr comb lines. Experimental results have shown successful interleaving of eight channels of distributed-feedback (DFB) lasers as well as a 200 GHz Kerr comb, both achieving an extinction ratio of approximately 20 dB.
View Article and Find Full Text PDFThis study proposes and experimentally demonstrates a distributed feedback (DFB) laser with a distributed phase shift (DPS) region at the center of the DFB cavity. By modeling the field intensity distribution in the cavity and the output spectrum, the DPS region length and phase shift values have been optimized. Experimental comparisons with lasers using traditional π-phase shifts confirm that DFB lasers with optimized DPS lengths and larger phase shifts (up to 15π) achieve stable single longitudinal mode operation over a broader current range, with lower threshold current, higher power slope efficiency, and a higher side mode suppression ratio (SMSR).
View Article and Find Full Text PDFAn ML-Enhanced Laser-Based Methane Slip Sensor Using Wavelength Modulation Spectroscopy.
ACS Sens
January 2025
Department of Mechanical Engineering, University of British Columbia, 2054-6250 Applied Science Lane, Vancouver, British Columbia V6T 1Z4, Canada.
Natural gas (NG) is a promising alternative to diesel for sustainable transport, potentially reducing GHG and air quality emissions significantly. However, the GHG benefits hinge on managing methane slip, the unburned methane in the exhaust of NG engines, which carries a significant global warming potential. The CH slip from NG engines is highly dependent on engine type and operation, and effective greenhouse gas emission mitigation requires that the actual operation of real-world engines is monitored.
View Article and Find Full Text PDFWe experimentally demonstrate a cost-effective dual-polarization quadrature phase shift keying (DP-QPSK) coherent passive optical network (PON) system that operates at 100 Gbits/s/λ. This system utilizes distributed feedback lasers (DFBs) and a carrier recovery algorithm facilitated by a bifunctional frequency-domain pilot tone (FPT). To reduce costs in coherent PON implementations, low-cost DFBs are employed as the sole light sources, replacing the more expensive external cavity lasers (ECLs) at both the optical line terminal (OLT) and the optical network units (ONUs).
View Article and Find Full Text PDFCompact and full-range carbon dioxide sensor using photoacoustic and resonance dependent modes.
Photoacoustics
February 2025
Dipartimento di Scienze di Base ed Applicate per l'Ingegneria, Sapienza Università di Roma, Rome 00161, Italy.
A compact and robust optical excitation photoacoustic sensor with a self-integrated laser module excitation and an optimized differential resonator was developed to achieve high sensitivity and full linear range detection of carbon dioxide (CO) based on dual modes of wavelength modulated photoacoustic spectroscopy (WMPAS) and resonant frequency tracking (RFT). The integrated laser module equipped with three lasers (a quantum cascade laser (QCL), a distributed feedback laser (DFB) and a He-Ne laser) working in a time-division multiplexing mode was used as an integrated set of spectroscopic sources for detection of the designated concentration levels of CO. With the absorption photoacoustic mode, the WMPAS detection with the QCL and DFB sources was capable of CO detection at concentrations below 20 %, yielding a noise equivalent concentration (NEC) as low as 240 ppt and a normalized noise equivalent absorption coefficient (NNEA) of 4.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!